Tens User Manual Yk15ab-Ok
Tens User Manual Yk15ab-Ok
Tens User Manual Yk15ab-Ok
1 TENS/EMS device
4 sets of self-adhesive electrode pads 2 inches
4 sets of dual leads wire with dia. 3.5mm plug
3 AAA batteries
Acupuncture Points Chart
User Manual
Warranty Card
Pads holder
Gift box
Troubleshooting:
PROBLEM
CAUSE
This is normal.
Different areas of
your body will react
differently.
Battery is low
SOLUTION
Precautions:
1)
2)
3)
4)
Contraindications:
Warnings:
1)
2)
3)
4)
5)
6)
7)
5)
6)
7)
8)
9)
Safety of this device for use during pregnancy has not been established.
Caution should be used for patients with suspected or diagnosed heart
problems.
Caution should be used for patients with suspected or diagnosed epilepsy.
Caution should be used in the presence of the following:
a. When there is a tendency to hemorrhage following acute trauma or
facture
b. Following recent surgical procedures when muscle contraction may
disrupt the healing process;
c. Over the menstruating or pregnant uterus;
d. Over areas of the skin which lack normal sensation.
Some patients may experience skin irritation or hypersensitivity due to the
electrical stimulation or electrical conductive medium. The irritation can
usually be reduced by using an alternate conductive medium, or alternate
electrode placement.
Electrode placement and stimulation settings should be based on the
guidance of the prescribing practitioner.
The device should be kept out of the reach of children.
The device should be used only with the leads and electrodes
recommended for use by the manufacturer.
This device should not be used while driving, operating machinery, or
during any activity in which involuntary muscle contractions may put the
user at undue risk of injury.
You should stop using the device and consult with your physician if you
experience any adverse reactions from the device.
Manufacturers Warranty
KNEADING
ACUPUNCTURE
Mode Descriptions:
We suggest that you initially experiment using each of the 15 modes. The
mode or combination of modes that gives you the most desirable sensations
and comfort is the most appropriate one to use for your current therapy
session. Adjust the intensity as needed for each mode.
15 . Modes:
P1: Neck
P2: Shoulder P3: Back
P4: Elbow
P5: Hip
P6: Ankle
P7: Knee
P8: Hand/Foot P9: Wrist
P10: Knead
P11: Acupuncture P12: Tapping P13: Cupping P14: Scraping P15: Random
Make sure your skin has been cleaned of all dirt, oil, or lotions.
When preparing to apply the electrode pads make note that putting a
few drops of tap water on your fingers and rubbing them onto the
electrode pads will help them maintain their adhesiveness.
When your current session is complete, always turn the device off
before the removal of the electrode pads from your body or before
unplugging any of the lead-wires.
Once the device is off, you may then remove the electrode pads &
Place the protective film back on the pads or place the pads on
TAPPING
CUPPING
SCRAPING
Press the wire plug firmly to the output port at the top of the unit
Connect the electrode pads to the electrode wire by inserting pins to the
female pin electrodes;
Remove the protective film and place the electrode pads on the targeted
area, making sure that both pads are on the skin and not overlapping;
Turn on the unit via the on/off switch; it will automatically start from mode 1;
Change the modes by pressing one of the 15 different mode buttons
Features:
To Control your A1/A2 ports use the intensity buttons located on the left
hand side of the device. Gradually increase the intensity by pressing
intensity (+) button for the channel A in use; to decrease the strength,
press the () button for the channel A in use;
To control your B1/B2 ports use the intensity buttons located on the righthand side of the device. Gradually increase the intensity by pressing
intensity (+) button for the channel B in use; to decrease the strength,
press the () button for the channel B in use;
Intensity should be set at a level where you will experience some
muscular vibration and involuntary muscle movements. It should be set to
give a comfortable treatment. The treatment should not be painful;
Default timer: 80 minutes. However, you may treat yourself as long as you
like;
Gradually increase the frequency by pressing speed (+) button for the
channel in use; to decrease the speed, press the () button for the
channel in use;
To Control your A1/A2 ports use the speed buttons located on the front of
the device. To control your B1/B2 ports, use the speed buttons located
on the front of the device;
Frequency of the treatment should be at least one to three sessions every
day initially, to get the most effective therapy. However, you may treat
yourself as often as you like;
Enjoy the unlimited soothing therapy anytime & anywhere you desire.
HealthmateForever
TENS EMS unit
YK15AB
www.HealthmateForever.com