This form is used to inspect ATVs/UTVs before they are deployed. It checks things like engine components, brakes, chassis, tires, lights and physical damage. Any item marked with an asterisk that fails inspection must be repaired before acceptance. Inspectors fill in codes to indicate acceptable or rejected conditions, note mileage/hours, and document any remarks. The equipment vendor and contractor representatives sign off to release the vehicle once passed.
This form is used to inspect ATVs/UTVs before they are deployed. It checks things like engine components, brakes, chassis, tires, lights and physical damage. Any item marked with an asterisk that fails inspection must be repaired before acceptance. Inspectors fill in codes to indicate acceptable or rejected conditions, note mileage/hours, and document any remarks. The equipment vendor and contractor representatives sign off to release the vehicle once passed.
This form is used to inspect ATVs/UTVs before they are deployed. It checks things like engine components, brakes, chassis, tires, lights and physical damage. Any item marked with an asterisk that fails inspection must be repaired before acceptance. Inspectors fill in codes to indicate acceptable or rejected conditions, note mileage/hours, and document any remarks. The equipment vendor and contractor representatives sign off to release the vehicle once passed.
This form is used to inspect ATVs/UTVs before they are deployed. It checks things like engine components, brakes, chassis, tires, lights and physical damage. Any item marked with an asterisk that fails inspection must be repaired before acceptance. Inspectors fill in codes to indicate acceptable or rejected conditions, note mileage/hours, and document any remarks. The equipment vendor and contractor representatives sign off to release the vehicle once passed.
License Plate #: Serial #: Starting Mileage/Hours:
Code: X = Acceptable Condition, R = Rejected Failed Inspection
Inspection Item Code Comments Engine and Fuel: Oil level and filter service Air Filter Clean Drive Belt tight and good condition Radiator, hoses and coolant levels Spark Arrestor * Throttle operational * Choke operational Fuel line hoses and connections * Brakes: Brake levers operational * Brake fluid level adequate * Brake pads, hoses and connections * Chassis: Lubrication Front and Rear gear case levels Steering acceptable * Boot Joints, Axles and Suspension acceptable * Tire wear and inflated properly * Wheel lugs tight * All lights and reflectors acceptable condition * Winch and cable acceptable Physical Damage (Remarks section & identify on picture) License Plate, registration and decals (required) Red Tagged (Out of Service) any safety item indicated by an asterisk (*) Do not accept until corrected.
Remarks: Pre-Use Inspector: Date:
Home Unit: Phone #
Contractor Representative: Date:
Release, No Damage No Claims : Release Mileage/Hours____________
Vendor Initial________
Inspector: Date:
Home Unit: Phone #:
Contractor Representative: Date:
Pre-Use inspection, identify body damage on pictures below
