2 Double Column Research Paper Format

Word Template for Full Length Paper
1st Author
2nd Author
3rd Author
1st author's affiliation

1st line of address
2nd line of address
Telephone number
2nd author's affiliation

1st line of address
2nd line of address
Telephone number
3rd author's affiliation

1st line of address
2nd line of address
Telephone number
1st author's E-mail

address
2nd E-mail
Abstract
The abstract is to be in fully-justified italicized text, at
the top of the left-hand column as it is here, below the
author information. Use the word Abstract as the
title, in 12-point Times, boldface type, centered relative
to the column, initially capitalized. The abstract is to be
in 10- point, single-spaced type, and may be up to 3 in.
(7.62 cm) long. Leave two blank lines after the abstract,
then begin the main text. All manuscripts must be in
English.
1. Introduction
These guidelines include complete descriptions of the
fonts, spacing, and related information for producing
your proceedings manuscripts. Please follow them and if
you have any questions, direct them to the production
editor in charge of your proceedings at the IEEE
Computer Society Press: Phone (714) 821-8380 or Fax
(714) 761-1784.
2. Formatting Your Paper

All printed material, including text, illustrations, and
charts, must be kept within a print area of 6-7/8 inches
(17.5 cm) wide by 8-7/8 inches (22.54 cm) high. Do not
write or print anything outside the print area. All text
must be in a two-column format. Columns are to be 31/4 inches (8.25 cm) wide, with a 5/16 inch (0.8 cm)
space between them.
Text must be fully justified. A format sheet with the
margins and placement guides is available in both Word
and PDF files as <format.doc> and <format.pdf>. It
contains lines and boxes showing the margins and print
areas. If you hold it and your printed page up to the light,
you can easily check your margins to see if your print
area fits within the space allowed.
3rd E-mail
3. Main Title
The main title (on the first page) should begin 1-3/8
inches (3.49 cm) from the top edge of the page, centered,
and in Times 14-point, boldface type. Capitalize the first
letter of nouns, pronouns, verbs, adjectives, and adverbs;
do not capitalize articles, coordinate conjunctions, or
prepositions (unless the title begins with such a word).
Leave two blank lines after the title.
4. Author Name(s) and Affiliation(s)

Author names and affiliations are to be centered
beneath the title and printed in Times 12-point, nonboldface type. Multiple authors may be shown in a twoor three-column format, with their affiliations below their
respective names. Affiliations are centered below each
author name, italicized, not bold.
Include e-mail
addresses if possible. Follow the author information by
two blank lines before main text.
5. Second and Following Pages

The second and following pages should begin 1.0 inch
(2.54 cm) from the top edge. On all pages, the bottom
margin should be 1-1/8 inches (2.86 cm) from the bottom
edge of the page for 8.5 x 11-inch paper; for A4 paper,
approximately 1-5/8 inches (4.13 cm) from the bottom
edge of the page.
6. Type-style and Fonts

Wherever Times is specified, Times Roman, or New
Times Roman may be used. If neither is available on
your word processor, please use the font closest in
appearance to Times that you have access to. Please
avoid using bitmapped fonts if possible. True-Type 1
fonts are preferred.
7. Main Text
Type your main text in 10-point Times, single-spaced.
Do not use double-spacing. All paragraphs should be
indented 1 pica (approximately 1/6- or 0.17-inch or 0.422

cm). Be sure your text is fully justifiedthat is, flush
left and flush right. Please do not place any additional
blank lines between paragraphs. You can use courier for
source code.
For I = 1 to 10 do
Print this figure
End;
List and number all bibliographical references in 9point Times, single-spaced, at the end of your paper.
When referenced in the text, enclose the citation number
in square brackets, for example [2-4], [2, 5], and [1].
[1] Briand, L. C., Daly, J., and Wst, J., "A unified framework
for coupling measurement in objectoriented systems", IEEE
Transactions on Software Engineering, 25, 1, January 1999, pp.
91-121.
Figure 1. Example figure.
7.1. Figure and Table Captions

Captions should be 10-point Helvetica (or a similar
sans-serif font), boldface. Callouts should be 9-point
Helvetica, non-boldface. Initially capitalize only the first
word of each figure caption and table title. Figures and
tables must be numbered separately. For example:
Figure 1. Example figure., Table 1. Table example..
Figure captions are to be below the figures (see Figure
1). Table titles are to be centered above the tables (see
Table 1.
Table 1. Table example.
One
10. References
Two
Three
8. First-order Headings
For example, 1. Introduction, should be Times 12point boldface, initially capitalized, flush left, with one
blank line before, and one blank line after. Use a period
(.) after the heading number, not a colon.
8.1. Second-order Headings

As in this heading, they should be Times 11-point
boldface, initially capitalized, flush left, with one blank
line before, and one after.
8.1.1. Third-order Headings. Third-order headings, as
in this paragraph, are discouraged. However, if you must
use them, use 10-point Times, boldface, initially
capitalized, flush left, preceded by one blank line,
followed by a period and your text on the same line.
9. Acknowledgements
This work was supported in part by a grant from the
National Science Foundation.
[2] Maletic, J. I., Collard, M. L., and Marcus, A., "Source Code
Files as Structured Documents", in Proceedings 10th IEEE
International Workshop on Program Comprehension
(IWPC'02), Paris, France, June 27-29 2002, pp. 289-292.
[3] Marcus, A., Semantic Driven Program Analysis, Kent State
University, Kent, OH, USA, Doctoral Thesis, 2003.
[4] Marcus, A. and Maletic, J. I., "Recovering Documentationto-Source-Code Traceability Links using Latent Semantic
Indexing", in Proceedings 25th IEEE/ACM International
Conference on Software Engineering (ICSE'03), Portland, OR,
May 3-10 2003, pp. 125-137.
[5] Salton, G., Automatic Text Processing: The Transformation,
Analysis and Retrieval of Information by Computer, AddisonWesley, 1989.

2 Double Column Research Paper Format

Uploaded by

Copyright:

Available Formats

2 Double Column Research Paper Format

Uploaded by

Document Information

Original Description:

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

2 Double Column Research Paper Format

Uploaded by

Copyright:

Available Formats

Word Template for Full Length Paper

1st author's affiliation

2nd author's affiliation

3rd author's affiliation

1st author's E-mail

2. Formatting Your Paper

4. Author Name(s) and Affiliation(s)

5. Second and Following Pages

6. Type-style and Fonts

indented 1 pica (approximately 1/6- or 0.17-inch or 0.422

Figure 1. Example figure.

7.1. Figure and Table Captions

8.1. Second-order Headings

You might also like