Location via proxy:   [ UP ]  
[Report a bug]   [Manage cookies]                

Bolted Beam Splice: (A) Conventional Splice

Download as docx, pdf, or txt
Download as docx, pdf, or txt
You are on page 1of 11

Beam and column splices It is often required to join structural members along

their length due to the available length of sections being limited and also due to
transportation and erection constraints. Such joints are called splices. Splices have to
be designed so as to transmit all the member forces and at the same time provide
sufficient stiffness and ease in erection. Splices are usually located away from critical
sections. In members subjected to instability, the splice should be preferably located
near the point of lateral restraint else the splice may have to be designed for additional
forces arising due to instability effects. In all cases, the requirements of the code should
be satisfied.

Beam splices Beam splices typically resist large bending moments and shear
forces. If a rolled section beam splice is located away from the point of maximum
moment, it is usually assumed that the flange splice carries all the moment and the web
splice carries the shear. Such an assumption simplifies the splice design considerably.
Where such simplification is not possible, as in the case of a plate girder, the total
moment is divided between the flange and the web in accordance with the stress
distribution. The web connection is then designed to resist its share of moment and
shear

A typical bolted splice is plate connection To avoid deformation associated with


slip before bearing in bearing bolts, HSFG bolts should be used. Usually double-splice
plates are more economical because they require less number of bolts. However, for
rolled steel sections with flange widths less than 200 mm, single splice plates may be
used in the flange.

Column splice Column splices can be of two types. In the bearing type, the faces
of the two columns are prepared to butt against each other and thus transmit the load
by physical bearing. In such cases only a nominal connection needs to be provided to
keep the columns aligned. However, this type of splice cannot be used if the column
sections are not prepared by grinding, if the columns are of different sizes, if the column
carries moment or if continuity is required. In such cases, HSFG bolts will have to be
used and the cost of splice increases. When connecting columns of different sizes, end
plates or packing plates should be provided similar to the beam splice .

Bolted beam splice: (a) Conventional splice


AISC suggested details (9th Ed.) for bolted moment splices have a small gap
between the ends of the beams.
For welded moment splices, both flanges webs of the beams are butted together.

In the original illustration there is a gap at the bolted flange, the bolted web, and the
welded flange.

In the second illustration there is a gap at the bolted flange and the bolted web, but not
at the welded flange.
Steel Beam Bolted Plate Splice Connection Detail Drawing
Beam to Beam Endplate Bolted Splice Connection Detail
Beam to Wide Flange Column Endplate Connection Detail
Steel Column Bolted Splice Extension Connection
references

https://www.structuraldetails.civilworx.com/shop/steel-frame-details/steel-beam-bolted-
plate-splice-connection-detail-drawing/

https://nptel.ac.in/courses/105106112/3_connections/6_beam_column_splices.pdf

https://www.pinterest.ph/pin/498070040036622930/

file:///C:/Users/Comp03/Downloads/ag0310%20(1).pdf

You might also like