6EP14362BA10 Datasheet en

Data sheet 6EP1436-2BA10
SITOP PSU300S 24 V/20 A

SITOP PSU300S 20 A Stabilized power supply input: 3 AC 400-500
V output: 24 V DC/20 A
Input
Input 3-phase AC
Rated voltage value Vin rated 400 ... 500 V
Voltage range AC 340 ... 550 V
Wide-range input Yes
Mains buffering at Vin = 400 V
Mains buffering at Iout rated, min. 6 ms; at Vin = 400 V
Rated line frequency 1 50 Hz
Rated line frequency 2 60 Hz
Rated line range 47 ... 63 Hz
Input current
● at rated input voltage 400 V 1.2 A
● at rated input voltage 500 V 1 A
Switch-on current limiting (+25 °C), max. 36 A
I²t, max. 0.9 A²·s
Built-in incoming fuse none
Protection in the mains power input (IEC 898) Required: 3-pole connected miniature circuit breaker 6 ... 16 A
characteristic C or circuit breaker 3RV2011-1DA10 (setting 3 A) or
3RV2711-1DD10 (UL 489-listed, DIVQ)
6EP1436-2BA10 Subject to change without notice

Page 1/4 12/16/2019 © Copyright Siemens
Output
Output Controlled, isolated DC voltage
Rated voltage Vout DC 24 V
Total tolerance, static ± 3 %
Static mains compensation, approx. 0.5 %
Static load balancing, approx. 1 %
Residual ripple peak-peak, max. 150 mV
Spikes peak-peak, max. (bandwidth: 20 MHz) 240 mV
Adjustment range 24 ... 28 V
Product function Output voltage adjustable Yes
Output voltage setting via potentiometer; max. 480 W
Status display Green LED for 24 V OK
Signaling Relay contact (NO contact, rating 60 V DC/ 0.3 A) for "24 V OK"
On/off behavior No overshoot of Vout (soft start)
Startup delay, max. 1.5 s
Voltage rise, typ. 30 ms
Voltage increase time of the output voltage maximum 500 ms
Rated current value Iout rated 20 A
Current range 0 ... 20 A
● Note 24 A up to +45°C; +60 ... +70 °C: Derating 2%/K
Supplied active power typical 480 W
Short-term overload current
● on short-circuiting during the start-up typical 35 A
● at short-circuit during operation typical 35 A
Duration of overloading capability for excess current
● on short-circuiting during the start-up 100 ms
● at short-circuit during operation 100 ms
Parallel switching for enhanced performance Yes
Numbers of parallel switchable units for enhanced 2
performance
Efficiency
Efficiency at Vout rated, Iout rated, approx. 91 %
Power loss at Vout rated, Iout rated, approx. 47 W
Closed-loop control
Dynamic mains compensation (Vin rated ±15 %), 3 %
max.
Dynamic load smoothing (Iout: 50/100/50 %), Uout ± 3 %
typ.
Load step setting time 50 to 100%, typ. 2 ms
Dynamic load smoothing (Iout: 10/90/10 %), Uout ± 3 %
typ.

Setting time maximum 10 ms
Protection and monitoring

Output overvoltage protection protection against overvoltage in case of internal fault Vout < 35 V
Current limitation, typ. 25.5 A
Property of the output Short-circuit proof Yes
Short-circuit protection Electronic shutdown, automatic restart
Enduring short circuit current RMS value
● maximum 7 A
Overcurrent overload capability in normal operation overload capability 150 % Iout rated up to 5 s/min
Safety
Primary/secondary isolation Yes
Galvanic isolation Safety extra-low output voltage Uout acc. to EN 60950-1 and EN
50178, transformer acc. to EN 61558-2-16
Protection class Class I
Leakage current
● maximum 3.5 mA
● typical 1 mA
Degree of protection (EN 60529) IP20
Approvals
CE mark Yes
UL/cUL (CSA) approval cULus-Listed (UL 508, CSA C22.2 No. 107.1), File E197259;
cCSAus (CSA C22.2 No. 60950-1, UL 60950-1)
Explosion protection IECEx Ex nA nC IIC T4 Gc; ATEX (EX) II 3G Ex nAC IIC T4 Gc;
cCSAus (CSA C22.2 No. 213, ANSI/ISA-12.12.01) Class I, Div. 2,
Group ABCD, T4
FM approval -
CB approval Yes
Marine approval ABS, DNV GL
EMC
Emitted interference EN 55022 Class B
Supply harmonics limitation EN 61000-3-2
Noise immunity EN 61000-6-2
environmental conditions
Ambient temperature
● during operation -25 ... +70 °C
— Note with natural convection
● during transport -40 ... +85 °C
● during storage -40 ... +85 °C
Humidity class according to EN 60721 Climate class 3K3, 5 … 95% no condensation
Mechanics

Connection technology screw-type terminals
Connections
● Supply input L1, L2, L3, PE: 1 screw terminal each for 0.5 ... 4 mm² single-
core/finely stranded
● Output +, -: 2 screw terminals each for 0.2 ... 4 mm²
● Auxiliary 13, 14 (alarm signal): 1 screw terminal each for 0.05 ... 2.5 mm²
Width of the enclosure 90 mm
Height of the enclosure 145 mm
Depth of the enclosure 150 mm
Required spacing
● top 40 mm
● bottom 40 mm
● left 0 mm
● right 0 mm
Weight, approx. 1.6 kg
Product feature of the enclosure housing for side-by- Yes
side mounting
Installation Snaps onto DIN rail EN 60715 35x7.5/15
Electrical accessories Redundancy module, buffer module, selectivity module, DC UPS
Mechanical accessories Device identification label 20 mm × 7 mm, pale turquoise
3RT1900-1SB20
MTBF at 40 °C 500 000 h
Other information Specifications at rated input voltage and ambient temperature +25
°C (unless otherwise specified)


6EP14362BA10 Datasheet en

Uploaded by

Copyright:

Available Formats

6EP14362BA10 Datasheet en

Uploaded by

Document Information

Original Title

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

6EP14362BA10 Datasheet en

Uploaded by

Copyright:

Available Formats

Data sheet 6EP1436-2BA10

SITOP PSU300S 24 V/20 A

6EP1436-2BA10 Subject to change without notice

6EP1436-2BA10 Subject to change without notice

Protection and monitoring

6EP1436-2BA10 Subject to change without notice

6EP1436-2BA10 Subject to change without notice

You might also like