Sleeve
Sleeve
3666324 01-JUN-1998
Service Bulletin
The purpose of the Fuel Injector Sleeve Replacement Kit, Part No. 3163113, is to replace
the fuel injector sleeves of the L10, M11, and N14 engines. This kit makes it possible to
replace the fuel injector sleeves in the heads of the L10, M11, or N14 while the heads are
still installed on the engine. Labels on the tools refer only to the M11 or N14 engines, but all
references to the M11 engine will also apply to the L10 engine. Tools contained in the Fuel
Injector Sleeve Replacement Kit, Part No. 3163113 are listed in Tables 1 through 6.
Additional tools required to properly replace the fuel injector sleeves are listed in Table 7.
Included in the Fuel Injector Sleeve Replacement Kit, Part No. 3163113, and additional
tools, are the following:
Reference Number Part Number Description Quantity
Table 1 3163118 Bore Plug 1
Table 2 3163114 Hydraulic Sleeve Extractor 1
Table 3 3163119 Head Cleaning Tool 1
Table 4 3163122 Head Thickness Gauge 1
Table 5 3163125 Sleeve Seating Tool 1
Table 6 3163135 Sleeve Expansion Tool 1
Table 7 Additional Tools As Required
Special attention must be given to the screw threads of the sleeve extractor tool. The screw
threads must be coated with antisieze and the expansion cam of the expanding collet must
be coated with Lubriplate™.
The cylinder body of the seating tool must have four to five drops of light machine oil placed
in the air fitting.
The shaft threads and the rollers of the sleeve expansion tool should be lubricated with light
machine oil.
Before each use of the tools, verify that the tools are clean of debris.
Removal
CAUTION
WARNING
Do not remove the pressure cap from a hot
engine. Wait until the coolant temperature is
below 50°C [120°F] before removing the
pressure cap. Heated coolant spray or
steam can cause personal injury.
WARNING
Coolant is toxic. Keep away from children
and pets. If not reused, dispose of in
accordance with local environmental
regulations.
WARNING
Do not pull or pry on the fan to rotate the
engine manually. Doing so can damage the
fan blades. Damaged fan blades can cause
premature fan failures that can result in
serious personal injury or property damage.
CAUTION
WARNING
Keep hands clear of the hydraulic actuator
and sleeve puller during removal. Failure to
keep clear can result in injury to personnel.
CAUTION
CAUTION
CAUTION
CAUTION
Installation
CAUTION
CAUTION
CAUTION
Wipe the
NOTE: new premachined
Separate adapters areinjector
used sleeve
on the
(Part M11,
L10, No. 3411410)
and N14 clean
heads. with a clean wiping
cloth.
Install the sleeve seating tool and the
Inspect the head
appropriate seating
adapter steps
into the of thebore
injector injector
and
bore to make sure that all debris
snug the two captive capscrews. has been
removed.
WARNING
Make sure the hammer trigger is in the
locked position prior to installing the remote
air control valve on the hammer. Failure to
do so may allow the hammer to trigger
prematurely, causing damage to equipment
or injury to personnel.
WARNING
The sleeve seating tool is under the
hammer spring pressure. Failure to keep
hands clear of the hammer spring face of
the spring seating tool could result in injury
to personnel.
CAUTION
CAUTION
WARNING
The shaft of the sleeve expanding tool is
under spring tension. Grasp the sleeve
expanding tool firmly during installation or
removal to prevent injury to personnel.