This document summarizes the design of a top-mounted anchor bolt subjected to shear and tension loading. Key details include an anchor diameter of 1/2 inches with an effective embedment length of 8 inches. Allowable stresses are calculated for tension, shear, and combined loading based on material properties and geometry. The anchor design is found to be satisfactory with governing failure modes of anchor yielding in tension and masonry breakout in shear. All calculated allowable stresses are greater than the applied loads.
This document summarizes the design of a top-mounted anchor bolt subjected to shear and tension loading. Key details include an anchor diameter of 1/2 inches with an effective embedment length of 8 inches. Allowable stresses are calculated for tension, shear, and combined loading based on material properties and geometry. The anchor design is found to be satisfactory with governing failure modes of anchor yielding in tension and masonry breakout in shear. All calculated allowable stresses are greater than the applied loads.
This document summarizes the design of a top-mounted anchor bolt subjected to shear and tension loading. Key details include an anchor diameter of 1/2 inches with an effective embedment length of 8 inches. Allowable stresses are calculated for tension, shear, and combined loading based on material properties and geometry. The anchor design is found to be satisfactory with governing failure modes of anchor yielding in tension and masonry breakout in shear. All calculated allowable stresses are greater than the applied loads.
This document summarizes the design of a top-mounted anchor bolt subjected to shear and tension loading. Key details include an anchor diameter of 1/2 inches with an effective embedment length of 8 inches. Allowable stresses are calculated for tension, shear, and combined loading based on material properties and geometry. The anchor design is found to be satisfactory with governing failure modes of anchor yielding in tension and masonry breakout in shear. All calculated allowable stresses are greater than the applied loads.
x Weather or Soil Exposure YES Top or Face Mount Top **Assumed adequate spacing from adjacent anchors to allow no overlap of breakout cones
Anchor Type = headed
Anchor Yield Strength = 60000 psi Anchor Diameter, d b = 1/2 in Anchor Hook Length, e b = 0.00 in **For headed anchor set hook length equal to 0
f' m = 2000 psi
Wall thickness, t = 7.625 in x Top Mounted Anchor Edge Distance, l be = 3.25 in Net Anchor Area, A b = 0.142 in2
Effective Embed. Length, l b = 8.00 in
Loading Shear Force, Vtotal = 500 lbs Offset distance, e = 2.00 in Dist. From C.L. of Bolt To Edge 4.00 in of Ledger, x = Direct Tension Force, Ptotal = 1000 lbs
<<Anchor design is satisfactory. See detailed analysis>>
Detailed Analysis
Check minimum embed.
[TMS 402-13 §1.17.6] lb= 8.00 in > lb_min = min(4db,2 in) = 2.00 in <Satisfactory>
Check minimum cover
[TMS 402-13 §1.16.4.1] covermin= 1.50 in
(for top mounted) t - leb = <Satisfactory>
coveractual= 3.25 in (for face mounted) t - lb =
Total Tension Force Considering Ecc., b af
1300 lbs ***assuming that moment arm is (5/6) of 'd'
Determine Tensile Capacity
h1= 4.75 in s1= 14.62 in A1 = 49.96 in2 2 h2= 3.63 in s2= 13.40 in A2 = 34.15 in
