B Srm-5a
B Srm-5a
B Srm-5a
R SR AD M -5 A
U L
U L
D C E
D D TE TE
BATTERY - INTERNAL (12V 7 AMP HOUR) BATTERY - EXTERNAL RECHARGEABLE BATTERY CHARGE - CHARGING VOLTAGE PRESENT OFF - ON - POWER TO 12V TERMINALS
Logan, Utah
MADE IN USA
WARNING:
CHARGE CHARGE +12V +12V
FROM CHARGER OR SOLAR PANEL 16-28VDC OR 18VAC RMS + TO EITHER TERMINAL, TO OTHER
PERMANENT DAMAGE TO RECHARGEABLE CELLS MAY RESULT IF DISCHARGED BELOW 10.5 VOLTS
LIFT TO REMOVE
5 3
6 L
7 4 H
8
EX1
POWER IN G 12V
P1 P2
13 14 7 H L
15 16 8 H L
CR1000
EX2 EX3
WIRING PANEL
RS-232 (Not Isolated)
Features
Asynchronous transmission of up to 9,600 bps Transmission range of up to 7.6 miles (12.2 kmsee Table 1 on back page) No ac power required Transformer isolated Compact, lightweight Easy to install
POWER OUT
SW-12 12V 12V 5V
COM1 COM2 Tx Rx Tx Rx
C4 C1 C2 C3 G G
COM3 COM4 Tx Rx Tx Rx
C5 C6 C7 C8 G
SN: SDM
MADE IN USA
PC-to-Datalogger Hookup
Logger Time 00:03:54 Flags Ports H=Help G = Graph enter/exit R = Re-scale + = Incr. auto exponent - = Decr. auto exponent
1
1000 1100 1200
V = View save to file F1. . F8 = Toggle flags P1. . P6 = Toggle ports C = Collect data
1: SOLAR 2: TEMP C 3: RH %
Scale = Auto
3 2
RAD
Surge Protector
100
200
300
400
500
600
700
800
900
1300
1400
1500
1600
1700
1800
1900
2000
2100
2200
2300
Environmental Enclosure
8 9
Datalogger
SC12 Cable
Interface
RAD
Surge Protector
PC running PC400 or LoggerNet Software. 7026 serial cable, which is a DB-25 male to DB-9 female. SRM-5A Short Haul modem, two required. Joslyn 4-wire surge protector model 6536 for use with PC. 4-wire unconditioned telephone line or the CABLE2TP-L Santoprene-jacketed, 2-twisted-pair cable with shield.
(6) 6361 Joslyn 4-wire surge protector for use in an enclosure. (7) SC932A DCE Interface2 and a 9-to-25 pin adapter. The 15770 Rad Modem Interface Kit includes the SC932A, adapter, and a mounting bracket. (8) SC12 cable (provided with SC932A). (9) Campbell Scientific datalogger
RAD is a registered trademark of RAD Data Communications, Inc. Rochelle Park, NJ. The SC932A is used to connect the modem to the dataloggers CS I/O port. Configuration is more complicated when connecting the modem to the dataloggers RS-232 port; contact Campbell Scientific for more information.
2
R C - V +
XM - T +
Specifications
Data Rates: Transmission Mode: Transmission Range: Line Interface: up to 9,600 bps Asynchronous, full duplex, 4-wire operation up to 7.6 miles (12.2 km); see Table 1 5-screw (4-wire and ground) connector block with cable strain relief inside plastic cover unconditioned, 4-wire telephone line; or CABLE2TP-L for short RS-232 or prewired systems) 6 dBm EIA RS-232-C/CCITT V.24, female integral 25-pin connector Protection:
Environment
Temperature: Altitude: Humidity: 0 to 60C (32 to 140F) up to 10,000 ft (3000 m) up to 95% non-condensing
Power Requirements
At Computer: uses low power from the EIA RS-232-C/CCITT V.24 data and control signals. combined current drain of the SC932A and RAD modem is 2.2 mA quiescent; 10 to 15 mA active. ac/dc over voltage connected via isolation transformers rated at 1,500 V RMS
Transmission Line:
At Datalogger:
Physical
Length: Width: Height: Weight: 2.1 in (5.2 cm) 2.1 in (5.2 cm) 0.7 in (1.8 cm) 1.3 oz (38 g)
Warranty/Repair
Application support and troubleshooting assistance for Campbell Scientific systems equipped with RAD modems are offered by Campbell Scientific. Repair and warranty service for RAD modems is extended by RAD Data Communications through their distributor, Pacific Data Com. If repair of a RAD modem becomes necessary, please call (213) 494-2121 for a returned merchandise authorization (RMA).
815 W 1800 N
|
(435) 753-2342
|
|
|
www.campbellsci.com
SOUTH AFRICA
|
AUSTRALIA
BRAZIL
CANADA
COSTA RICA
ENGLAND
FRANCE
GERMANY
SPAIN