GDJP Unit Joe IV
GDJP Unit Joe IV
GDJP Unit Joe IV
Mx My 1
c x c y a *2
T01
T1
POy
1
POx
1
2
M1
2
9. Show waves cannot develop in subsonic flow ? Why ? (Ms uni ap 96)
In subsonic flow , the velocity of the fluid is less than the velocity of
sound. Due to this section , deceleration is not possible in subsonic flow. So
shockwaves cannot develop in subsonic flow.
10. Give the expression for Ty / Tx across the normal shock. (Mu uni ap
96)
2
1
2
2
M x 1 1
Mx
Ty 1
2
2
Tx
Mx
2
1
2 1
11. Define compression and raifaction shock? Is the latter possible.
(Mu uni
ap 96)
A shock wave which is at a higher pressure than the fliud to which is
moving is called compression shock wave.
A shock wave which is at a lower pressure than the fluid into which it is moving
is called an expansion shock.
12. State the necessary condition for a normal shock to occur in
compression flow. (Bu Nov 96)
1. The compression wave is to be at right angle to the compressible flow.
2. Flow should be supersonic.
13. Write down the Rankine Hugonite equation(Mu Nov 97)
y
x
1 Py
1 Px
1 Py
1 Px
14. Is the flow through a normal shock an equilibrium one. (Mku Nov
97)
No, Since the fluid properties like pressure, temperature and density are
changed during normal shock.
15. Write the static pressure ratio expression for a normal shock. (Bu
Nov 97)
Py
Px
1
2
2
M x
1
1
16. Give the difference between normal and oblique shock(Ms uni Nov
97)
Normal shock
1. Shock wave is right angle to the
flow
Oblique shock
Shock wave is inclined at an angle to
the flow
Two dimension flow
2. One dimension
17.The stagnation pressure -------------------- and static pressure
----------------across a normal shock. (Mu uni oct 95)
ANS: Decreases , Increases
18. What are properties changes across a normal shock? (Mu uni apr
96)
1. Stagnation pressure decreases.
2. Stagnation temperature remains constant.
3. Static temperature and static pressure increases.
19. Calculate the strength of shock wave when normal shock appears
at M=2. (Mu uni apr 99)
py px
px
py
px
M x
1
2
2. Prove that M y
(Bu Nov 97)
2
2
M 1
1 x
3. Derive the static pressure ratio across the shock
Px
1
2
2
Mx
(Au
Py
1
1
Dec 03)
4.Show that strength of shock
6. Derive Rankine Hugonoit Equation ( Density across the shock) (Mku apr
96)
7. Derive stagnation pressure across the shock wave
8. Explain Oblique shock
9. The state of a gas 1.3, R 0.469 KJ / KgK upstream of a normal shock
wave is given by the following data : M x 2.5, Px 2bar , Tx 272 K . Calculate
the mach number, pressure, temperature of the gas downstream of the shock.
[Anna university May 2005]
16. A convergent-divergent nozzle has an exit area to throat area ratio of 2.5.
The total properties of air at inlet are 7 bar and 87 oC. The throuat area is 6.5
cm2.
Determine Mach number, static pressure, static temperature and
stagnation pressure at exit, whe a plane normal shock stands at a point where
the Mach number is 2. Assume Isentropic flow before and after the shock.
[Manonmanium Sundaranar Univ Apr97]
18. A Mach -2 aircraft engine employes a subsonic inlet diffuser of area ration
3. A normal shock is formed just upstream of the diffuser inlet. The freestream conditions of upstream of the diffuser are p 0=0.10 bar, T =300K,
determine
a) Mach number, pressure and temperature at the diffuser exit.
b) Diffuser efficiency including the shock.
Assume isentropic flow in the diffuser downstream of the shock.
[Manonmanium Sundaranar Univ Apr96]
19.An air plane having a diffuser designed for subsonic flight has a normal
shock attached to the edge of the diffuser when the plane is flying at a certain
mach number. If at the exit of the diffuser the mach number is 0.3. what must
be the flight mach number assuming isentropic diffusion behind the shock.
The area at inlet is 0.29 m2 and that exit is 0.44 m2.
20. Air with Mach number 2.5 enters a convergent duct with an area ratio A 2/A1
= 0.5. under certain conditions, normal shock occurs at a point where A/A 1 =
0.6. For this condition, find exit Mach number and pressure ratio across the
duct.
21. A convergent divergent fuct is operating under off design conditions as it
conducts air from a high pressure tank where p 0 = 210 Kpa and T0 = 37oC. A
normal shock is present in the diverging section of nozzle. Find the exit
A
2
A
[Madras Univ Apr 2000 & MSU Apr 96]
ASSIGNMENT IV
Unit-IV
1. Starting from the energy equation for flow through a normal shock obtaine
the following relation. (prandtl meyer relation)
Px
1
2
2
Mx
2. Derive the static pressure ratio across the shock
Py
1
1