Intumescent Paint
Intumescent Paint
Intumescent Paint
1.2. Relevant identified uses of the substance or mixture and uses advised against Intended use See Technical Data Sheet. For professional use only. Application Method See Technical Data Sheet. 1.3. Details of the supplier of the safety data sheet International Paint Ltd. Manufacturer Stoneygate Lane Felling Gateshead Tyne and Wear NE10 0JY UK +44 (0)191 469 6111 Telephone No. +44 (0)191 438 3711 Fax No. 1.4. Emergency telephone number +44 (0)191 469 6111 24hr Manufacturer Official Advisory Body Telephone No.: Advice for Doctors and Hospitals +44 (0)844 892 0111 sdsfellingUK@akzonobel.com
Page 1 of 11
Using the Toxicity Data listed in section 11 & 12 the product is labelled as follows. According to Regulation (EC) No 1272/2008
Warning.
Contains: Fatty acids, C18-unsatd.,dimers,compds. with polyetheylenepolyamine-tall-oil fatty acid reaction products, Synthetic vitreous (silicate) fibres,
H315 Causes skin irritation. H317 May cause an allergic skin reaction. H319 Causes serious eye irritation. p260 Do not breathe mist / vapours / spray. p280 Wear protective gloves / eye protection / face protection. P303+361+353 IF ON SKIN (or hair): Remove / Take off immediately all contaminated clothing. Rinse skin with water / shower. P305+351+338 IF IN EYES: Rinse continuously with water for several minutes. Remove contact lenses if present and easy to do - continue rinsing. P501 Dispose of contents / container in accordance with local / national regulations. 2.3. Other hazards This product contains no PBT/vPvB chemicals.
2,4,6-Tris(dimethylaminomethyl) 2.5 - < 10 phenol CAS Number: 0000090-72-2 EC No. 202-013-9 Index No.: 603-069-00-0 REACH Reg. No.: 01-211956059727-xxxx Synthetic vitreous (silicate) fibres 2.5 - < 10 CAS Number: 0287922-11-6 EC No. Index No.: REACH Reg. No.: 01-211947231344-xxxx Amorphous silica, hydrophobic CAS Number: 0067762-90-7 EC No. Index No.: REACH Reg. No.: 1 - < 2.5
Xn;R22 Xi;R36/38
[1]
Xi; R38
Q [1]
[1]
Page 2 of 11
Tetraethylenepentamine CAS Number: 0000112-57-2 EC No. 203-986-2 Index No.: 612-060-00-0 REACH Reg. No.:
0-<1
Acute Tox. 4;H312 Acute Tox. 4;H302 Skin Corr. 1B;H314 Skin Sens. 1;H317 Aquatic Chronic 2;H411
[1]
[1] Substance classified with a health or environmental hazard. [2] Substance with a workplace exposure limit. [3] PBT-substance or vPvB-substance. *The full texts of the phrases are shown in Section 16.
6.1. Personal precautions, protective equipment and emergency procedures Remove sources of ignition, do not turn lights or unprotected electrical equipment on or off. In case of a major spill or spillage in a confined space evacuate the area and check that solvent vapour levels are below the Lower Explosive Limit before re-entering. 6.2. Environmental precautions Do not allow spills to enter drains or watercourses. 6.3. Methods and material for containment and cleaning up Ventilate the area and avoid breathing vapours. Take the personal protective measures listed in section 8. Contain and absorb spillage with non-combustible materials e.g. sand, earth, vermiculite. Place in closed containers outside buildings and dispose of according to the Waste Regulations. (See section 13). Clean, preferably with a detergent. Do not use solvents. Do not allow spills to enter drains or watercourses. If drains, sewers, streams or lakes are contaminated, inform the local water company immediately. In the case of contamination of rivers, streams or lakes the Environmental Protection Agency should also be informed.
8.1. Control parameters The following workplace exposure limits have been established by the Health and Safety Executive as published in EH40.
