Location via proxy:   [ UP ]  
[Report a bug]   [Manage cookies]                
Scribd
Upload
62 views

Design and Fabrication of Variable Power Supply For 12V/1A Aim

The document outlines the design and fabrication of a variable power supply that outputs 12V/1A. It lists the required apparatus including a PCB circuit board, transformer, diodes, capacitors, resistors, variable resistor, regulator IC, LED, heat sink, display unit, and other components. The power supply uses an LM317 regulator IC and has components like a transformer, diode bridge, and capacitors to convert mains AC to a variable DC output voltage and current.

Uploaded by

shiva shakthy
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
62 views

Design and Fabrication of Variable Power Supply For 12V/1A Aim

The document outlines the design and fabrication of a variable power supply that outputs 12V/1A. It lists the required apparatus including a PCB circuit board, transformer, diodes, capacitors, resistors, variable resistor, regulator IC, LED, heat sink, display unit, and other components. The power supply uses an LM317 regulator IC and has components like a transformer, diode bridge, and capacitors to convert mains AC to a variable DC output voltage and current.

Uploaded by

shiva shakthy
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

DESIGN AND FABRICATION OF VARIABLE POWER SUPPLY FOR 12V/1A AIM: To design and fabricate the variable power

supply for 12V/1A. APPARATUS REQUIRED: S.NO 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 APPARATUS PCB circuit board Transformer Diode Electrolyte capacitor Ceramic capacitor Resistor Variable resistor Regulator IC LED Heat sink Display unit Soldering kit Wire cutter Knobs Power chord RANGE 230/15V 1N4007 1000f/25V 0.1f 1k,330 2k LM317 QUANTITY 1 1 4 1 1 Each 1 1 1 1 1 1 1 1 1 1

Introduction: Construct a variable

You might also like