MEGANE

Installation manual:
Parrot MKi + Parrot
CK3100 range

MEGANE 3

The brand
This
document
nameisRENAULT
a tool to MEGANE
assist withIIIthe
andinstallation
the RENAULT
of alogo
Parrot
are product
the property
and isofsupplied
RENAULT.
purely for information. Any installation performed in
compliance
This
document
withis the
onlyinstructions
valid for theappearing
vehicle model
in thisMEGANE
document
IIIisyear
done
2008
under
to 2011,
the sole
excluding
responsibility
all otherofmodels
the installer,
in the same
who isrange
entirely
and responsible
excluding
for the
later
modifications
quality of the
made
installation.
to the vehicle
All rights
by the
reserved
manufacturer.
Copyright 2011 PARROT SA RCS PARIS 394 149 496. May not be reproduced without
the authorisation
The
Parrot brand name
of Parrot
andSA.
logos
Pictures
are the
forexclusive
information
property
only. of Parrot SA.

MEGANE

Fitting time (estimated) / Main features

Disassembly

30min

NO

+APC

Mounting kit

30min

NO

ISO

Refitting

30min

N/A

UNIKA

Testing

15min

FRONT LOUDSPEAKER

TEL mode

Total

1h45min

ALL

MUSIC mode

Tools

Plastic trim removal tools

FACOM / BOJO

-TORX screwdriver
- Cutting pliers
- Crimping pliers
- Multimeter or Test lamp
- Wire tie
- Electrical tape
- Round male terminal

FACOM DX-25 kit (n4 tools)

Accessories required
CK range

MKi range

Photos for illustration purposes

Kram ref.

Dealer ref.

CK range

86795

77 11 428 303

MKi range

84795X795

77 11 428 303

"Please contact your wholesaler to purchase

accessories. List of wholesalers available at
www.certified.parrot.com."

Updating
To get the most out of your hands-free kit, we recommend that you update your software regularly. The
procedure for doing this can be found at http://www.parrot.com/usa/support/downloads
This document is a tool to assist with the installation of a Parrot product and is supplied purely for information. Any installation performed in
compliance with the instructions appearing in this document is done under the sole responsibility of the installer, who is entirely responsible
for the quality of the installation. All rights reserved Copyright 2011 PARROT SA RCS PARIS 394 149 496. May not be reproduced without
the authorisation of Parrot SA. Pictures for information only.

MEGANE

Disassembly

This document is a tool to assist with the installation of a Parrot product and is supplied purely for information. Any installation performed in
compliance with the instructions appearing in this document is done under the sole responsibility of the installer, who is entirely responsible
for the quality of the installation. All rights reserved Copyright 2011 PARROT SA RCS PARIS 394 149 496. May not be reproduced without
the authorisation of Parrot SA. Pictures for information only.

MEGANE

Disassembly 1 / 2

Using the plastic trim tools, unclip

the cover above the glove box

Using the plastic trim tools, unclip

the cover next to the steering wheel

Using the plastic trim tools,

unclip the radio and air
conditioning covers...

...pull it out without

disconnecting, insert the
removal tools into the slots on
each side of the radio

Unlip the radio, pull it carefully,

then remove the removal tools

Pull and lift the radio

disconnecting the connector and
the antenna

This document is a tool to assist with the installation of a Parrot product and is supplied purely for information. Any installation performed in
compliance with the instructions appearing in this document is done under the sole responsibility of the installer, who is entirely responsible
for the quality of the installation. All rights reserved Copyright 2011 PARROT SA RCS PARIS 394 149 496. May not be reproduced without
the authorisation of Parrot SA. Pictures for information only.

MEGANE

Disassembly 2 / 3

Using the plastic trim tools, unclip

the cover located on the right side
of the dashboard

Disconnect the connector for the

passenger air bag trigger

10

Unscrew screw 1 from the glove

box

Unscrew screw 2 from the glove

box

11

12

6
3

Unscrew screws 3, 4 and 5

located above the glove box

Unscrew screw 6 in the glove box

near the light

This document is a tool to assist with the installation of a Parrot product and is supplied purely for information. Any installation performed in
compliance with the instructions appearing in this document is done under the sole responsibility of the installer, who is entirely responsible
for the quality of the installation. All rights reserved Copyright 2011 PARROT SA RCS PARIS 394 149 496. May not be reproduced without
the authorisation of Parrot SA. Pictures for information only.

MEGANE

Disassembly 3 / 3

13

14

Pull the glove box hard to unclip

it, then remove it unplugging the
light connector

9
15

Using the plastic trim tools, unclip

the central air vent assembly

10
16

Remove the assembly without

disconnecting it

17

Using the plastic trim tools,

unclip the cover located on the
left side of the dashboard

18

Remove screws 7 and 8

Using the plastic trim tools,

unclip the headlight adjuster and
disconnect it

This document is a tool to assist with the installation of a Parrot product and is supplied purely for information. Any installation performed in
compliance with the instructions appearing in this document is done under the sole responsibility of the installer, who is entirely responsible
for the quality of the installation. All rights reserved Copyright 2011 PARROT SA RCS PARIS 394 149 496. May not be reproduced without
the authorisation of Parrot SA. Pictures for information only.

MEGANE

Finding an ACC wire 1/2

Remove the large black connector

located under the fuse box, under
the steering wheel

Remove the thin YELLOW wire

from the bottom row of the black
connector

Using a jumper or splice, connect

a wire

Pass the wire under the steering

wheel to the central air vent
assembly

9
3

10
4

Run the wire into the vents

Pass the wire into the glove box

housing

This document is a tool to assist with the installation of a Parrot product and is supplied purely for information. Any installation performed in
compliance with the instructions appearing in this document is done under the sole responsibility of the installer, who is entirely responsible
for the quality of the installation. All rights reserved Copyright 2011 PARROT SA RCS PARIS 394 149 496. May not be reproduced without
the authorisation of Parrot SA. Pictures for information only.

