www.FirstRanker.com www.

FirstRanke

Code No: ZO422/R07 Set No. 1

I B.Tech Supplementary Examinations, December 2012
NETWORK ANALYSIS
( Common to ECE,EIE,BME,E.Con.E,ETE and ECC)
Time: 3 hours Max Marks: 80
Answer any FIVE Questions
All Questions carry equal marks

1. (a) Compare lumped circuits with distributed circuits.

(b) Determine the equivalent resistance between the terminals A and B in the
circuit shown in figure 1. All the resistances are in Ohms. [4+12]

e r
n k
R a
r s t Figure 1

i
2. The resistor R in series with capacitance C is connected to a 50Hz, 240 V supply.

F
Find the value of C so that R absorbs 300 watts at 100 volts. Find also the
maximum charge and the maximum stored energy in C. [16]

3. A three phase balanced delta connected load of (4 +j8) is connected across a

400 V, 3 phase balanced supply. Determine the phase currents and line currents.
Assume the phase sequence to be RYB. Also calculate the power drawn by the
load. [16]

4. Draw the oriented network graph from the incidence matrix given below. [16]
Nodes Branches
1 2 3 4 5 6
A -1 0 0 +1 -1 0
B +1 -1 0 0 0 -1
C 0 +1 -1 0 +1 0
D 0 0 +1 -1 0 +1

5. Find Va using Super position principle in the circuit shown in the figure 5. [16]

1 of 2
www.FirstRanker.com
www.FirstRanker.com www.FirstRanke

Code No: ZO422/R07 Set No. 1

Figure 5
6. For the two port network shown in the figure 6, the currents I1 and I2 entering at
port 1 and 2 respectively are given by the equations.
I1 = 0.5 V1 - 0.2 V2
I2 = -0.2V1 + V2

e r
n k
R a
s t Figure 6
Where V1 and V2 are the port voltages at port 1 and 2 respectively. Find the Y,

r
Z, ABCD parameters for the network. Also find its equivalent network. [16]

source.
i
7. Derive an expression for the current response in RL series circuit with a sinusoidal

F
8. (a) Design a constant K low pass filter for R = 600 and fc = 1kHz and obtain
its characteristics.
[16]

(b) Draw the equivalent circuit of a crystal and explain how it can be used as a
filter. [8+8]

2 of 2
www.FirstRanker.com
www.FirstRanker.com www.FirstRanke

Code No: ZO422/R07 Set No. 2

I B.Tech Supplementary Examinations, December 2012
NETWORK ANALYSIS
( Common to ECE,EIE,BME,E.Con.E,ETE and ECC)
Time: 3 hours Max Marks: 80
Answer any FIVE Questions
All Questions carry equal marks

1. Three resistors 8 ohms, 6 ohms and 10 ohms are connected in series to a battery of
terminal voltage 24 volts. Find the current in the circuit, P.D. across each resistor
and power dissipated in each resistor. [16]

2. The combined inductance of two coils when connected series is 1H or 0.2 H depend-
ing on the relative directions of the currents in the coils. If the self inductance of

r
one of the coils when isolated is 0.2 H, calculate the self inductance of the other
coil and the mutual inductance between them. Derive the expression used. [16]

k e
3. (a) Define half power frequency. Draw a sketch and explain.
(b) Derive the formula for half power frequencies. [6+10]

a n
4. For the network shown in figure 4, draw the oriented graph, select a tree and obtain
a tie-set matrix. Write down the KVL equations from the tie-set matrix.

s t R [16]

i r
F Figure 4
5. (a) State and explain Thevenins Theorem.
(b) What are the limitations of Thevenins Theorem.
(c) Explain the steps to apply Thevenins Theorem and draw the Thevenins
equivalent circuit. [6+4+6]

6. For the two port network shown in the figure 6, the currents I1 and I2 entering at
port 1 and 2 respectively are given by the equations.
I1 = 0.5 V1 - 0.2 V2
I2 = -0.2V1 + V2

1 of 2
www.FirstRanker.com
www.FirstRanker.com www.FirstRanke

Code No: ZO422/R07 Set No. 2

Figure 6
Where V1 and V2 are the port voltages at port 1 and 2 respectively. Find the Y,
Z, ABCD parameters for the network. Also find its equivalent network. [16]

7. In a series RC circuit with R = 100, C = 25 F is applied at time, t = 0, an ac

sinusoidal response of V = 200 sin 500t. Assume initial charge on the capacitor is
zero. Find an expression for the transient current. [16]

