Location via proxy:   [ UP ]  
[Report a bug]   [Manage cookies]                

CAPE June 2008chemistry RestofRegionSR

Download as pdf or txt
Download as pdf or txt
You are on page 1of 9

CARI BB E AN

E XA MINA TIONS

C OUN CIL

REPORT ON CANDIDATES WORK IN THE


CARIBBEAN ADVANCED PROFICIENCY EXAMINATION
MAY/JUNE 2008

CHEMISTRY
(REGION EXCLUDING TRINIDAD AND TOBAGO)

Copyright 2008 Caribbean Examinations Council


St Michael Barbados
All rights reserved

CHEMISTRY
CARIBBEAN ADVANCED PROFICIENCY EXAMINATION
MAY/JUNE 2008
THE STRUCTURE OF THE EXAMINATION

A revised CAPE Chemistry syllabus was assessed for the first time for Unit 2 in 2008, and for the
second time for Unit 1. The revision included a reorganization of the Modules of the Units, as
follows:
Unit 1
Module 1: Fundamentals in Chemistry
Module 2: Kinetics and Equilibria (previously in Unit 2)
Module 3: Chemistry of the Elements (previously in Unit 2)
Unit 2
Module 1: The Chemistry of Carbon Compounds (previously in Unit 1)
Module 2: Analytical Methods and Separation Techniques (previously in Unit 1)
Module 3: Industry and the Environment
The examination for each Unit consisted of two external papers. Paper 01 consisted of 45 Multiple
Choice items, 15 from each Module. Paper 02 consisted of six compulsory questions, two from each
Module.
The Internal Assessment, Paper 03, involved the continuous assessment of candidates by teachers
over the duration of the Unit. Candidates were required to conduct at least 16 laboratory practical
exercises. These were assessed by the teachers and comprised the Paper 03 marks for the candidates.
Samples of candidates laboratory books were externally moderated by CXC, and formed the basis of
the moderation of all Internal Assessment marks submitted by the teachers.
The contribution of each paper to the overall examination was as follows:
Paper 01
Paper 02
Paper 03

40 %
40 %
20 %

GENERAL COMMENTS
One thousand, seven hundred and two candidates registered for the examination in Unit 1, and 1176
candidates registered for Unit 2.

Unit 1
Overall, candidate performance was satisfactory. Approximately twenty-two per cent (22%) of the
candidates achieved Grade I and more that 80 per cent achieved acceptable grades, Grades I-V.

Unit 2
Approximately twelve per cent (12%) of the candidates achieved Grade I, while almost ninety per
cent (90%) achieved Grades I-V. This performance is satisfactory, considering that Organic
Chemistry (Module 1) and Analytical Methods (Module 2) have been examined for the first time in
this Unit.

DETAILED COMMENTS
Paper 01 Multiple Choice

This paper comprised 15 items from Module 1, 15 from Module 2, and 15 from Module 3. The mean
on Unit 1 Paper 01 was 56 per cent and 49 per cent on Unit 2 Paper 01. For Unit 1, candidates
experienced difficulties with the following:

Polarizing power of elements (Module 1)


Feasibility of redox reactions given cell diagrams (Module 2)
Trend in bonding re NaCl, AlCl3, SiCl4, PCl5 (Module 3)

For Unit 2, candidates experienced difficulties with the following:

Volatility of organic compounds (Module 1)


Calculating the concentration of a solution given an absorbance graph (Module 2)
Fragmentation pattern of CH2Cl2 (Module 2)

UNIT 1
Paper 02 Structured Essay
Question 1
Specific Objectives: 4.1 - 4.3
This question sought to test candidates understanding of the concept of oxidation/reduction,
oxidation number as illustrated in redox reactions and the writing of relevant equations. Candidate
performance was modest, giving the distinct impression of superficial comprehension of the above
concepts.
There was some confusion surrounding the correct oxidation number change of the two processes.
Particular areas of weaknesses were:
The balancing of redox equations
The correct use of chemical terminology. Consistent reference to clear solution instead of
colourless solution; insoluble solution, dirty solution, are clear indicators of the confusion
between precipitate and solution.