Material Amorphous silica, hydrophobic Short term (15 min. ave) Long term (8hr TWA) ppm mg/m3 ppm mg/m3 4 Comments
For Key to entries in 'Comments' column see Section 16 DNEL/PNEC values No Data Available 8.2. Exposure controls Provide adequate ventilation.Where reasonably practicable this should be achieved by the use of local exhaust ventilation and good general extraction. If these are not sufficient to maintain concentrations of particulates and any vapour below occupational exposure limits suitable respiratory protection must be worn. Eye/face protection Wear safety eyewear, e.g. safety spectacles, goggles or visors to protect against the splash of liquids. Eyewear should meet the requirements of standard EN 166. Skin protection For prolonged or repeated contact use protective gloves. Barrier creams may help to protect the exposed areas of skin, they should however not be applied once exposure has occurred. Skin should be washed after contact. Use chemical resistant gloves classified under Standard EN 374: Protective gloves against chemicals and micro-organisms. Recommended gloves: Viton or Nitrile Breakthrough Time: 480 min When prolonged or frequently repeated contact may occur, a glove with a protection class of 6 (breakthrough time greater than 480 minutes according to EN 374) is recommended. When only brief contact is expected, a glove with a protection class of 2 or higher (breakthrough time greater than 30 minutes according to EN 374) is recommended. NOTICE: The selection of a specific glove for a particular application and duration of use in a workplace should also take into account all relevant workplace factors such as, but not limited to: Other chemicals which may be handled, physical requirements (cut/puncture protection, dexterity, thermal protection), potential body reactions to glove materials, as well as the instructions/specifications provided by the glove supplier. The user must check that the final choice of type of glove selected for handling this product is the most appropriate and takes into account the particular conditions of use, as included in the user's risk assessment. Other Overalls which cover the body, arms and legs should be worn. Skin should not be exposed. Barrier creams may help to protect areas which are difficult to cover such as the face and neck. They should however not be applied once exposure has occurred. Petroleum jelly based types such as Vaseline should not be used. All parts of the body should be washed after contact. Respiratory protection If workers are exposed to concentrations above the exposure limit they must use the appropriate,certified respirators.For maximum protection when spraying this product it is recommended that a multi layer combination type filter, such as ABEK1, is used. In confined spaces use compressed air or fresh air
Page 5 of 11
Acute toxicity Exposure to solvent vapour concentrations from the component solvents in excess of the stated occupational exposure limits may result in adverse health effects such as mucous membrane and respiratory system irritation and adverse effects on the kidneys, liver and central nervous system. Symptoms include headache, nausea, dizziness, fatigue, muscular weakness, drowsiness and in extreme cases, loss of consciousness. Repeated or prolonged contact with the preparation may cause removal of natural fat from the skin resulting in dryness, irritation and possible non-allergic contact dermatitis. Solvents may also be absorbed through the skin. Splashes of liquid in the eyes may cause irritation and soreness with possible reversible damage. The preparation has been assessed using the Acute Toxicity Data listed below, and classified for toxicological hazards accordingly. See section 2 for details.
Ingredient 2,4,6-Tris(dimethylaminomethyl)phenol - (9072-2) Amorphous silica, hydrophobic - (67762-907) Fatty acids, C18-unsatd.,dimers,compds. with polyetheylenepolyamine-tall-oil fatty acid reaction products - (64754-99-0) Synthetic vitreous (silicate) fibres - (28792211-6) Tetraethylenepentamine - (112-57-2)
Inhalation Vapour LD50, mg/L/4hr Not Available Not Available Not Available
Inhalation Dust/Mist LD50, mg/L/4hr Not Available Not Available Not Available
Percent Unknown Toxicity: 45 Classification Acute toxicity (oral) Acute toxicity (dermal) Acute toxicity (inhalation) Skin corrosion/irritation Serious eye damage/irritation Respiratory sensitization Skin sensitization Germ cell mutagenicity Carcinogenicity Reproductive toxicity STOT-single exposure STOT-repeated exposure Aspiration hazard Category Not Classified Not Classified Not Classified 2 2 Not Classified 1 Not Classified Not Classified Not Classified Not Classified Not Classified Not Classified Hazard Description Not Applicable Not Applicable Not Applicable Causes skin irritation. Causes serious eye irritation. Not Applicable May cause an allergic skin reaction. Not Applicable Not Applicable Not Applicable Not Applicable Not Applicable Not Applicable
Page 7 of 11
dangerous for the environment. See section 3 for details There are no data available on the product itself. The product should not be allowed to enter drains or water courses. Aquatic Ecotoxicity
96 hr LC50 fish, 48 hr EC50 crustacea, mg/l mg/l Not Available Not Available ErC50 algae, mg/l 0.00 ( hr),
Ingredient Fatty acids, C18unsatd.,dimers,compds. with polyetheylenepolyamine-tall-oil fatty acid reaction products - (64754-99-0) 2,4,6-Tris(dimethylaminomethyl)phenol (90-72-2) Synthetic vitreous (silicate) fibres (287922-11-6) Amorphous silica, hydrophobic (67762-90-7) Tetraethylenepentamine - (112-57-2)
12.2. Persistence and degradability There is no data available on the preparation itself. 12.3. Bioaccumulative potential Not Measured 12.4. Mobility in soil No data available 12.5. Results of PBT and vPvB assessment This product contains no PBT/vPvB chemicals. 12.6. Other adverse effects No data available
14.1. UN number 14.2. UN proper shipping name 14.3. Transport hazard class(es) ADR/RID/ADN IMDG class/div
Non hazardous
Page 8 of 11
Sub Class -
14.4. Packing group 14.5. Environmental hazards ADR/RID/ADN Environmentally Hazardous: No IMDG Marine Pollutant: No
14.6. Special precautions for user No further information 14.7. Transport in bulk according to Annex II of MARPOL73/78 and the IBC Code Not Applicable
16.1. Classification of the substance or mixture Classification according to 67/548/EEC or 1999/45/EC. Xi Irritant. R36/38 R43 16.2. Label elements According to 1999/45/EC Irritating to eyes and skin. May cause sensitisation by skin contact.