MEGANE

Finding an ACC wire 2/2

On the adapter 86795 or

7711428303, cut the red wire
between the fuse holder and the
ISO connector and connect the
+APC wire

Swap the fuse holders, i.e. the

red and orange wires

On the adapter 84795X795,

reconnect the +APC wire using a
round male terminal

This document is a tool to assist with the installation of a Parrot product and is supplied purely for information. Any installation performed in
compliance with the instructions appearing in this document is done under the sole responsibility of the installer, who is entirely responsible
for the quality of the installation. All rights reserved Copyright 2011 PARROT SA RCS PARIS 394 149 496. May not be reproduced without
the authorisation of Parrot SA. Pictures for information only.

MEGANE

Microphone passage

Using the plastic trim tools, pass

the cable through the headliner
near the rain sensor

Glue the supplied bracket under

the rain sensor cover, after
degreasing

Using the plastic trim tools, run

the cable under the head liner
and down the windscreen post

Run the cable replacing the seal

on the passenger door

Pass the cable into the

dashboard on the right side

Run, and attach with wire ties,

the cable under the dashboard in
the glove box housing

This document is a tool to assist with the installation of a Parrot product and is supplied purely for information. Any installation performed in
compliance with the instructions appearing in this document is done under the sole responsibility of the installer, who is entirely responsible
for the quality of the installation. All rights reserved Copyright 2011 PARROT SA RCS PARIS 394 149 496. May not be reproduced without
the authorisation of Parrot SA. Pictures for information only.

MEGANE

Feeding the accessory cable

In the bottom of the glove box,

insert the cable into the hole next
to the light...

... and bring it out leaving sufficient

length

This document is a tool to assist with the installation of a Parrot product and is supplied purely for information. Any installation performed in
compliance with the instructions appearing in this document is done under the sole responsibility of the installer, who is entirely responsible
for the quality of the installation. All rights reserved Copyright 2011 PARROT SA RCS PARIS 394 149 496. May not be reproduced without
the authorisation of Parrot SA. Pictures for information only.

MEGANE

Fitting the hands-free system 1 / 2

Connect the adaptor to the original connector

and connect all of the wires to the blue box as
shown in the diagram below. Test the assembly
before reassembly then slide all the cables
behind the glove box and attach them with wire
ties

ISO
adapter

This document is a tool to assist with the installation of a Parrot product and is supplied purely for information. Any installation performed in
compliance with the instructions appearing in this document is done under the sole responsibility of the installer, who is entirely responsible
for the quality of the installation. All rights reserved Copyright 2011 PARROT SA RCS PARIS 394 149 496. May not be reproduced without
the authorisation of Parrot SA. Pictures for information only.

MEGANE

Fitting the hands-free system 2 / 2

Pass the cable through the centre

air vent assembly

Bring the wire out in the glove box

housing

!
Glue the support (supplied) after
degreasing the upper left corner
of the vent located on the
dashboard

Re-clip the centre air vent

assembly (ATTENTION do not cut
the screen cable)

12

This document is a tool to assist with the installation of a Parrot product and is supplied purely for information. Any installation performed in
compliance with the instructions appearing in this document is done under the sole responsibility of the installer, who is entirely responsible
for the quality of the installation. All rights reserved Copyright 2011 PARROT SA RCS PARIS 394 149 496. May not be reproduced without
the authorisation of Parrot SA. Pictures for information only.

MEGANE

Testing
Before refitting the system, switch the kit on using the
ignition (or by starting the car). By pushing the central knob
of the remote control, check:
1 - that the menu is displayed on the screen (language or
iPod etc)
2 - that the radio system is muted when the kit is in use (click
in the blue box)

3 - that the sound through all speakers is properly muted

4 - that there is sound through the front speakers for spoken
menus
5 - then turn off the ignition, verify that the kit turns off and
that the message goodbye is displayed on the screen
(otherwise reverse the fuses on the kit power supply
harness)
6 - pair a telephone with the kit and make a call (check that
both the microphone and the kit are working)

This document is a tool to assist with the installation of a Parrot product and is supplied purely for information. Any installation performed in
compliance with the instructions appearing in this document is done under the sole responsibility of the installer, who is entirely responsible
for the quality of the installation. All rights reserved Copyright 2011 PARROT SA RCS PARIS 394 149 496. May not be reproduced without
the authorisation of Parrot SA. Pictures for information only.

MEGANE

Reassembly
Refit the system using the following procedure:
1 - reconnect and replace the radio
2 - replace the glove box by pushing hard (pay attention to the accessory cable)
3 - replace screws 1, 2, 3, 4, 5 and 6 in the glove box
4 - reconnect the passenger airbag selector
5 - refit the right dashboard panel
6 - replace the cover located below the steering wheel by pushing hard
7 - replace screws 7 and 8
8 - reconnect and replace the headlight adjuster
9 - refit the panel on the left-hand side of the dashboard
10 - refit the car stereo and air conditioning surround
11 - replace the steering wheel side cover
12 - replace the cover above the glove box

This document is a tool to assist with the installation of a Parrot product and is supplied purely for information. Any installation performed in
compliance with the instructions appearing in this document is done under the sole responsibility of the installer, who is entirely responsible
for the quality of the installation. All rights reserved Copyright 2011 PARROT SA RCS PARIS 394 149 496. May not be reproduced without
the authorisation of Parrot SA. Pictures for information only.