Professional Documents
Culture Documents
Sheet: Differential Global Positioning System (DGPS)
Sheet: Differential Global Positioning System (DGPS)
What is DGPS?
DGPS provides differential corrections to a GPS receiver in order to improve navigation accuracy and monitors the integrity of GPS satellite transmissions. Integrity monitoring of the reference stations is a vital feature of DGPS. The stations test for GPS signals that are out of specification and immediately notify users to disregard the signal. With DGPS, this warning occurs within a few seconds of the satellite becoming unhealthy, compared to the GPS system, where up to 12 hours can elapse before notification is received. The improved accuracy offered by DGPS takes on greater significance in the 21st century. This is because the use of highly accurate positional information is central to the functioning of navigational aids like Electronic Chart Display and Information Systems (ECDIS) and Automatic (ship) Identification System (AIS). Each DGPS radio beacon comprises of two independent GPS receivers, (including special software to calculate the corrections), an MSK modulator, a transmitter operating in the LF/MF band (285 - 325 kHz), a DGPS station controller and an integrity monitor. Critical components of the system are redundant and the DGPS radio beacons are remotely controlled and monitored 24 hours a day. The status of any unhealthy DGPS radio beacon is reported to mariners via coastal navigational (AUSCOAST) warnings.
Fact Sheet Differential Global Positioning System (DGPS) Fact Sheet Transferring ownership of an Australian ship
This form of DGPS uses pseudo-range (distance measurement) corrections and range-rate corrections from a single reference station, which has sufficient channels (typically 12) to track all satellites in view. Pseudo-ranges are simultaneously measured to all satellites in view, and using the known position of the receivers antenna and the positional data from each satellite, the errors in the pseudo-ranges are calculated. These errors are converted to corrections and are broadcast to user receivers. The users GPS receiver applies the corrections to the pseudo-ranges measured to each satellite used in its position calculation. The GPS receiver always applies the latest corrections received. Using this method, and depending on the user-to-reference station separation and the age of the corrections being applied, horizontal accuracy of the system can be improved from 13 to 22 metres (95% of the time) to better than 10 metres (95% of the time). Monitoring of AMSAs operational stations indicates that accuracies of 2-4 metres can be expected from a typical maritime DGPS receiver. The further the user is from the reference station, the less accurate the navigational solution is likely to be.
Equipment Required
To improve GPS navigational accuracy, users need a GPS receiver, which is differential-ready, and a DGPS beacon receiver. Another solution is to use a DGPS receiver that houses the GPS and beacon receivers inside the one unit. Installation requires mounting the DGPS beacon receiver antenna, and connecting the DGPS beacon receiver to the DGPS (or RTCM) port on your Differential-Ready GPS receiver. This equipment can be purchased from GPS or maritime equipment distributors.
Horn Island Darwin Weipa Cape Flattery Ingham Karratha Exmouth Mackay Gladstone Brisbane
Mallacoota
Visit www.amsa.gov.au/navigation/services/dgps/ for up-to-date information, including details on the accuracy of AMSAs DGPS reference stations antenna position surveys.