Irritant Contains: Fatty acids, C18-unsatd.,dimers,compds. with polyetheylenepolyamine-tall-oil fatty acid reaction
Page 9 of 11
products, Synthetic vitreous (silicate) fibres, R36/38 Irritating to eyes and skin. R43 May cause sensitisation by skin contact. S23 Do not breathe vapour/spray. S24 Avoid contact with skin. S37 Wear suitable gloves. S51 Use only in well-ventilated areas. P. Phrases; IMPORTANT NOTE: the information contained in this data sheet (as may be amended from time to time) is not intended to be exhaustive and is presented in good faith and believed to be correct as of the date on which it is prepared. It is the user's responsibility to verify that this data sheet is current prior to using the product to which it relates. Persons using the information must make their own determinations as to the suitability of the relevant product for their purposes prior to use. Where those purposes are other than as specifically recommended in this safety data sheet, then the user uses the product at their own risk. MANUFACTURERS DISCLAIMER: the conditions, methods and factors affecting the handling, storage, application, use and disposal of the product are not under the control and knowledge of the manufacturer. Therefore the manufacturer does not assume responsibility for any adverse events which may occur in the handling, storage, application, use, misuse or disposal of the product and, so far as permitted by applicable law, the manufacturer expressly disclaims liability for any and all loss, damages and/or expenses arising out of or in any way connected to the storage, handling, use or disposal of the product. Safe handling, storage, use and disposal are the responsibility of the users. Users must comply with all applicable health and safety laws. Unless we have agreed to the contrary, all products are supplied by us subject to our standard terms and conditions of business, which include limitations of liability. Please make sure to refer to these and / or the relevant agreement which you have with AkzoNobel (or its affiliate, as the case may be). AkzoNobel The information in this Health & Safety Data Sheet is required pursuant to EC Regulation 1907(2006) and the Chemicals (Hazard Information & Packaging for Supply) Regulations 2009.
Key to 'Comments' column in Section 8. (+) There is a risk of absorption through unbroken skin. (C) Capable of causing cancer and/or heritable genetic damage. (R) Suppliers recommended limit. (S) Capable of causing occupational asthma. The full text of the R, H & EUH phrases appearing in section 3 is: H302 Harmful if swallowed. H312 Harmful in contact with skin. H314 Causes severe skin burns and eye damage. H315 Causes skin irritation. H317 May cause an allergic skin reaction. H319 Causes serious eye irritation. H411 Toxic to aquatic life with long lasting effects. R21/22 Harmful in contact with skin and if swallowed. R22 Harmful if swallowed. R34 Causes burns.
Page 10 of 11
R36 Irritating to eyes. R36/38 Irritating to eyes and skin. R38 Irritating to skin. R43 May cause sensitisation by skin contact. R51/53 Toxic to aquatic organisms, may cause long-term adverse effects in the aquatic environment. The following sections have changed since the previous revision. End of document
Your attention is drawn to the disclaimer on the Product Data Sheet which with this Safety Data Sheet and the package labelling comprise an integral information system about this product. Copies of the Product Data Sheet are available from International Paint on request or from our Internet sites : www.yachtpaint.com , www.international-marine.com, www.international-pc.com
Page 11 of 11