8. Describe a prototype T section band stop filter. Determine the formula required

m-derived band stop filter.

e r
for designing band stop filter. With suitable sketches explain the advantages of
[16]

n k
R a
r s t
F i

2 of 2
www.FirstRanker.com
www.FirstRanker.com www.FirstRanke

Code No: ZO422/R07 Set No. 3

I B.Tech Supplementary Examinations, December 2012
NETWORK ANALYSIS
( Common to ECE,EIE,BME,E.Con.E,ETE and ECC)
Time: 3 hours Max Marks: 80
Answer any FIVE Questions
All Questions carry equal marks

1. In the circuit as shown in figure 1 find the currents in all the resistors. Also calcu-
late the supply voltage & power supplied by the source. [16]

e r
n k
R a Figure 1
2. A network has two branches in parallel. The branch a has a 5 resistance and

s t
15 capacitive reactance in series. The branch b has 10 resistance and 12
inductive reactance in series. It is fed from 100V, 50 Hz supply. Find

r
F i
(a) branch currents.
(b) Circuit current
(c) Power factor of the circuit
(d) Total active power. [16]

3. Analyse the current relationship and the voltage relationship in a 3 phase star
connected system. Also derive the equation for power in such a system. [16]

4. Draw the graph of the network shown in the figure 4. Obtain a tree thereof. What
is the number of mesh currents required for the network. [16]

Figure 4
5. Verify reciprocity theorem for the voltage V and current I in AB of the network
shown in figure 5. [16]

1 of 2
www.FirstRanker.com
www.FirstRanker.com www.FirstRanke

Code No: ZO422/R07 Set No. 3

Figure 5
6. Compute the open circuit impedance parameters for the circuit shown in figure 6.
[16]

e r
n k
R a Figure 6

r s t
7. In the circuit shown in figure 7, Eg (t) = 2.5 t Volts. What are the values of i(t)
and VL(t) at t = 4 seconds. [16]

F i
Figure 7
8. Design a composite low pass filter to meet the following specifications. The filter is
to be terminated in 500 ohms resistance and it is to have a cutoff of 1000 Hz with
very high attenuation at 1065 and 1250 Hz. [16]

2 of 2
www.FirstRanker.com
www.FirstRanker.com www.FirstRanke

Code No: ZO422/R07 Set No. 4

I B.Tech Supplementary Examinations, December 2012
NETWORK ANALYSIS
( Common to ECE,EIE,BME,E.Con.E,ETE and ECC)
Time: 3 hours Max Marks: 80
Answer any FIVE Questions
All Questions carry equal marks

1. For the figure 1 shown, calculate the equivalent resistance of the following combi-
nation of resistors and also calculate the source current, total power dissipated.
[16]

e r
n k
R a
s t Figure 1
2. Derive expressions for impedance, p.f., current of a RL series circuit supplied with

r
i
ac voltage source. Draw also the phasor diagram. [16]

F
3. A series RLC circuit has an impedance of 40 at a frequency of 200 rad /s. When
the circuit is excited by a 10V source of variable frequency the circuit resonates at
a frequency of 250 rad /s. The current at resonance is 0.5 A and the quality factor
at resonance is 10. Determine the circuit parameters. [16]

4. In the network shown in figure 4 the numerical values of resistances also indicate
the branch numbers. Write the oriented graph of the network. Select a tree with
branches 1, 2, 3 as the tree branches, write tie-set and cut-set schedule.
[16]

Figure 4

1 of 2
www.FirstRanker.com
www.FirstRanker.com www.FirstRanke

Code No: ZO422/R07 Set No. 4

5. Find the Nortons equivalent across the terminals ab as shown in the figure 5. Hence
find current through 10 ohms. [16]

Figure 5
6. The Z - parameters of a two port network are Z11 = 10, Z22 = 20, Z12 = Z21 =
5.

(a) Find the ABCD parameters

e r
(b) Find the equivalent T network.

n k [16]

7. In the circuit shown in figure 7, Eg (t) = 2.5 t Volts. What are the values of i(t)
and VL(t) at t = 4 seconds.

R a [16]

r s t
F i
Figure 7
8. A constant - k high pass filter cuts off at a frequency of 2300 Hz. The resistance of
the load is 500 ohms. Calculate the values of the components used in the filter.
[16]

2 of 2
www.FirstRanker.com