Location via proxy:   [ UP ]  
[Report a bug]   [Manage cookies]                
Scribd
Upload
51 views

Ec Project Report Guidelines

Uploaded by

api-249398117
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as PDF, TXT or read online on Scribd
51 views

Ec Project Report Guidelines

Uploaded by

api-249398117
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 5

Mahatma Gandhi Missions College of Engineering and Technology, Noida Department of Electronics and Communication General Rules for

Final Year Project:


1. Project Reports should be submitted to candidate's advisor for review well in advance so that the supervisor suggests the necessary changes that should be incorporated in the reports. 2. The Department Library requires the deposit of one copy of the approved report while the supervisor concerned requires one copy. Some Suggestions to improve the quality of the reports are given below. One should note the spelling of Foreword. Periods and commas go inside quotation marks; semicolons and colons go outside. The word data is plural and requires a plural verb. Numbers from one to nine, inclusive, should be spelled out, for number 10 and above, use numerals. Numbers should be spelled out when they begin a sentence. 3. One should spell out per cent; do not use %, and write per cent as two words without a period. He should not say "due to" for "because of", "over" for "more than", "secure" for "obtain," etc. Be sure tenses throughout are consistent, likewise that all verbs and subjects agree in number; that the antecedent of each pronoun is clear. 4. Use of the pronoun such as "I", "We", "You", "He", "They" must be avoided. suggested to use passive voice in such cases. It is

PROJECT REPORT STRUCTURE


Preliminary Pages: 1. 2. 3. 4.
Title Page Certificate signed by the supervisor Declaration from the project group to avoid the problem of plagiarism. Acknowledgements, to those who have helped them in matters scientific, and also indirectly by providing such essentials as food, education, genes, money, help, advice, friendship etc. 5. Table of Contents provides the list of all headings and subheadings with page numbers

Abstract:
An abstract is an abbreviated version of the project report. It should be limited to a maximum of 250 words. An abstract should have the following five pieces such as Introduction, Problem Statement, Procedure, Results and Conclusion.

Chapters in Report: 1. Chapter 1: Introduction


The purpose of an introduction in the B. Tech Project Report is to justify the reasons for writing about the report. The goal in this section is to introduce the topic to the reader, provide an overview of previous research on the topic, and identify the own hypothesis. It contains introduction to problem identified, summarize previous research work, provide the hypothesis and Organization of the Report Use of Tense Very often, it has been seen that author mixes up various tenses to express. It is expected that one uses only present tense through the report.

2. 3. 4. 5. 6.

Chapter 2: Theory or Background of the Problem. (As shown in Sample Report) Chapter 3: Factors involve in the Problem. (As shown in Sample Report) Chapter 4: Proposed model or solution to exist problem. (As shown in Sample Report) Results of work done. (As shown in Sample Report) Conclusion. (As shown in Sample Report)

References: Appendix-A Appendix-B Appendix-C

TEXT PROCESSING INFORMATION


1. The original copy shall be typed on 75 or 80 gr./m2 white paper. All photocopies shall be run on the same grade of paper. Size of paper shall be 210 x 297 mm, i.e. A4. 2. Laser printer and Ink Jet printer are acceptable. 3. As a character font, one should use Times New Roman. The font size must be 12 point in the text and at least 8 point in the figures. 4. Margins of pages shall conform to the following specifications. a. Left margin - 3 1/2 cm. from edge of paper. b. Right margin - 2 cm. from edge of paper. c. Top margin - 3 1/2. from edge of paper. d. Bottom margin - 2 cm. from edge of paper. The above margins shall be observed on charts, graphs, tables, and drawings. Folded papers will not be accepted unless there is absolutely no other way for the material to be presented. 5. Spacing of the text material shall be 1.5 with the following exceptions: a. Footnotes - single spacing b. Long biographical quotes - single spacing c. Extensive quotations - single spacing and indented eight (8) spaces relative to the text material. 6. Headings used in the report shall conform to the following rules: a. Chapter Headings - CHAPTER 1, CHAPTER 2, CHAPTER 3 etc. (1) Must begin a new page and be centered using the Font Size 18 with Bold Fold. Omit period at the end of the heading. (2) Must be typed in upper case letters. (3) Chapter headings are to be titled names that reflect content of the text that (4) It should be centered and Font Size to be used is 18 with Bold Face. (5) Must be typed in upper case letters. (6) Provide 3 blank lines after the chapter name. follows.

