25% 50% 33% 100% Solution: Efficiency of Modulation Is Given by

Q1) The maximum power efficiency of an AM modulator is:
a) 25%
b) 50%
c) 33%
d) 100%
Solution: Efficiency of modulation is given by
⁄ 𝑃 𝜇
𝑃 𝜇
𝜂= = =
𝑃 +𝑃 𝑃 +𝜇⁄ 𝑃 +𝜇
μ=1, the optimum value
𝜂= = × = %
+
Q2) Consider sinusoidal modulation in an AM systems, assuming no

over modulation , the modulation index (µ) when the maximum and
minimum values of the envelope, respectively, are 3V and 1V is
_______
𝑬 𝒂 −𝑬 𝒊 −
Solution: 𝝁 = = = = .
𝑬 𝒂 +𝑬 𝒊 +
Q3) Which of the following analog modulation scheme requires the

minimum transmitted power and minimum channel band-width?
(a) VSB
(b) DSB-SC
(c) SSB
(d) AM
Solution: (C)
Modulation type BW Power
Conventional AM 2 fm Maximum power
DSB SC 2 fm (Less power)
VSB fm + vestige
SSB fm Less & power
So, SSB least power & bandwidth
Q4) A 1 MHz sinusoidal carrier is amplitude modulated by a
symmetrical square wave of period 100 µsec. Which of the following
frequencies will not be present in the modulated signal?
(a)990kHz
(b)1010kHz
(c)1020kHz
(d) 1030kHz
Solution: (C)
Frequency of carrier signal is 𝑴 𝒛= 𝑲 𝒛
Modulation signal is square wave of period 100 μS.
Frequency = × − = 𝑲 𝒛
Since modulation signal is symmetrical square wave it will contain only odd
harmonics i.e. 10 KHz, 30 KHz, 50 KHz -----etc.
Thus the modulated signal has 𝒄± =( ± 𝑲 𝒛)= 𝑲 𝒛&
𝑲 𝒛 𝒄± =( ± 𝑲 𝒛)= 𝑲 𝒛& 𝑲 𝒛
So, 1020 KHz will not be present in modulated signal
Q5) v(t)=5[cos(106πt)-sin(103πt).sin(106πt)] represents:

(a) DSB- suppressed carrier signal
(b) AM signal
(c) SSB signal
(d) Narrow band FM signal
Solution: (d)
( )= 𝐜𝐨𝐬( 𝝅 − / 𝐜𝐨𝐬( − )𝝅 + / 𝐜𝐨𝐬( + )𝝅
Carrier and upper side band are in phase and lower side band is out of phase with
carrier
The given signal is narrow band FM signal
Q6) The average side-band power for the AM signal given above is
(a) 25
(b) 12.5
(c) 6.25
(d) 3.125
Solution: The AM signal was not printed in the question paper so the
question is incomplete and everybody is given 1 mark for this question
Q7) A 10 MHz carrier is frequency modulated by a sinusoidal signal
of 500 Hz, the maximum frequency deviation being 50 KHz. The
bandwidth required. as given by the Carson’s rule is ___________
Solution:
By carson’s rule
𝑾= Δ + ) = ( + . )= 𝑲 𝒛
Q8) In commercial TV transmission in India, picture and speech

signals are modulated respectively
(Picture) (Speech)
(a) VSB and VSB
(b)VSB and SSB
(c) VSB and FM
(d) FM and VSB
Solution: (c)
Note that VSB modulation is the clever compromise between SSB and DSB. Since
TV bandwidth is large so VSB is used for picture transmission. Also, FM is the best
option for speech because of better noise immunity
Q9) In a double side-band (DSB) full carrier AM transmission

system, if the modulation index is doubled, then the ratio of total
sideband power to the carrier power increases by a factor of
____________.
Solution:
The AM system is Double side band (DSB) with full carrier. The expression
for total power in such modulation signal is
𝐸𝑐2 𝜇2 𝐸𝑐2 𝜇2 𝐸𝑐2
𝑃𝑡 = + +
2 4 2 4 2
𝜇
𝑃𝑡 = 𝑃𝑐 + 𝑃𝐶
The second term of the above equation is side band power, thus
𝜇
𝑃 = 𝑃𝐶
𝑃 𝜇
=
𝑃
Now if μ (modulation index) is doubled then 𝑷𝑺 /𝑷 will be 4 times
So, it is factor of 4
Q10) A 4 GHz carrier is DSB-SC modulated by a low-pass message

signal with maximum frequency of 2 MHz. The resultant signal is to
be ideally sampled. The minimum frequency of the sampling impulse
train should be
(a) 4MHz
(b) 8MHz
(c) 8GHz
(d) 8.004GHz
Solutions:
Given
𝒄= 𝒛= 𝑴 𝒛
= 𝑴 𝒛( 𝒂 𝒂 𝒊 𝒂)
Such a signal is amplitude modulated (DSB-SC) i.e. two side bands
( 𝒄+ )&( 𝒄− )
i.e. 4002 & 3998 or 4 MHz = BW
so, min. sampling frequency should be (Nyquist Rate)
option (b) ( 𝒊 )= × = 𝑴 𝒛

25% 50% 33% 100% Solution: Efficiency of Modulation Is Given by

Uploaded by

Copyright:

Available Formats

25% 50% 33% 100% Solution: Efficiency of Modulation Is Given by

Uploaded by

Document Information

Original Description:

Original Title

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

25% 50% 33% 100% Solution: Efficiency of Modulation Is Given by

Uploaded by

Copyright:

Available Formats

Q1) The maximum power efficiency of an AM modulator is:

μ=1, the optimum value

Q2) Consider sinusoidal modulation in an AM systems, assuming no

Q3) Which of the following analog modulation scheme requires the

Q5) v(t)=5[cos(106πt)-sin(103πt).sin(106πt)] represents:

Q8) In commercial TV transmission in India, picture and speech

Q9) In a double side-band (DSB) full carrier AM transmission

Q10) A 4 GHz carrier is DSB-SC modulated by a low-pass message

You might also like