Location via proxy:   [ UP ]  
[Report a bug]   [Manage cookies]                
Scribd
Upload
386 views

Eclipse Reference Manual

eclipse

Uploaded by

André Mattos
Copyright
© © All Rights Reserved
Available Formats
Download as PDF or read online on Scribd
386 views

Eclipse Reference Manual

eclipse

Uploaded by

André Mattos
Copyright
© © All Rights Reserved
Available Formats
Download as PDF or read online on Scribd
You are on page 1/ 3
ECLIPSE Reference Manual COMPVE [CLIPS 00] “ECLIPSE SPECIAL RUNSPEC PROFS x [ Seno Well connection depth data COMPS is used to reset the top and bottom depths of well connections, to allow for partial penetration within a grid block when calculating the phase relative permeabilities at the connection. The skin factor ean also be adjusted to allow for partial penetration, In runs using the vertical equilibrium option (keyword V in the RUNSPEC section), the relative permeabilitcs at a well connection depend upon the connection's top and bottom depths and the fluid contact depths. Unless modified with the COMPVE keyword, the top and bottom depths of each connection are set to the depths of the center of the top and bottom faces of the connecting grid block, giving full penetration of the grid block. {Ifthe CoMPVE keyword is entered when the vertical equilibrium option is not in use, the top and bottom depths are automatically converted into scald saturation table endpoints, which are then treated as if they had boon entered withthe Co:

You might also like