Location via proxy:   [ UP ]  
[Report a bug]   [Manage cookies]                
Scribd
Upload
34 views

Objectives: Cutting Cable Using Crimper

This document provides procedures for preparing and testing network cables and configuring a basic network. It involves: 1) Preparing straight and crossover Ethernet cables using a crimper and cutting cables to different lengths. 2) Connecting the cables to RJ45 sockets and testing them using a cable tester. 3) Connecting computers to a switch using the prepared cables and configuring the TCP/IP settings. 4) Testing the network connection by opening an internet browser.

Uploaded by

Wani Syazwani
Copyright
© © All Rights Reserved
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
34 views

Objectives: Cutting Cable Using Crimper

This document provides procedures for preparing and testing network cables and configuring a basic network. It involves: 1) Preparing straight and crossover Ethernet cables using a crimper and cutting cables to different lengths. 2) Connecting the cables to RJ45 sockets and testing them using a cable tester. 3) Connecting computers to a switch using the prepared cables and configuring the TCP/IP settings. 4) Testing the network connection by opening an internet browser.

Uploaded by

Wani Syazwani
Copyright
© © All Rights Reserved
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 5

LAB 1 : Cables preparation and interconnecting LAN OBJECTIVES a.

Preparing two types of networks cables which is straight and crossover. b. Interconnecting network e !ip"ents. EQUIPMENTS a. Cri"per b. Cable tester c. #$P cable d. %&'( socket PROCEDURES a. )irst of all* we have to prepare for two cables that are straight and crossover cables. b. By !sing cri"per* c!t the cable to divide the cable into two as shown in pict!re below. )or crossover cable "ake it a bit shorter than the straight cable so that can be recogni+e easily.

Cutting cable using crimper

c. Based on the cable arrange"ents fig!re below* arrange the two cables. %e"e"ber to do it on the both sides of the cables.

Straight cable

Crossover cable

d. After the arrange"ents are done* p!t it in the %&'( socket. )ig!re below is the pict!re of %&'( socket.

RJ45

e. $o "ake s!re that the arrange"ents are correct we will test the" !sing cables tester. By connecting the cable to tester* observe if the light is on or not. If the light is on "eans that the cable can be !se.

Testing the cable

LAB , : Network Config!ration and $esting

OBJECTIVES a. Config!ring networks. b. $esting network connections.

EQUIPMENTS a. Co"p!ters b. -witch./!b

PROCEDURES

1. By !sing cables that yo! had prepared before in Lab 1* connect all the co"p!ters to the switch or h!b. 0o! can !se any port between I1,' b!t do not connect the co"p!ter to the !plink port. -ee fig!re c. ,. -tart with fig!re c2i3 and then fig!re c2ii3.

c(i)

c(ii)

4. $hen* config!re network by open control panel 5 Network connections. '. -elect yo!r connection* click Properties.
5. -elect $CP.IP Protocol and click Properties.

6. )ro" here* yo! can edit yo!r config!ration setting "an!ally. 7. $esting the connection by opening any internet browser.

You might also like