ETO Entrance Test - Syllabus

Electro-Technical Officer (ETO)
Entrance Exam
SYLLABUS
Total Marks: 100
Duration: 120 minutes
Type : On-line Objective
Level of the Test: Degree level (Electrical and Electronics)
S.NO
1
SUBJECT
General
Concept of Electricity-generation, Transmission, Distribution and utilization,
Electronics and communication.
Principle of direct and alternating current and circuits

Production of direct and alternating current, concept of frequency and wave form,
instantaneous maximum and average values, form factor for sinusoidal wave.
Concept of phase and phase difference.
Re-presentation of alternating quantities by phasors. D.C. and A.C. Circuits, concept
of resistance, inductance, capacitance. Power and power factor. Alternating voltage
applied to resistance and inductance in series and RLC series/parallel circuits,
practical importance of power factor. Simple problems on A.C. Circuits. Concept of
three phase system, star delta connection, voltage and current relationship. Simple
problems.
Electronics
Principle of working of electronic rectifier, full wave and half wave, rectifiers, coarse
and fine controls, relationship between D.C. output and A.C. input voltage, ripple,
effect of capacitor/inductor input filters on the ripple, voltage stabilization by Zener
diode.
Batteries
Arrangement of cells, construction of lead acid batteries and S.M.F. batteries, Ampere
hour and watt. hour efficiency, simple problems. Battery charging and necessary
precautions.
Measuring Instruments
Electrical properties and instruments for their measurement. Working principles and
construction of following measuring instruments including their errors and accuracy.
Simple problems Ammeters, volt meters (moving coil and moving iron type) different
between volt meter and Ammeter. Extension of range of A.C. & D.C. instruments.
Watt meters and energy Meter. Difference between watt meter and energy meter.
Use of multi-meter, ohm meter, megger, earth tester etc.
Air-conditioning
Principle of A.C., Refrigerating, Refrigeration components and controls.
Electric Circuits and Fields

Network graph, KCL, KVL, node and mesh analysis, transient response of dc and ac
networks; sinusoidal steady-state analysis, resonance, basic filter concepts; ideal
current and voltage sources, Thevenins, Nortons and Superposition and Maximum
Power Transfer theorems, two-port networks, three phase circuits.
Gauss Theorem, electric field and potential due to point, line, plane and spherical
charge distributions; Amperes and Biot-Savarts laws; inductance; dielectrics;
capacitance.
Rev: 20052014

Entrance Exam
SYLLABUS
S.NO
8
SUBJECT
Signals and Systems
Representation of continuous and discrete-time signals; shifting and scaling
operations; linear, time-invariant and casual systems; Fourier series representation of
continuous periodic signals; sampling theorem; Fourier, Laplace and Z transforms.
Electrical Machines
Single Phase transformer equivalent circuit, phasor diagram, tests, regulation and
efficiency; three phase transformers connections, parallel operation; auto-transformer;
energy conversion principles; DC machines types, windings, generator
characteristics, armature reaction and commutation, starting and speed control of
motors; three phase induction motors principles, types, performance characteristics,
starting and speed control; Single phase induction motors; synchronous machines
performance, regulation and parallel operation of generators, motor starting,
characteristics and applications; servo and stepper motors.
10
Power Systems
Basic power generation concepts; transmission line models and performance; cable
performance insulation; corona and radio interference; distribution systems; per-unit
quantities; bus impedance and admittance matrices; load flow; voltage control; power
factor correction; economic operation; symmetrical components; fault analysis.
11
Protection and switchgear

Principles of over-current, differential and distance protection; solid state relays and
digital protection; circuit breakers; system stability concepts, swing curves and equal
area criterion; HVDC transmission and FACTS concepts.
12
Control Systems
Principles of feedback; transfer function; block diagrams; steady state errors; Routh
and Niquist techniques; Bode plots; root loci; lag, lead and lead-leg compensation;
state space model; state transition matrix, controllability and observability
13
Electrical and Electronic Measurements

Bridges and potentiometers; PMMC, moving iron, dynamometer and induction type
instruments; measurement of voltage, current, power, energy and power factor;
instrument transformers; digital voltmeters and multimeters; phase, time and
frequency measurement; Q-meters; Oscilloscopes; potentiometric recorders; error
analysis
14
Analog and Digital Electronics

Characteristics of diodes, BJT, FET; amplifiers biasing, equivalent circuit and
frequency response; oscillators and feedback amplifiers; operational amplifiers
characteristics and applications; simple active filters; VCOs and timers;
Combinational and sequential logic circuits; multiplexer; Schmitt trigger; multivibrators; sample and hold circuits; A/D and D/A convertors; 8-bit microprocessor
basics, architecture, programming and interfacing.
15
Power Electronics and Drives

Semiconductor power diodes, transistors, thyristors, triacs, GTOs, MOSFETs and
IGBTs static characteristics and principles of operation; triggering circuits; phase
control rectifiers; bridge converters fully controlled and half controlled; principles of
choppers and inverters; basis concepts of adjustable speed dc and ac drives.
Rev: 20052014

Entrance Exam
SYLLABUS
S.NO
16
17
18
SUBJECT
Electronics and Control Systems
Theoretical knowledge of capacitance, dielectric strength, semiconductor
components, diodes, transistors amplifiers, SCR, UJT, rectifier circuits, thyristors and
their functions and operations
Explain the basics of Control Systems. Explain the terms Open Loop, Closed Loop,
Set Point, Deviation, Offset, Hunting, Negative Feedback. Applications. Different
types of sensors and actuators.
ENGLISH
Sentence Completion
Grammar
Vocabulary
Comprehension
APTITUDE
Qualitative reasoning
Quantitative reasoning
Abstract reasoning
Spatial reasoning
Logical reasoning - ability to draw logical conclusions based on statements or
arguments.
Rev: 20052014

ETO Entrance Test - Syllabus

Uploaded by

Copyright:

Available Formats

ETO Entrance Test - Syllabus

Uploaded by

Document Information

Original Description:

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

ETO Entrance Test - Syllabus

Uploaded by

Copyright:

Available Formats

Electro-Technical Officer (ETO)

Principle of direct and alternating current and circuits

Electric Circuits and Fields

Electro-Technical Officer (ETO)

Protection and switchgear

Electrical and Electronic Measurements

Analog and Digital Electronics

Power Electronics and Drives

Electro-Technical Officer (ETO)

You might also like