Investigation of BaTiO$_3$-NiO composite as compact Dielectric Resonator Antenna
Abstract
A compact dielectric resonator antenna has been fabricated on a microstrip transmission line for the purpose of C-band wireless communication using a ceramic material made out of a sintered mixture of BTO and NiO. The antenna parameters are optimized using Ansys HFSS software and verified experimentally. Ni replaces both Ba at A site and Ti at B site. Such a solid solution has a limit depending on the amount of NiO provided during sintering. A complete study of the structural changes and the dielectric constant enables the correlation with the resonating property. All the samples retain the ferroelectric tetragonal P4mm phase with a nominal decrease in the c/a ratio. NiO incorporation in BTO decreases the sintering temperature and shows two types of morphology associated with BTO-like and NiO-like phases. It induces prominent reduction in the permittivity and loss tangent (<0.01) in the range 100Hz to 1MHz. These properties make these samples suitable for DRA application in the C-Band range [4-8 GHz]. Experimental and theoretical assessment using HFSS software yields a C-band signal at ~7.27 GHz.
- Publication:
-
arXiv e-prints
- Pub Date:
- May 2024
- DOI:
- 10.48550/arXiv.2405.08910
- arXiv:
- arXiv:2405.08910
- Bibcode:
- 2024arXiv240508910G
- Keywords:
-
- Physics - Applied Physics;
- Condensed Matter - Materials Science
- E-Print:
- The previous draft is written in the perspective of a DRA application of the synthesized material. This updated version is presented from the perspective of a novel measurement technique of the dielectric constant of those materials in GHz range using the same DRA setup