PB Antenna Design

G. Sharma, V. Sharma and P. K. Singhal / IJECCT 2013, Vol.
3 (2)
18
Performance Investigation Of Yagi-Uda Antenna Using

Different Shapes Of Antenna Element At 2GHz
Gulshan Sharma,Vijay Sharma and P.K. Singhal
Department of Electronics, Madhav institute of Technology & Science, Gwalior-474005, India
gulshan087@gmail.com, chottu.vijay@gmail.com, pks_65@yahoo.com
Abstract: This paper is aimed to evaluate the performance

of the Yagi-Uda Antenna with squared shaped Antenna
element and compare its performance from conventional
spherical shaped Yagi Antenna. For this job, two YagiUda Antennas has been designed at 2GHz frequency with
two different shape of Antenna element. The Antennas
potential characteristics such as return loss, radiation
pattern, have been measured for the analysis of proposed
Antenna. The related designing parameters were also
discussed in this paper.
Keywords- Antenna, Yagi-Uda, Return Loss, Radiation
Pattern
I.
INTRODUCTION
A YagiUda Antenna is a widely used Antenna design due

to its high forward gain capability, low cost and ease of
construction. It is commonly used as a roof top television
receiver. Basically an Antenna is a areal system that
matches or coupled the energy to the free space. A YagiUda Antenna is a directional Antenna system consisting of
an array of a dipole and additional closely coupled
parasitic elements as follows:
A reflector
One or more directors
A typical Yagi-Uda Antenna consists of a dipole
element which is directly connected to the transmission
feed-line and responsible of for energizing the whole
structure. Another element called reflector is 5% longer
than dipole element & other element are called directors.
Directors are 5% shorter than the dipole elements. The
number of directors depends on the gain and for achieving
high gain it should be better to have equally spaced
element with larger number of directors.
The function of parasitic element is to improve the
radiation pattern in the forward direction. The reflector
provides 3dB additional forward gain but having more
than one reflector has little benefit [1-6].
II.
For a particular operating frequency typical design

parameter has been taken from NBS (see in NBS note
688)[12-13], as shown in Fig. 1.
Figure 1 - Geometrical design of Yagi Antenna
In case of Yagi-Uda Antenna the boom isolation play a

significant role in performance Antenna. Here, two
different booms are used to fabricate the Antennas. All the
calculated parameters are shown in Table 1 below.
Table 1.
Freq (in MHz)

Boom Length
Gain (in dB approx.)
Elements
Diameter of Parasitic elements (in mm)
Shape of Boom
Is the Boom isolated from Parasitics
2000
100
1200
5
6
Square &
Spherical
Yes
The typical cross sectional view of the proposed

Antennas are shown in Figure 2(a) and Figure 2(b).
ANTENNA DESIGN:
There are no simple formulas for designing Yagi-Uda

Antenna due to the non-linear relationships between
physical parameter such as element length, diameter and
position and electrical characteristics such as input
impedance and gain, but performance can be estimated by
computer simulation [9-11].
Figure 2(a) - Yagi-Uda Antenna using cylindrical iron rod as

Antenna element.
G. Sharma, V. Sharma and P. K. Singhal / IJECCT 2013, Vol. 3 (2)
19
Figure 2(b) - Yagi-Uda Antenna using square iron rod as Antenna

element.
III.
MEASURED RESULTS:
All the measurement has been done by using FS-315

Spectrum Analyzer connected to the SWR Bridge &
proposed Antennas as shown in Fig. 3.
Fig
ure 4(b) Measured Return Loss of the proposed Antenna with
spherical shaped metal rod.
Figure 3 - Setup used for measurement.

Figure 5: Comparative Analysis between both the Yagis.
Figure 4(a) Measured Return Loss of the proposed Antenna

with square shaped metal rod.
Figure 6: Radiation pattern for the proposed antenna system
G. Sharma, V. Sharma and P. K. Singhal / IJECCT 2013, Vol. 3 (2)
IV.
SUMMARY
A Yagi-Uda Antenna has been fabricated with two

different shapes of Antenna elements & from the analysis
of the proposed Antennas this paper realized that the
spherical shaped is the better choice as compared with
square shaped element to achieve better potential Antenna
characteristics through Yagi-Uda Antenna. So eventually it
can be said that the square shaped Antenna element
increases the beam-width & makes the radiation pattern
nearest to omni-directional one. In spite of that it also
gives multi-frequency return loss characteristics to the
Yagi-Uda Antenna. There can be a single reason behind
that the reflections occur through their sharp edges which
creates the dramatic change in the performance of YagiUda Antenna.
REFERENCES:
[1]
[2]
[3]
[4]
[5]
[6]
Chou, H. T., K. L. Hung, and C. Y. Chen, Utilization of a Yagi

