Location via proxy:   [ UP ]  
[Report a bug]   [Manage cookies]                
Scribd Logo
Upload

Welcome to Scribd!

  • 300 views

    Pulsed Microwave Technology

    Uploaded by

    bingwazzup
    This document discusses pulsed microwave technology and its ability to generate sounds within a human skull, such as clicks, pops, and buzzing, without the need for a receiver. It describes research from the 1940s onwards showing that low-power microwaves can create audible signals by modulating pulses around certain frequencies. Methods like spread spectrum hopping were also found to allow for encrypted voice-to-skull communication using just microwatts of power per pulse.

    Copyright:

    Attribution Non-Commercial (BY-NC)
    Download as DOC, PDF, TXT or read online from Scribd

    Pulsed Microwave Technology

    Uploaded by

    bingwazzup
    300 views2 pages
    This document discusses pulsed microwave technology and its ability to generate sounds within a human skull, such as clicks, pops, and buzzing, without the need for a receiver. It describes research from the 1940s onwards showing that low-power microwaves can create audible signals by modulating pulses around certain frequencies. Methods like spread spectrum hopping were also found to allow for encrypted voice-to-skull communication using just microwatts of power per pulse.

    Copyright

    © Attribution Non-Commercial (BY-NC)

    Available Formats

    DOC, PDF, TXT or read online from Scribd

    Did you find this document useful?

    Is this content inappropriate?

    This document discusses pulsed microwave technology and its ability to generate sounds within a human skull, such as clicks, pops, and buzzing, without the need for a receiver. It describes research from the 1940s onwards showing that low-power microwaves can create audible signals by modulating pulses around certain frequencies. Methods like spread spectrum hopping were also found to allow for encrypted voice-to-skull communication using just microwatts of power per pulse.

    Copyright:

    Attribution Non-Commercial (BY-NC)
    Download as DOC, PDF, TXT or read online from Scribd
    Download as doc, pdf, or txt
    300 views2 pages

    Pulsed Microwave Technology

    Uploaded by

    bingwazzup
    This document discusses pulsed microwave technology and its ability to generate sounds within a human skull, such as clicks, pops, and buzzing, without the need for a receiver. It describes research from the 1940s onwards showing that low-power microwaves can create audible signals by modulating pulses around certain frequencies. Methods like spread spectrum hopping were also found to allow for encrypted voice-to-skull communication using just microwatts of power per pulse.

    Copyright:

    Attribution Non-Commercial (BY-NC)
    Download as DOC, PDF, TXT or read online from Scribd
    Download as doc, pdf, or txt
    of 2

    Pulsed Microwave Technology

    Pulsed microwave voice-to-skull (or other-sound-to-skull) transmission was


    discovered during World War II by radar technicians who found they could hear
    the buzz of the train of pulses being transmitted by radar equipment they were
    working on. This phenomenon has been studied extensively by Dr. Allan Frey,
    (Willow Grove, 1965) whose work has been published in a number of reference
    books.

    What Dr. Frey found was that single pulses of microwave could be heard by
    some people as "pops" or "clicks", while a train of uniform pulses could be heard
    as a buzz, without benefit of any type of receiver.

    Dr. Frey also found that a wide range of frequencies, as low as 125 MHz (well
    below microwave) worked for some combination of pulse power and pulse width.
    Detailed unclassified studies mapped out those frequencies and pulse
    characteristics which are optimum for generation of "microwave hearing".

    Very significantly, when discussing electronic mind control, is the fact that the
    peak pulse power required is modest - something like 0.3 watts per square
    centimeter of skull surface, and that this power level is only applied or needed for
    a very small percentage of each pulse's cycle time. 0.3-watts/sq cm is about what
    you get under a 250-watt heat lamp at a distance of one meter. It is not a lot of
    power.

    When you take into account that the pulse train is off (no signal) for most of
    each cycle, the average power is so low as to be nearly undetectable. This is the
    concept of "spike" waves used in radar and other military forms of
    communication.

    Frequencies that act as voice-to-skull carriers are not single frequencies, as, for
    example TV or cell phone channels. Each sensitive frequency is actually a range
    or "band" of frequencies. A technology used to reduce both interference and
    detection is called "spread spectrum". Spread spectrum signals usually have the
    carrier frequency "hop" around within a specified band.

    Unless a receiver "knows" this hop schedule in advance, like other forms of
    encryption there is virtually no chance of receiving or detecting a coherent
    readable signal. Spectrum analyzers, used for detection, are receivers with a
    screen. A spread spectrum signal received on a spectrum analyzer appears as just
    more "static" or noise.

    The actual method of the first successful unclassified voice to skull experiment
    was in 1974, by Dr. Joseph C. Sharp and Mark Grove, then at the Walter Reed
    Army Institute of Research. A Frey-type audible pulse was transmitted every
    time the voice waveform passed down through the zero axes, a technique easily
    duplicated by ham radio operators who build their own equipment.

    The sensation is reported as a buzzing, clicking, or hissing which seems to


    originate within or just behind the head. The phenomenon occurs with carrier
    densities as low as microwatts per square centimeter with carrier frequencies
    from 0.3-3.0 GHz. By proper choice of pulse characteristics, intelligent speech
    may be created.

    Dr. James Lin of Wayne State University has written a book entitled:
    Microwave Auditory Effects and Applications. It explores the possible
    mechanisms for the phenomenon, and discusses possibilities for the deaf, as
    persons with certain types of hearing loss can still hear pulsed microwaves (as
    tones or clicks and buzzes, if words aren't modulated on). Lin mentions the
    Sharp and Grove experiment and comments: "The capability of communicating
    directly with humans by pulsed microwaves is obviously not limited to the field of
    therapeutic medicine."

    You might also like