Professional Documents
Culture Documents
Service Bulletin: Topic: Ident No: Supersedes: Date: Subject: Models Affected
Service Bulletin: Topic: Ident No: Supersedes: Date: Subject: Models Affected
TOPIC: Accessories
IDENT NO: 1-3000
SUPERSEDES: New
DATE: October 15, 2008
SUBJECT: Air Starter Inertia Drive
MODELS AFFECTED: ALL 6 & 12 Cylinder Engines
An Improved air starter inertia drive (P/N 495127) is 2. Remove set screw using a flat head screwdriver,
available for 6 & 12 cylinder VHP engines equipped and pull drive assembly from starter carrier shaft.
with air starter (P/N 214148A). The newly designed
3. Remove spring. This spring fits loosely between
air starter will reduce occurrences of broken pinion
the drive assembly and carrier shaft.
gears. (See Figure 1.)
Drive Installation
1. If removed, install two woodruff keys TDI (P/N 9-
90211-019) on carrier shaft. Verify keys are
properly installed. (See Figure 2.)
2. Install spring between drive cavity and end of
output shaft.
1. Mark position of drive pinion opening relative to 3. Tighten six screws to 190 in-lb. (21.5 N⋅m).
gearbox housing for reference during reassembly.
2. Remove six screws that secure drive housing to
gearbox housing.
3. Pull drive housing from gearbox housing. If drive
housing is too tight, tap it with a soft mallet. (See
Figure 2.)
Removal of Drive Assembly
1. In loaded spring area of drive, remove retaining
ring from set screw slot. (See Figure 2.)
WAUKESHA ENGINE
DRESSER, INC.
Page 1 of 2
WAUKESHA, WI 53188-4999
Service Bulletin No. 1-3000
1 2 3
1) Retaining Ring
2) Set Screw
3) Spring
4) Drive Housing
5) Screw
6) Drive Assembly
7) Woodruff Keys