Rexroth A10VO
Rexroth A10VO
A10VO, A10VSO
Series 31
3 4
2 5
6
1
7
9
14
13 12 11 10
Port overview
B
L
S
L1
Fig. 13: Port overview A10VO Series 31, SAE flange ports at rear
B
L
X
S L1
Fig. 14: Port overview A10VO/A10VSO Series 31, SAE flange ports at top, opposite at bottom
Connect line Please comply with the following information for the version with adapter (concerns
to pilot pressure controller DRG, DFR/DFR1/DRSC, DFLR).
port with adapter
▶▶ When connecting and tightening the connection line to the pilot pressure
port X, the adapter (1) must be secured with a tightening torque of 20 Nm
(WAF 19). The maximum permissible tightening torque of 45 Nm in the female
thread of the adapter (M14 x 1.5, 12 deep) must not be exceeded.
1
If the adapter (1) is unscrewed from the pilot pressure port X and then screwed
back in again, it must be tightened with a tightening torque of 23 + 2.5 Nm.
For the version without adapter, the pilot pressure port X has an ISO 11926
thread of size 7/16-20 UNF-2B; 11.5 deep.
14 Troubleshooting
Table 14 is intended to help you with troubleshooting. This table is not exhaustive.
Issues may occur in practice that are not listed here.
Only authorized personnel may perform troubleshooting inside a safety area
designated by the machine manufacturer.
Unusual noises Insufficient air bleeding of the hydraulic system Fill the axial piston unit, suction line for the
hydraulic pump and the reservoir
Completely air bleed the axial piston unit and
hydraulic system
Check correct installation position
No or insufficient flow Insufficient air bleeding of the hydraulic system Fill the axial piston unit, suction line for the
hydraulic pump and the reservoir
Completely air bleed the axial piston unit and
hydraulic system
Faulty mechanical drive (for example, defective Contact machine/system manufacturer
coupling)
Drive speed too low Contact machine/system manufacturer
No or insufficient pressure Insufficient air bleeding of the hydraulic system Fill the axial piston unit, suction line for the
hydraulic pump and the reservoir
Completely air bleed the axial piston unit and
hydraulic system
Check correct installation position
Valve and controller vibrate Optimize the adjustment of the axial piston
unit and the pressure limitation in the hydraulic
system
Unstable control signal Contact machine/system manufacturer or Bosch
Rexroth Service
Malfunction in the control devices or the Contact Bosch Rexroth Service
controller