Problem Set 4 Physics 201b February 3, 2010. Due Feb 10

1
Problem Set 4 Physics 201b February 3, 2010. Due Feb 10

1. (i) Consider the electrostatic potential V (r) in a region free of charge. (There can of
course be charges outside this region producing the V . Show that V , its average value
over a sphere of any radius R equals V (0), its value at the center . (Note that this
sphere is a mathematical surface and lies within the charge free region. )
(i) One way is to use brute force and show by explicitly averaging over the sphere the
potential due to single charge q located a distance r > R from the center and then
arguing by the superposition principle for the general case of many charges.
Hint: Note that the average of any function over the sphere is
F =
1
F (, )R2 sin dd,
4R2
use the law of cosines to find distances and choose the point charge to lie on the z-axis.
(I have the left the R2 which cancels just so you know where the formula comes from.)
(ii) Now try the clever proof which goes as follows. Consider the potential energy U of
a real nonconducting sphere of radius R with charge Q glued uniformly over its surface
and a charge q at a distance r from the center of the sphere as in Fig. ??. First find
U assuming the sphere is fixed and the point charge is brought in from infinity to a
distance r from its center. Next find the same U by assuming the point charge is fixed
and the sphere is brought from infinity to the same final location. Show that the latter
involves the average of V (r ) ( Figure ??) over the sphere. Equating the U for the two
equivalent procedures will give the desired result.
(iii) Deduce from the above that V cannot have a minimum or maximum in a charge
free region. (Consider a tiny sphere around the supposed maximum or minimum.)
(iv) Show (iii) another way. Suppose r0 is a point of stable equilibrium for a positive
test charge. Which way should E point as you approach r0 from various directions? If
you use Gauss Law what does that imply? This rules out a minimum, what about a
maximum?
2. So far we were used to finding the potential V (r) due to a collection of charges. Given
V () = 0, the answer was unique (just do the sum or integral over (q/(40 r)). But
consider a dierent specification of the problem depicted in Figure ??. It shows a
closed region that contains many conductors (shaded blobs) held at various potentials
V1 , V2 .. , say by connecting them to ground via a batteries of prescribed voltages.
The outermost boundary could even be the sphere at infinity, and it too is at some
potential (V4 ). So we do not know exactly where the charges are, only that in the
end they bring each conductor to the advertised potential. Question: do these data
determine the potential V (r) in the empty region? All we know is that it is required to
agree with the assigned values on the boundary, i.e., on the conductors surfaces and
the surrounding surface. I will help you show that there is a unique V (r) in the empty
space obeying these boundary conditions.
Suppose there are two solutions V1 (r) and V2 (r) obeying these boundary conditions.
Consider their dierence W (r) = V1 (r)V2 (r) and write down the boundary conditions
2
it obeys. Show that these imply W must vanish everywhere in the empty region or
else there will have a maximum or minimum somewhere, which is disallowed by the
pervious result.) Thus V1 (r) = V2 (r) everywhere. This is an example of a uniqueness
theorem.
There are generalizations which show uniqueness persists even if there are charges in
the space between conductors. I just want you to get the flavor, so you understand
why the method of images works.
3. Consider the circuit with a battery of EMF E, connected to a resistor R and an
uncharged capacitor C in series at t = 0. Using the solution for Q(t) and I(t) given
in class show that at any time t > 0, the work done by the battery up to that point
equals the stored energy in the capacitor and energy dissipated in the resistor.
4. Consider a point charge q a distance a along the x-axis from a sphere of radius R as in
Fig. ??. First assume the sphere is grounded. You want to show that q and an image
charge q = (R/a)q at a distance b = R2 /a will make the sphere an equipotential
V = 0.
(i) Show that b = R2 /a and q = (R/a)q are required if we demand V = 0 at two
special points on the sphere: one closest to q and one farthest from q. This does not
mean V will vanish over the entire sphere r = R, but it just does! Show this using the
law of cosines to find distances and the above value of q and b.
(ii) Say in words how you will find the surface charge density. What will it integrate
to over the sphere and why?
(iii) Find the force of attraction between the sphere and q.
(iv) Repeat part (iii) for the case of an isolated and neutral sphere.
(v) Repeat part (iii) for the case of an isolated neutral sphere with charge Q to begin
with.
5. Electrons enter a region of uniform B in the plane perpendicular to B and finish an
orbit in 1s. What is B in Tesla?
6. Find the eective resistance between points A and B in Fig ??. Hint: Apply a voltage
between A and B, assume a current I flows and find V /I.
7. In Fig ?? assume S has been closed for along time. (i) What is the current flowing
through C?(ii) What is the current flowing through R1 and R2 ? (iii) What is the
charge on C? (iv) If S is now opened, describe what will happen. (iv) What will be
the time constant for the charge decay? (v) Now put in numbers for all parts using
V = 9V, R1 = 4k, R2 = 5k, R3 = 1k, C = 100F .
8. Imagine a capacitor made of two hollow conductors, one inside the other, with a capacitance C. (You may imagine they are concentric spheres but they need not be
concentric or spherical for this problem. ) The space between them is filled with a
substance of conductivity . If I connect a battery with voltage V0 between the two,
3
show that the current will be I =
inner conductor.
V0 C
.
0
Hint: Start with J = E at the surface of the
9. The cylindrical rod of length w shown in Fig. ?? carries a current I as shown and is
bathed in a field B perpendicular to the plane in which is a shaped rail. The rod
rolls without slipping on the rails, its length perpendicular to the two parallel rails and
equal to the space between them. It starts at rest and rolls o after going a distance
L. Show that its exit velocity is
v=
4BLIw
.
3M
Notice that the radius of the cylinder is not given. This problem requires you to go
back and look up rolling without slipping and torques.
q
r'
Figure 1: A point charge q and a nonconducting sphere with Q uniformly glued over its
surface. r is the distance from a generic point on the sphere to q.
V_4
V_2
V_1
V_3
Figure 2: A closed region (big outer curve) with some conductors (shaded blobs) at fixed
potentials V1 , ..V4
r
R
q'
(a,0,0)
q
(b,0,0)
Figure 3: A point charge q at a distance a from the conducting sphere of radius R. The
image is q and located at (b, 0, 0).
A
2R
R
R
2R
B
Figure 4: The leads (thick lines) have no resistance, the thin ones have values R and 2R as
shown.
R1
R
2
R3
Figure 5: A two loop circuit with a switch S.
B
w
Figure 6: The rod rolls without slipping.

Problem Set 4 Physics 201b February 3, 2010. Due Feb 10

Uploaded by

Copyright:

Available Formats

Problem Set 4 Physics 201b February 3, 2010. Due Feb 10

Uploaded by

Document Information

Original Description:

Original Title

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

Problem Set 4 Physics 201b February 3, 2010. Due Feb 10

Uploaded by

Copyright:

Available Formats

1

Problem Set 4 Physics 201b February 3, 2010. Due Feb 10

Hint: Start with J = E at the surface of the

Figure 5: A two loop circuit with a switch S.

Figure 6: The rod rolls without slipping.

You might also like