Question 2
Specific Objective: 6.3 6.5
Candidates were required to demonstrate their understanding of the principles involving
electrochemical cells and electrode potentials.
Overall candidate performance was rather modest. However, there were some instances when
candidates demonstrated a good grasp of the contents presented by the question.
The majority of candidates were able to draw the cell diagram requested in Part (a). However, the
identification of the correct electrode reactions with the corresponding E values and the products of
changes required in Part (f) presented quite a challenge.
Question 3
Specific Objectives: 6.1; 6.2; 6.5
This question focused on the chemistry of a number of elements listed in Module 3 of this Unit.
Candidates found this question to be difficult, producing a rather poor overall performance. The only
section answered with any degree of competence was Part (a), involving the testing for Al3+ and Pb2+
using alkalis.
The perennial challenge of writing ionic equations and the uncertainty surrounding what constitutes
observations and inferences were again quite evident. The best interpretation to be placed on
candidates writing of incorrect formulae was one of carelessness (H2So4 for sulphuric acid). It would
be quite disappointing to suggest that at this level this presented a basic problem.
Question 4
Specific Objectives: 3.7 3.9
This question tested candidates on their knowledge of empirical and molecular formulae and relevant
calculations, as well as the practical and mathematical applications of titrimetric analysis.
The majority of candidates were able to calculate the empirical and molecular formulae of caproic
acid (Part (a) (ii)).
Candidate weaknesses encountered included:
Explanations in distinguishing between empirical and molecular formulae (Part (a)(i)). A
significant number of candidates used atom and molecule interchangeably in their
attempt to answer this part of the question.
The lack of appreciation of the fact that the molecular formula describes the ratio of each
atom in the compound. Some examples used were inappropriate, for example, C2H4, C2H8.
The calculation of molar concentration. Candidates were often guilty of relying on the use of
the formula M1V1 = M2V2 with its subsequent misuse.
Question 5
Specific Objectives: 2.6; 5.1; 5.2; 5.5
This question focused on the applications and calculations surrounding the concepts of equilibrium
and solubility product.

Candidate performance was rather inconsistent with a significant number demonstrating difficulty.
The notion of equilibrium, explanations and application of the concept of solubility product presented
a challenge for most candidates. However, most candidates were able to define Le Chateliers
Principle (Part (d)), wrote the correct expression for Kc (Part (a) (i)) and deduced the value of Ksp
(Part (b) (i)).
Question 6
Specific Objective: 4.1; 4.2; 4.5; 1.1
Candidates were tested on their knowledge of the chemistry of the Group VII elements and the
variation of ionisation energy across Period 3 of elements in the periodic classification.
Candidates showed a general knowledge of the subject matter, and grades were satisfactory.
Candidates found the explanations required in areas represented in Parts (b) (ii), (c) (ii) and (c) (iii) to
be challenging.
The above clearly indicates that while candidates were comfortable with questions in the area of
knowledge and comprehension, there was a lack of competence in responding accurately to
questions in the area of use of knowledge.

UNIT 2
Paper 02 Structured Essay
Question 1
Specific Objectives: 2.4; 2.6 2.9
Candidates were required to demonstrate an understanding of the reactions of a number of functional
groups with their associated reaction mechanisms.
Candidates responses indicated a satisfactory grasp of the above concepts. The main deficiency was
shown in the responses to Part (b), which required the writing of the reaction mechanism for the
conversion of the tertiary bromoalkane to the corresponding alcohol. This deficiency resulted in the
incorrect use of arrows, both single and double headed, showing uncertainty in the use of these
symbols.
The failure to distinguish between the concepts of observation and deduction in Part (c) was again
seen.
More work needs to be done to assure the removal of these deficiencies.
Question 2
Specific Objectives: 8.1 8.4; 8.6
This question tested the candidates knowledge of chromatographic methods, in particular TLC and
GLC.
Candidates level of performance was somewhat inconsistent. The majority of candidates were
familiar with the use of chromatographic methods. They were able to give examples of, and
differentiate between, stationary and mobile phases, and to calculate Rf values.

Candidates main difficulty stemmed from an inability to adequately explain the function of the two
phases and hence to identify polarity as the property of the three compounds in Part (b) (ii).
Candidates also failed in their comparison of Rf values and hence found Parts (b) (iii) (a) and (c) (iii)
difficult.
Question 3
Specific Objectives: 8.2; 8.3; 8.5; 8.6
In this question, candidates were asked to show a knowledge of the position of water as a vital
compound in the environment; pollution sources and their detection; and purification methods in the
provision of potable water.
Candidate performance was disappointingly low and apart from Part (c) (i), the question proved to be
difficult.
Candidates showed a lack of knowledge of:
The test for the presence of Pb2+ and NO3
The concept of eutrophication
Thermal pollution of the aquatic environment as required in Part (d)
Question 4
Specific Objectives: 2.1; 2.4; 2.6; 2.11; 2.13; 2.17
This question focused on the areas of functional group analysis, their reactions and mechanisms.
Candidates showed modest performance in their responses. The pattern of responses in this question
mirrored those in the corresponding area as presented in Question 1.
Candidates again had difficulty in explaining the required mechanism and, additionally, found further
challenges in the identification of individual groups in the stated reactions.
Candidates, however, had little difficulty in the case of the free radical mechanism.
Question 5
Specific Objectives: 9.1; 9.8
Candidates were asked to respond to questions relating to their knowledge of fractional distillation as
a technique of separation.
Candidates were comfortable in answering Parts (c) and (e). However, there was some confusion in
distinguishing between principle and process with respect to fractional distillation, with
candidates describing the latter instead (Part (c)).
Many candidates also found the sketching of the boiling point/composition curve to be an area of
difficulty.
Generally, candidates only attained a modest mark on this question.

