El 1

5.0 elektro ABBG Figure 1 ACJL One of the main switching elements in the tnac has failed.
ARAJ 10-200 BGNJ between 0.1 and 1.0 ohm BNLE Figure 1 CIPJ To ensure that no energy remains in the system and that it cannot be recharged by external influences. CRQT Pressure to current converter. CSMC 30 volts CUFX 2.2 Ohms DBRX Vacuum DNNI Control of the process inlet side DTBG Figure B DWOF Capillary tube EKVD 22 Ohms ELPL Differentiator ESFO The input impedance is made much larger than the output impedance EUUQ Multi - meter FEYS A large bow thruster will draw very large currents at low voltage. Being typically remote from the generator, significant voltage drops would occur at low voltage. FKRP One Henry FTAX Protect the SCR against damage caused by fast high voltage spikes FXAI Ionization type GATR Differentiating GHLA AND HPMA 60 ohm HQPC Open arcurt winding between W and U ISPY Measurement of differential pressure JNMP Faulty contactor coil KKHF Return inductive current to supply at switch off. KQUB G - 1/R KVVL R1/R2 - R3/R4 LKYH In a pressure transmitter. LLXP 0.2 A LQRG - 100 M Ohms NGTS 40 kA NRXM U-E, V-E. W-E, U-V,V-W, W-U NVKP Une fuses and overcurrent relays NVMA Incorrect frequency OFXE Thermocouple sensor OKWA 6 ohms OSDY The primary controller m a cascade control system PBKR The slave controller receives the set-point from the output signal of the master controller PDRS Temperature, humidity and surface contamination PEBH Contactor chattering (vibrating) QDFE 5 and 6 RGBR Better linearity and increased accuracy RNOO Integrator RPHF The controller will not react to a process change in this range RSDC Reduced current and reduced torque RTXB 4.6V SFGF OR gate SHXA Install a 100 ohm resistor in series with the coil SWQI Figure 1 TCKG Disconnect the thermocouple lead from the controller and replace with a mV source. TEOA The amount of apparent power that coukl flow into any fault at any point in the electrical network. THJL The gas, liquid or vapour which will minimise creation of an electric arc as contacts open. TPDU Zero-pomt is accurate, but 100% input is not Qivino 100% output UDFB Bandpass filter UKRC Allowing stored energy in solenoid to dissipate as freewheel current and therefore prevent damage to transistor from inductive switching voltage. VTAU Solution of potassium hydroxide (KOH) and water VXJJ The secondary controller WGVI Rotten eggs. WJUT Apply reduced voltage to the element for a few minutes. Then retest and if ok put into service. WRW In the event of an earth fault vital equipment will not tnp WSOR It will allow for inrush current or motor specific faults WVMM Differential amplifier
XNFD Level control XRGG fo- 1 / (2"PiM sqrt (L/C)) XSES It is possible to predict the control mathematically YAPA Adjust the slave controller with the master controller in manual mode YWKI Electoc motors will run at reduced speed and will tend to overheat. YYMW Absolute pressure
ABBG Figure 1 ACJL One of the main switching elements in the tnac has failed. ARAJ 10-200 BGNJ between 0.1 and 1.0 ohm BNLE Figure 1 CIPJ To ensure that no energy remains in the system and that it cannot be recharged by external influences. CRQT Pressure to current converter CSMC 30 volts CUFX 2.2 Ohms DBRX Vacuum DNNI Control of the process inlet side DTBG Figure B DWOF Capillary tube EKVD 22 Ohms ELPL Differentiator ESFO The input impedance is made much larger than the output impedance EUUQ Multi - meter FEYS A large bow thruster will draw very large currents at low voltage. Being typically remote from the generator, significant voltage drops would occur at low voltage. FKRP One Henry FTAX Protect the SCR against damage caused by fast high voltage spikes FXAI Ionization type GATR Differentiating GHLA AND HPMA 60 ohm HQPC Open arcurt winding between W and U ISPY Measurement of differential pressure JNMP Faulty contactor coil KKHF Return inductive current to supply at switch off. KQUB G - 1/R KVVL R1/R2 - R3/R4 LKYH In a pressure transmitter. LLXP 0.2 A LQRG - 100 M Ohms NGTS 40 kA NRXM U-E, V-E. W-E, U-V,V-W, W-U NVKP Une fuses and overcurrent relays NVMA Incorrect frequency OFXE Thermocouple sensor OKWA 6 ohms OSDY The primary controller m a cascade control system PBKR The slave controller receives the set-point from the output signal of the master controller PDRS Temperature, humidity and surface contamination PEBH Contactor chattering (vibrating) QDFE 5 and 6 RGBR Better linearity and increased accuracy RNOO Integrator RPHF The controller will not react to a process change in this range RSDC Reduced current and reduced torque RTXB 4.6V SFGF OR gate SHXA Install a 100 ohm resistor in series with the coil SWQI Figure 1 TCKG Disconnect the thermocouple lead from the controller and replace with a mV source. TEOA The amount of apparent power that coukl flow into any fault at any point in the electrical network. THJL The gas, liquid or vapour which will minimise creation of an electric arc as contacts open. TPDU Zero-pomt is accurate, but 100% input is not Qivino 100% output UDFB Bandpass filter
UKRC Allowing stored energy in solenoid to dissipate as freewheel current and therefore prevent damage to transistor from inductive switching voltage. VTAU Solution of potassium hydroxide (KOH) and water VXJJ The secondary controller WGVI Rotten eggs. WJUT Apply reduced voltage to the element for a few minutes. Then retest and if ok put into service. WRW In the event of an earth fault vital equipment will not tnp WSOR It will allow for inrush current or motor specific faults WVMM Differential amplifier XNFD Level control XRGG fo- 1 / (2"PiM sqrt (L/C)) XSES It is possible to predict the control mathematically YAPA Adjust the slave controller with the master controller in manual mode YWKI Electoc motors will run at reduced speed and will tend to overheat. YYMW Absolute pressure

El 1

Uploaded by

Document Information

Original Description:

Original Title

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

El 1

Uploaded by

Copyright:

Available Formats

5.0 elektro ABBG Figure 1 ACJL One of the main switching elements in the tnac has failed.

You might also like