Mody Institute of Technology and Science, Lakshmangarh Faculty of Engineering and Technology
Mody Institute of Technology and Science, Lakshmangarh Faculty of Engineering and Technology
Note: 1. Question number 1 is compulsory. Attempt five more questions out of the remaining
seven (Questions 2 through 8) questions.
2. All questions other than question number 1 carry equal marks.
iii) Which of the following is disadvantage of die casting over sand casting?
a) better surface finish b) higher production rates
c) higher melting temperature metals d) mold can be reused
v) Match list I with list II and select the correct answer using codes given below the lists:
List I List II
A. Reaming 1.Smoothing and squaring surface around the hole for proper
seating
B. Counter boring 2. Sizing and finishing the hole
C. Counter sinking 3. Enlarging the end of the hole
D. Spot facing 4. Making the conical enlargement at the end of the hole
Codes:
A B C D A B C D
a) 3 2 4 1 b) 2 3 1 4
c) 3 2 1 4 d) 2 3 4 1
1|Page3
vi) The ratio of the oxygen is to Acetylene in the neutral flame is
a) 2:1 b) 1:2 c) 1:1 d) 3:1
vii) The flux coating of an electric arc electrode has a melting point
a) higher than the metallic core b) lower than the metallic core
c) the same as the metallic core d) the same as the metal being welded
ix) Match list I with list II and select the correct answer using codes given below the lists:
List I (metal forming process) List II (a similar process)
A. Blanking 1. Wire drawing
B. Coining 2. Piercing
C. Extrusion 3. Embossing
D. Cup drawing 4. Bending
Codes:
A B C D A B C D
a) 2 3 4 1 b) 2 3 1 4
c) 3 2 1 4 d) 1 3 4 2
Q.2 i) Describe, stepwise, the procedure of making a mould with a two piece split pattern. [10]
Q.3 i) With neat sketch explain the following operations performed on lathe [12]
a) step turning b) grooving c) knurling d) facing
ii) Identify the parts on the horizontal milling machine shown in figure below. [4]
2|Page3
Q. 4 i) Describe the principle of oxyacetylene gas welding and explain different types of flame
obtained in gas welding. [8]
ii) What is the purpose of coating over the commercial arc welding electrodes? [6]
iii) What are the similarities and differences between consumable and nonconsumable
electrodes? [2]
Q. 5 i) Explain with the help of neat sketches any four types of sheet metal shearing operations. [8]
ii) What is forging? Describe with neat sketch open die forging and closed die forging. [8]
ii) What is an integrated circuit? What are the three major stages in the production of
silicon-based integrated circuits? [6]
ii) Explain with neat sketch wire drawing and spinning operation. [8]
iii) Component shown in the figure below is to be manufactured from workpiece of size 45
mm diameter and 150 mm length. List the various operations involved to make the
component. [4]
3|Page3