Question 6
Specific Objectives: 4.1; 4.2
This question tested the candidates knowledge of ammonia production via the Haber Process, and the
associated industrial applications.
Candidate performance was again of modest proportions. The majority of candidates were able to
write the equation for the Haber Process and to give examples of the use of ammonia, (Part (a) (i)).
Candidate difficulty centered around the lack of ability to apply Le Chateliers principle as required.
Thus, candidates were unable to adequately explain the behaviour of the equilibrium mixture (and
thus the equilibrium constant, Keq ) when the various factors were altered, Part (b).

Internal Assessment
While the general standard of this component of the examination has shown improvements over the
years, there are certain areas which continue to be constant. This is cause for concern.
Mark Schemes
These generally were acceptable and served as useful guides for the moderators. There were,
however, still quite a few cases where the mark schemes were either incomplete or contained
irrelevant skills. For example, a number of mark schemes in assessing Observation, Recording and
Reporting (ORR), awarded marks for Analysis and Interpretation (AI).
The construction of mark schemes for Planning and Design (PD) is still presenting great difficulty.
This can be traced in part to inappropriate PD assignments.
Mark schemes must be made more informative and moderator friendly by including the identity of
unknowns and the observations expected when qualitative analyses are assessed.
Syllabus Coverage; Adequacy and Standard of Activities
This part of the Internal Assessment was very well met and the number of activities was good. Care
should be taken to ensure an even spread of activities across topic boundaries. The practice of
assigning five volumetric or qualitative analyses, one energetics experiment and an absence of an
exercise on equilibrium should be avoided.
Efforts should continue to be made to upgrade the standard of activities so as to provide appropriate
challenges for students at this level of competence, especially in the areas of volumetric and
qualitative analyses.
Assessment of Skills
Generally each of the four skills was assessed at least twice. Some, however, were assessed in as
many as seventeen (17) practical assignments.
Although this is commendable, only two practical assignments should be chosen and indicated for the
assessment of a particular skill for moderation purposes.

Observation, Recording, Reporting (ORR)


This skill was satisfactorily assessed. This included the assessments of skills and concepts such as
communication and correct English grammar. It must be borne in mind, however, that only five (5)
marks of the twelve (12) are to be allotted for this purpose.
Candidates should be encouraged to improve their skills in the plotting and drawing of graphs, as well
as the inclusion of state symbols in the writing of equations.
Manipulation and Measurement (MM)
Though not moderated, evidence of this skill must be present and indicated in the samples to be
presented. Efforts should be made to assess the widest range of skills in this area.
Analysis and Interpretation (AI)
Activities testing this skill needed to be more challenging calculations should be multi-staged.
Deductions from observations/results should be relevant and made in a logical and sequential manner.
Analysis of graphs and discussions of results should be encouraged, and it should be borne in mind
that drawing of graphs is an activity related to ORR but not AI.
Planning and Design (PD)
The assigning and assessment of this skill continues to be the major concern of the whole Internal
Assessment component of the examination and in quite a number of cases are unmitigated disasters.
Acceptable activities for PD should pose a problem for candidates to solve, using concepts
contained in the syllabus. These problems should encourage hypothesis making, be
conceptualized in novel situations and should not be activities previously done or readily
available in text books.
It must be borne in mind that laboratory practical activities, which are written in the past tense,
have no stated hypothesis and are based on common investigations, cannot be accepted for
planning and design marks. It must be clear to the moderators that some planning and design
was done by the candidates.
Candidates should be instructed not to include actual results in their prediction of results. It is
recognized that in places where there is a large turnover of teachers, the need for implementation of
strategies in the area of training is vital to the elimination of the above deficiencies in the assessment
of this skill. Ministry and School Officials need to lend urgent attention to providing solutions to this
critical area.

CONCLUSION
The overall performance of candidates across the region has been satisfactory and the revised syllabus
has been effective in relating more closely with the developmental aspect of the candidates learning
processes.
Teachers however, should pay some attention to the:

Wider use of practical assignments in the teaching of the various topics for example,
oxidation/reduction, where candidates can be taught the difference between an observation
and the corresponding inference

Employment of strategies to enable candidates to understand and use the language of


chemistry appropriately in descriptive work

Writing of equations, both ionic and stoichiometric with the inclusion of state symbols

Recognition that candidates find certain topics more challenging than others, and, therefore,
seek out methods to facilitate comprehension of such; for example, electrochemistry and
various analytical techniques

Insistence that calculations based on the sequential deduction of number of moles contained
in a volume of solution be used instead of the parroting of the formula M1V1 = M2V2, which
generally leads to muddled thinking.

You might also like