QUIZ#2
QUIZ#2
QUIZ#2
Dr. MANIS H KUMAR; 8853951326 ; m k u m ar.e e e @i tbh u .ac.i n DATE 08-01-2019 TIME 0930-1100
RO LL NO . NAME DO B TO B PO B N. O . Q . A.
A
. True
B.
False
2. Determine the frequency at which the maximum power is transferred from the amplifier to
the speaker in the given figure.
A.
1,027 Hz
B.
10,270 Hz
C.
6,330 Hz
D.
63,330 Hz
3. A three-phase -connected generator is driving a balanced load such that each phase
current is 12 A in magnitude. When I θa = 12 30° A, what are the polar expressions for
the other phase currents?
A.
I θb = 12 150° A, I θc = 12 –90° A
B.
I θb = 12 120° A, I θc = 12 30° A
C.
I θb = 12 30° A, I θc = 12 120° A
D.
I θb = 12 90° A, I θc = 12 90° A
4. In a certain Y-Y system, the source phase currents each have a magnitude of 9 A. The
magnitude of each load current for a balanced load condition is
A.3
A
B. 6
A
C. 9
A
D.27
A
5. Two equal-value resistors in series will divide the source voltage equally.
A
. True
B.
False
6. If a transformer has 50 turns in the primary winding and 10 turns in the secondary winding,
what is the reflective resistance if the secondary load resistance is 250 ?
A.
250
B.
25
C.
6,250
D.
62,500
A.
0.0000003
B.
0.0003
C.
3
D.
3,000
A.
250 Hz
B.
2,500 Hz
C.
25,000 Hz
D.
400 Hz
A.
6°
B.
60°
C.
180°
D.
27°
10. Two resistors are in series: a 5.6 k resistor and a 4.7 k resistor. The voltage drop
across the 5.6 k resistor is 10 V. The voltage across the 4.7 k resistor is
A.
8.39 V
B.
10 V
C.
2.32 V
D.0
V
11. In an RC low-pass filter, the output voltage is taken across the resistor and the output lags
the input voltage.
A
. True
B.
False
12. The maximum resistance value for a brown, red, yellow, gold resistor is
A.
126,000
B.
126,600
C.
114,000
D.
132,000
A.
switch
B.
photoconductive cell
C.
thermistor
D.
potentiometer
14. The same signal in Problem 2 is applied to an RC high-pass filter. If the reactance is zero
at the input frequency, the output voltage is
A.
18 V peak-to-peak
B.
zero
C.
9 V peak-to-peak
D.
12.73 V peak-to-peak
A.
increases
B.
decreases
C.
remains constant
D.
is not a factor
A
. True
B.
False
17. When an additional resistor is connected across an existing parallel circuit, the total
resistance
A.
remains the same
B.
decreases by the value of the added resistor
C.
increases by the value of the added resistor
D.
decreases
A.
4 units above the origin on the j axis
B.
4 units below the origin on the j axis
C.
4 units right of the origin on the real axis
D.
4 units left of the origin on the real axis
19. The branch current method is based on Kirchhoff's voltage law and Kirchhoff's current
law.
A
. True
B.
False
A
. True
B.
False