antenna director array to synthesize a shaped radiation pattern for
optimum coverage in wireless communications," Journal of
Electromagnetic Waves and Applications, Vol. 23, No. 7, 851.
Li, J.-Y. and J. L. Guo, Optimization technique using dierential
evolution for Yagi-Uda antennas," Journal of Electromagnetic
Waves and Applications, Vol. 23, No. 4, 449.
Misra, I. S., R. S. Chakrabarty, and B. B. Mangaraj, \Design,
analysis and optimization of V-dipole and its three-element YagiUda array," Progress In Electromagnetics Research, PIER 66,156,
2006.
Rattan, M., M. S. Patterh, and B. S. Sohi, \Optimization of YagiUda
antenna
using
simulated
annealing,"
Journal
ofElectromagnetic Waves and Applications, Vol. 22, No. 2,
291,2008.
Mahmoud, K. R., M. El-Adawy, S. M. M. Ibrahem, R. Bansal, K.
R. Mahmoud Visiting, and S. H. Zainud-Deen, \Performance
[7]
[8]
[9]
[10]
[11]
[12]
[13]
[14]
[15]
[16]
[17]
[18]
20
of circular Yagi-Uda arrays for beamforming applications using

particle
swarm
optimization
algorithm,"
Journal
of
Electromagnetic Waves and Applications, Vol. 22, No. 2{3,
353{364, 2008.
Yang, X. S., B. Z. Wang, and H. L. Liu, \Recongurable Yagi
patch array by utilizing odd-even-mode method," Journal of
Electromagnetic Waves and Applications, Vol. 20, No. 13,
1725,2006.
Teisbaek, H. B. and K. B. Jakobsen, \Koch-fractal Yagi-Uda
antenna," Journal of Electromagnetic Waves and Applications,
Vol. 23, No. 2, 2009.
Kraus J. D., Antenna, 243{248, 2nd Edition, McGraw-Hill, New
York, 1988.
Shiroma, G. S. and W. A. Shiroma, \A two-element L-band quasiYagi array with omnidirectional coverage," IEEE Trans. Antennas
Propag., Vol. 55, No. 12, 3713{3716, Dec. 2007.
Cheng, S., P. Rantakari, R. Malmqvist, C. Samuelsson, T.
Vaha- Heikkila, A. Rydberg, and J. Varis, \Switched beam
antennabased on RF MEMS SPDT switch on quartz substrate,"
IEEE Antennas Wireless Propag. Lett., Vol. 8, 383{386, 2008.
Lim, S. and H. Ling, \Design of electrically small,
patternrecongurable Yagi antenna," Electron. Lett., Vol. 43, No.
24,1326{1327, Nov. 2007.
Honma, N., T. Seki, K. Nishikawa, K. Tsunekawa, and K.
Sawaya,\Compact six-sector antenna employing three intersecting
dualbeam microstrip Yagi-Uda arrays with common director," IEEE,
2010.Trans. Antennas Propag., Vol. 54, No. 11, 3055{3062, Nov.
2006.
Honma, N., T. Seki, and K. Nishikawa, \Compact planar foursector antenna comprising microstrip Yagi-Uda arrays in a
squareconguration," IEEE Antennas Wireless Propag. Lett., Vol.
7,596, 2008.
Lim, S., \Design of a multidirectional, high-gain compact Yagi
antenna," IEEE Antennas Wireless Propag. Lett., Vol. 8, 418,2009.
15Gulshan Sharma, Anand Sharma, Ashish Duvey, P.K.Singhal
Yagi-Uda Antenna For L-Band Frequency Range International
Journal of Engineering and Technology, 1 (4) (2012) 315-320

PB Antenna Design

Uploaded by

Copyright:

Available Formats

PB Antenna Design

Uploaded by

Document Information

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

PB Antenna Design

Uploaded by

Copyright:

Available Formats

G. Sharma, V. Sharma and P. K. Singhal / IJECCT 2013, Vol.

Performance Investigation Of Yagi-Uda Antenna Using

Abstract: This paper is aimed to evaluate the performance

A YagiUda Antenna is a widely used Antenna design due

For a particular operating frequency typical design

Figure 1 - Geometrical design of Yagi Antenna

In case of Yagi-Uda Antenna the boom isolation play a

Freq (in MHz)

The typical cross sectional view of the proposed

There are no simple formulas for designing Yagi-Uda

Figure 2(a) - Yagi-Uda Antenna using cylindrical iron rod as

G. Sharma, V. Sharma and P. K. Singhal / IJECCT 2013, Vol. 3 (2)

Figure 2(b) - Yagi-Uda Antenna using square iron rod as Antenna

All the measurement has been done by using FS-315

Figure 3 - Setup used for measurement.

Figure 4(a) Measured Return Loss of the proposed Antenna

Figure 6: Radiation pattern for the proposed antenna system

G. Sharma, V. Sharma and P. K. Singhal / IJECCT 2013, Vol. 3 (2)

A Yagi-Uda Antenna has been fabricated with two

Chou, H. T., K. L. Hung, and C. Y. Chen, Utilization of a Yagi

of circular Yagi-Uda arrays for beamforming applications using

You might also like