Location via proxy:   [ UP ]  
[Report a bug]   [Manage cookies]                

Simoco TSF2000

Download as pdf or txt
Download as pdf or txt
You are on page 1of 2

T S F 2 0 0 0

TSF2000 VHF/UHF
BASE STATION

The TSF2000 is a range of advanced Base Stations


for Analogue Communications Systems.
The TSF 2025 and 2100 are slim-line, cost effective, high performance Base
Stations for the 21st Century with comprehensive remote control facilities.

High performance in 1RU height,


19”basestation series,
TSF2025:1–25W cont, and
TSF2100: 25–100W cont.
High environmental
specification.
Transmit Duty Cycle 100%, Full Duplex.
Modular construction for low MTTR.
Rack or wall mounted.
Microsoft Windows® based Programming Tool.
DSP controlled, fully programmable.
Five key PMR frequency bands covered (66-520MHz).
Completely compatible with SRM9000 Series of Mobile Radios.
In-built loudspeaker for audio monitoring.
37-way Facilities socket with programmable pin functions.
Two 2/4-wire line connections.
Dual-redundant, speed controlled fans with remote alarms.
Line Signalling, Voting Tones, RSSI.
Local Encode/Decode of CTCSS, DCS, Selcall tones (decode only).
SPECIFICATIONS

T S F 2 0 0 0
General
Channel Bandwidth 12.5kHz, 20kHz or 25kHz selectable per channel
Modulation Freq. F3E (voice) pre-emphasised/flat, or FFSK data (1200 or 2400bps)
Frequency Bands EO: 66–88MHz AC: 136–174MHz R3: 335–400MHz
TU: 400–480MHz UW: 440–520MHz
Stability ±2.0 ppm
Temperature –25°C to +55°C Operating (Full Spec.) –40°C to +80°C Storage
Antenna Connect 2 x 50W female N-type
Environmental IP20 ingress protection, Humidity < non condensing
Inputs/Outputs Engineer’s handset (RJ45 – front panel)
2 x 2/4-wire line audio interfaces (screw terminal)
2 x line audio connections + E&M signalling (RJ45)
Programmable facilities connector (37 way D-type)
RS232 serial connection (9 way D)
Power Connector (5 Pin, 25 D-shell)

Supply Voltage 10.8 to 16.2V DC negative earth (13.65V nominal)


Dimensions 44mm(1RU) High x 433mm Wide x 430mm Deep (Excluding Cables)
– In wall mount 125mm High x 465mm Wide x 470mm Deep
Power Requirement 12VDC Nominal for 25W (additional 24V needed for 100W)
Weight 6.95 kg

Transmitter
Transmit Power 1W to 25W(TSF2025) selectable per channel
25W to 100W (TSF2100) selectable per channel
Tx Current Consumption 25W @ 5.7A (Typical; 20°C, no Engineer’s Handset)
Duty Cycle 100%
Audio Distortion <5% at 1kHz, 60% deviation
Audio Frequency Response +1dB to –3dB of pre-emphasised 300 to 3000Hz of 25kHz channel,
300 to 2550Hz on 12.5kHz channel
Intermodulation >40dB (12.5kHz), 45dB (25kHz)
Hum and Noise >40dB (12.5kHz), 45dB (25kHz)
Transmit Rise Time <25mS

Receiver
Sensitivity Voice: 12dB SINAD for 0.3µVpd for 25kHz channel
Data: typical FFSK performance for <10–2 BER (< 20%MER):
0.3µV – 1200 baud in 12.5kHz & 1200/2400 baud in 25kHz
0.5µV – 2400 baud in 12.5kHz channel
Rx Current Consumption Typical: 1.0A (20°C; no Engineers Handset)
Max: 1.55A (fans & audio on max plus Engineers Handset)
Selectivity >73dB (25kHz), >63dB (12.5kHz)
Intermodulation >70dB attenuation
Audio Response ±3dB of de-emphasised 300–2550Hz for 12.5kHz chan with CTCSS
Audio Output 2Wrms internal monitor speaker
Distortion <5%
Blocking >95dB at ±1Mhz
Hum and Noise >40dB (12.5kHz)
For additional
information onthis and
Local Dealer: other Simoco products
visit our website:
www.simoco.com.au
ComGroup does not accept liability
COM6477D_2

for any error or omissionin this


document.Alldata may be subject
to variation without prior notice.
© ComGroup October 2007

You might also like