b. Second Headings - 2.1, 2.2, 2.3, etc. (1) Must be towards left margin and be typed in capital and lower case letters; i.e., the first letter of each word except conjunctions, prepositions, and articles must be a capital letter. Omit period at the end of heading. (2) The letter designation of the heading shall be followed by a period and two blank spaces. (3) Must be three spaces below preceding text and two spaces ahead of succeeding text. (4) Font Size to be used is 14 with Bold Face. (5) In case it is found that first line of the succeeding text starts from the next page, then this heading should start from the next page using page break. c. First sub-headings - 2.2.1, 2.2.2 , etc. (1) Must be typed on separate lines beginning at the left margin line of the text, but need not begin a new page. (2) Must be typed in capital and lower case letters except conjunctions, prepositions, and articles. (3) The number designation of the heading shall be followed by a period and two spaces. Omit period at the end of the heading. (4) Must be separated from the succeeding text by three spaces. (5) Font Size to be used is 12 with Bold Face. (6) In case it is found that first line of the succeeding text starts from the next page, then this sub-heading should start from the next page using page break. d. Second sub-headings- 2.2.1.1, 2.2.1.2 etc.. (second sub-headings should be avoided if possible) (1) Must be typed on the same line as the text it introduces beginning at the left margin line of the text. (2) Must be typed in capital and lower case letters except conjunctions, prepositions, and articles. (3) Must be followed by a period at the end of the heading and must be underscored by a line. (4) The letter designation shall be followed by a period and two spaces. (5) Font Size to be used is 12. (6) In case it is found that first line of the succeeding text starts from the next page, then this second sub-heading should start from the next page using page break.

7. Figures and Tables: Ideally, every result claimed in the text should be documented with data, usually data presented in tables or figures. If there are no data provided to support a given statement of result or observation, one should consider adding more data, or deleting the unsupported "observation." Examine figure(s) or table(s) pertaining to the result(s). Author should assess whether: 1. the data support the textual statement 2. the data contradict the textual statement 3. the data are insufficient to prove The actual figures and tables should be embedded/inserted in the text, generally on the page following the page where the figure/table is first cited in the text. All figures should be numbered and cited consecutively in the text as Figure 2.1, Figure 2.2, to indicate the first and second figures in Chapter 2 respectively. Similarly it is the case with tables such as Table 3.1, Table 3.2, etc. 8. Pagination and Paragraphs Each page in the report or dissertation is expected to bear a number. Only one side of the paper may be used. The following plan should be used exclusively: a. The preliminary section, including the title page; copyright page, if any; foreword, preface, or acknowledgements; table of contents; etc., should be numbered, using lower case Roman Numerals, e.g., i, ii, iii, etc. The title page counts as Page i, but the number does not appear. b. For the remainder of the report, Arabic numbers are used. Each page must be numbered. Page numbers are to be placed 2 centimeters from the top and right hand margins on the pages. 9. Binding Specifications: Beside the supervisor's and personal copies, two copies of the project report should be bound in light Blue color (Matt finish) hard rexin binding with golden engraved letters. Ensure that the side face of thickness of the thesis should have the surname of the students, and month of submission at top and bottom edge respectively. 10. Number of Copies: Two hardcopies (one for supervisor, one for departmental library) along with softcopy of the thesis are to be submitted before the due date to the Department.

You might also like