DPP Nlm-I
DPP Nlm-I
1
DPP 1
1.
2.
6N
2 kg 1 kg
3N
(d) 5N
In the given figure, all the strings are ideal. The ratio of
tension T4 and T3 is
(a) 1 : 1
(b) 1 : 3
(c) 3 : 1
(d) 2 : 1
60 T5
T4
T2
30
T3
T1
10 kg
3.
A block of weight 9.8 N is placed on a table. The table surface exerts an upward force of
10N on the block. Choose the correct alternative (Assume g = 9.8 m/s2)
(a) the block exerts a force of 10N on the table
(b) the block exerts a force of 19.8N on the table
(c) the block exerts a force of 9.8N on the table
(d) the block has downward acceleration.
4.
5.
(a) Mg tan
2
Mg cos
(c)
1 sin
6.
(d) 12 m/s2
(b) Mg cot
2
7.
A flexible chain of weight 10 N hangs between two fixed points A and B which are at the
same horizontal level. The inclination of the chain with the horizontal at both the points of
support is 45. Find the tension (in N) of the chain at the mid point.
8.
K
A
B
K
C
3
DPP 2
1.
2.
3.
45
45
A
B
B
A
4.
A man of mass m slides down along a rope which is connected to the ceiling of an elevator
retarding with acceleration a relative to the rope. If elevator is going upwards with an
acceleration a relative to the ground then tension in the rope is
(a) mg
(b) m (g + 2a)
(c) m (g + a)
(d) m (g + 3a)
5.
A 10 kg object is to be lowered down from a height using a cord with breaking strength of
80N. The object should be
(a) lowered very slowly
(b) lowered with an acceleration less than 2 m/s2
(c) lowered with an acceleration greater than 2 m/s2
(d) object cannot be lowered down without breaking the cord.
6.
30
7.
8.
9.
50m
F2
F1
B
A
Two men A and B of equal mass are holding the free ends of a massless rope which passes
over a frictionless light pulley. Man A climbs up the rope with acceleration 10 m/s2 relative
to the rope while man B hangs on without climbing. Find the acceleration (in m/s2) of the
man B with respect to ground.
5
DPP 3
1.
2.
3r
r
a
m
4.
5.
6.
1
A
v2
10kg
37
v1
9 m/s2
3.
10m
30kg
7.
8.
9.
F
A
x
y
S
A
B
37
Starting from rest, the cable is wound onto the drum of the motor at a rate of
vA = (24t2)m/s, where t in seconds. Determine the time (in s) needed to lift the load by a
distance of 27m.
7
DPP 4
1.
2.
18 kg
(b)
3 3
g
(c)
3 2
3.
60 60
B
2 3
g
(d)
3
Two containers of sand S and H are arranged in figure I. The containers alone have
negligible mass. The sand in them has a total mass Mtot. The sand in the hanging container
H has mass m. The magnitude a of the acceleration of the system in a series of experiments
is to be measured where m varies from experiment to experiment but Mtot does not, that is
m
is taken on the x-axis for
sand is to be shifted between the containers before each trial.
M tot
all the plots and acceleration and tension in the string are taken on the y-axis.
The plot which gives the variation of acceleration magnitude of the containers (taken on yaxis) is
y
y
y
y
(a) 0
m
M tot
1.0 (b) 0
m
M tot
1.0 (c) 0
m
M tot
1.0 (d) 0
m
M tot
1.0
4.
In the above problem, the plot which gives variation of tension in the connecting string
(taken on y-axis) is
y
y
y
y
(a) 0
1.0 (b) 0
M tot
5.
(a) 0
1.0 (c) 0
M tot
m
M tot
7.
1.0 (d) 0
M tot
1.0
M tot
In the above problem, if net force on container H is taken on the y-axis, the plot which gives
the variation of magnitude of net force, on container H is
6.
1.0 (b) 0
1.0 (c) 0
M tot
1.0 (d) 0
M tot
Case (i)
1.0
M tot
A B
Case (ii)
8.
In the given figure, find the velocity (in cm/s) and acceleration (in m/s2) of B, if velocity and
acceleration of A are as shown.