UNIDAL® Alloy´s Characteristics Alloy EN AW 7019 Type of Alloy heat treatable Temper T651 Surface precision milled, roughness Ra 0.4 µm, foiled on both sides
2) Processing Characteristics Dimensional stability 2–3 Machinability 1 Erodability 1 Weldability (Gas / TIG / MIG / Resistance / EB) 4/1/1/1/3 Corrosion resistance (seawater / weather/ stress cracking) 3/2/4 3) Use at temperatures (max °C long/short terms) 90 / 120 4) Anodising (technical / decorative / hard-) 2/6/1 Polishability 1–2 Etching 1 Contact with food (according to EN 602) no
Tolerances 5) Thickness in [mm] Flatness [mm] Thickness [mm] Width & Length [mm] ≤ 15 ≤ 0.5 +/- 0.1 > 15 ≤ 0.25 +/- 0.1 cuts DIN ISO 2768-1m
Standard Stock Sizes
Plate Dimension [mm] 1,520 × 3,020 in thickness of 8 – 80 mm 8, 10, 12, 15, 20, 25, 30 35, 40, 50, 60, 70, 80 Other dimension upon request
Date: 07.01.2016
1) Typical values at room temperature.
2) Ratings evaluation rating from 1 (very good) to 6 (inapplicable). 3) Without loss of strength after cooling down. 4) Technical anodising only - no warranty towards optical demands. 5) Surface flatness for whole plates is measured with a special, 1 meter long, digital flatness ruler.
UNIDAL® is a registered trademark of CONSTELLIUM Valais AG
