Gierie Invisalign Deep Bite White Paper Virtual Bite Ramps PDF

CLINICAL TIPS & TECHNIQUES
Techniques for Deep Bite Correction with Invisalign Virtual Bite Ramps
By Dr. William V. Gierie, DDS, MS, PA
In the past deep bites have been a challenge to treat with occlusal coverage appliances like Invisalign. The transient posterior intrusion that we often see with posterior occlusal coverage leads to autorotation of the mandible. This has the effect of bringing the lower incisors forward and superior . resulting in more overbite than was seen in the ClinCheck However, if we can learn to mitigate the transient posterior intrusion inherent in aligners, we can begin to level the lower arch earlier with Invisalign than with braces. This may result in shorter treatment times to open a deep bite with aligners than with fixed appliances.
prevent transient posterior intrusion. The amount of overjet will determine how thick you make the virtual bite ramps and whether you use horizontal or vertical orientation.
Virtual Bite Ramps in ClinCheck Treatment Plan
Virtual Bite Ramp on Lingual Aspect of Aligner
Troubleshooting Tip: If the patient has a large overjet, their lower
Tip 1: Deep Bites Can Be Corrected with Relative Posterior Extrusion or Absolute Anterior Intrusion
Facial esthetic factors such as face height, mandibular plane angle and incisor exposure at rest and smile help determine which technique or combination of techniques you will employ. First, determine if incisor display is adequate or excessive. Then, look at the face height and curve of Spee and optimize your strategy based on this information. For example, in a patient with excessive incisor and gingival display with a high mandibular plane angle, you would not want to open the bite with absolute or relative posterior extrusion. Absolute anterior intrusion would make sense here and would improve anterior esthetics.
incisors will not contact the Virtual Bite Ramps and you will not see the same bite opening effect. Mandibular advancement, class II elastics and upper IPR can all reduce overjet to allow contact with the virtual bite ramps. Vertically oriented bite ramps will follow the lingual slope of the upper incisors and will allow earlier contact with the bite ramps in those patients with large overjets. Be aware that some SmartForce features such as the lingual Power Ridges on maxillary incisors can interfere with virtual bite ramps if they occupy the same spot on the aligner. In the case of a conflict, you need to decide which is more important in that particular case and remove the conflicting feature.
Tip 2: If You Are Planning on Absolute Anterior Intrusion Decide if It Should Be the Upper, Lower or Both Arches and Add Virtual Bite Ramps to Assist the Intrusion
Virtual bite ramps are lingually placed 1-2 mm thick horizontal rectangular attachments, horizontal gingival beveled attachments or vertical rectangular attachments. Aligns default is the horizontal beveled attachment. Virtual Bite Ramps are never bonded to the teeth but act as a bite ramp when the patient has the aligners in place. By discluding the posterior teeth they
Vertical Bite Ramps
Tip 3: Clincheck Will See the Virtual Bite Ramp as a Collision Between an Attachment and the Lower Incisors but Clinically the Virtual Bite Ramps Will Disclude the Posterior Teeth
Virtual bite ramps eliminate transient posterior intrusion, disclude posterior teeth to aid crossbite correction, add intrusion force to lower incisors and may cause a slight clockwise rotation of the lower occlusal plane.
Treatment Applicability: Virtual Bite Ramps are useful for any
patient with a deep bite who needs relative extrusion or absolute anterior intrusion. They are also useful in the normal overbite patient where transient posterior intrusion and posterior open bite is a concern. The only real contra-indication to using Virtual Bite Ramps would be an open bite patient where you would like some posterior intrusion. In this case the virtual bite ramps would prevent the posterior intrusion.
Communicating with Technicians: Simply ask for virtual bite
ramps and specify you want horizontal or vertical, rectangular or beveled, thickness (in mm) and where you would like them placed. An example would be, Please place 1.25 mm thick gingival beveled virtual bite ramps on the lingual of the U2-2.
ClinCheck
Please place 1 mm from the incisal edge of the U1s.

Reviewing ClinCheck Treatment Plans for Deep Bite Cases:
When reviewing ClinCheck treatment plans make sure you are getting the type of movement you want based on your evaluation of the patients esthetics. Relative posterior extrusion
Real World
or absolute anterior intrusion or a combination of the two are possible to certain degrees with aligners, so make sure you are getting what you requested by carefully reviewing the ClinCheck treatment plan. On patients who have a short lower face height, low mandibular plane angle, excessive maxillary incisor display and supra-erupted lower incisors you may need to employ both techniques to open the bite effectively. Generally, Dr. Gierie will overcorrect a deep bite by 1 mm by placing the bite ramps 1 mm from the incisal edge of the U1s. The ClinCheck treatment plan will actually show normal 2-3 mm of overbite but clinically you will get a little overcorrection. Remember, you are in control of what happens and you are prescribing the movement.
Managing Patient Expectations: It is better to include the virtual
Tip 4: Adding Bite Ramps During Treatment

If you find yourself in need of a bite ramp during treatment and you didnt build it into the ClinCheck treatment plan, you can add bite ramps to an aligner with the Bite Plane Plier invented by Dr. Keith Hilliard. If you need to add a bite ramp to a vacuum formed retainer, the Orthoarch mini mold anterior bite ramp can be used. Adding bite planes to aligners can be helpful if the clinician is having trouble opening the bite, notices transient posterior intrusion or has a patient who is clenching excessively on the aligners (headaches etc.) If the patient is a severe clencher they can crush the thermoformed bite planes so in this case they can be reinforced with composite. This doesnt seem to happen with factory made virtual bite ramps since they are full thickness plastic.
bite ramps from the beginning of treatment so the patients will get used to them right away. Some patients will experience speech disruption for a day or two if you add bite ramps to their aligners but this is similar to them getting used to speaking with their initial set of aligners. In bruxers or clenchers that had improvement of their symptoms with virtual bite ramps built in to their aligners, its a good idea to continue them in their retainers.
To learn more about Deep Bite clinical techniques, watch the Ask the Expert webinar by Dr. Nicozisis and Dr. Gierie at http://learn.invisalign.com/ate/05-25-2012
Disclosure: Dr. Gierie was provided an honorarium from Align for his presentation. The statements, views and opinions expressed in this presentation are those of the author, and do not necessarily reflect the views and opinions of Align Technology, Inc.
Align Technology, Inc. 2560 Orchard Pkwy San Jose, CA 95131 WWW.INVISALIGN.COM
2013 Align Technology, Inc. All rights reserved. Invisalign and ClinCheck, among others, are registered trademarks of Align Technology, Inc. June 2013

Gierie Invisalign Deep Bite White Paper Virtual Bite Ramps PDF

Uploaded by

Copyright:

Available Formats

Gierie Invisalign Deep Bite White Paper Virtual Bite Ramps PDF

Uploaded by

Document Information

Original Title

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

Gierie Invisalign Deep Bite White Paper Virtual Bite Ramps PDF

Uploaded by

Copyright:

Available Formats

CLINICAL TIPS & TECHNIQUES

Virtual Bite Ramps in ClinCheck Treatment Plan

Virtual Bite Ramp on Lingual Aspect of Aligner

Troubleshooting Tip: If the patient has a large overjet, their lower

Treatment Applicability: Virtual Bite Ramps are useful for any

Please place 1 mm from the incisal edge of the U1s.

Tip 4: Adding Bite Ramps During Treatment

You might also like