Assignment 04 v2
Assignment 04 v2
A 0C
B 2C
C 4C
D 8C
Question 2
What are the values of the lower fixed point and of the upper fixed point on the Celsius scale?
A -10 110
B 0 20
C 0 100
D 20 100
1
IGCSE PHYSICS 2014+ ASSIGNMENT 04
Question 3
An experiment is set up to find out which metal is the best conductor of heat. Balls are stuck with wax to
make rods made from different metals, as shown in diagram X. The rods are heated at one end. Some of the
balls fall off, leaving some as shown in diagram Y.
Question 4
When a liquid evaporates, some molecules escape from it and its temperature changes.
From where do the molecules escape and what is the effect on the temperature of the liquid?
2
IGCSE PHYSICS 2014+ ASSIGNMENT 04
Question 5
What happens to the average speed of the molecules and to the pressure of the gas in the cylinder as the
temperature rises?
A Falls Falls
B Falls Rises
C Rises Falls
D Rises Rises
Question 6
Food is kept in a cool-box which uses two ice packs to keep it cool. Where should the ice packs be
placed to keep all the food as cool as possible?
Question 7
The diagram shows an electric heater being used to heat a beaker of water and an identical beaker for oil
for several minutes.
3
IGCSE PHYSICS 2014+ ASSIGNMENT 04
The temperature of the water and the temperature of the oil increase constantly. The rise in temperature
of the oil is much greater than that of the water.
Why is this?
Question 8
Evaporation occurs when molecules escape from a liquid surface into the air above it. During this process
the temperature of the liquid falls.
B The molecules left in the liquid have more space to move around
C The molecules move more slowly when they escape into the air
D The molecules with the highest energies escape into the air
Question 9
To mark the lower fixed point of a Celsius scale on a thermometer, the thermometer should be placed in
A pure alcohol
D pure mercury
4
IGCSE PHYSICS 2014+ ASSIGNMENT 04
Question 10
One can is insulated with wool. The temperature of the water in each can is taken every minute for several
minutes. Graphs of the results are plotted.
5
Question 11
The diagram shows a cooling unit in a refrigerator.
B Cold air is a band conductor so heat is not conducted into the refrigerator
[11 marks]
Question 12
……………………………………………………………………………………………………………………………………………………………
……………………………………………………………………………………………………………………………………………………………
[1]
……………………………………………………………………………………………………………………………………………………………
……………………………………………………………………………………………………………………………………………………………
[1]
6
(iii) the density of the iron.
……………………………………………………………………………………………………………………………………………………………
……………………………………………………………………………………………………………………………………………………………
[1]
(b) When concrete roads are made, the concrete is laid in sections, with gaps between the sections.
The gaps are then filled with a soft material, called pitch. This is shown in Fig. 6.1.
……………………………………………………………………………………………………………………………………………………………
……………………………………………………………………………………………………………………………………………………………
[2]
[5 marks]
Question 13
Energy may be transferred from one place to another by means of conduction, convection or
radiation.
[4 marks]
7
Question 14
Some very fine grains of powder are mixed with some water. The powder does not dissolve. A small
drop of the mixture is put on a glass slide and viewed through a microscope.
The powder grains are observed to be moving with a jerky, random motion.
……………………………………………………………………………………………………………… [1]
……………………………………………………………………………………………………………………………………………………………………
……………………………………………………………………………………………………………………………………………………………
……………………………………………………………………………………………………………………………………………………………
[2]
[3 marks]
Question 15
Steam is coming out of a kettle of boiling water. When the steam strikes a cold jug, it makes the jug
wet.
(b) All of the following words are names of things that could happen during a change of state.
State which of these is used to describe what happens to the steam to make the jug wet.
……………………………………………………………………………………………………………… [1]
8
(c) When the steam hits the jug, what happens to the energy stored in the steam?
……………………………………………………………………………………………………………… [1]
[5 marks]
Question 16
(a) (i) In the space below, draw a labelled diagram of the apparatus you would use to measure
the specific heat capacity of a liquid.
[3]
(ii) List the quantities you would need to measure, or previously know, in order to
calculate the specific heat capacity of the liquid.
……………………………………………………………………………………………………………………………………………………………
……………………………………………………………………………………………………………………………………………………………
……………………………………………………………………………………………………………………………………………………………
…………………………………………………………………………………………………………………………………….... [3]
9
Some sea water has a specific heat capacity of 3900J/kgC and a boiling point of 100.6C.
(b) (i) Calculate the energy required to raise the temperature of 0.800kg of this sea water
from 12.0C up to its boiling point. State the equation that you use.
(ii) The energy to raise the temperature in (b)(i) is supplied at the rate of 620W.
Calculate the time taken to raise the sea water to its boiling point.
[12 marks]
Question 17
10
(a) Explain what is meant by the statement: 'the specific latent heat of fusion of ice is 330J/g'.
…………………………………………………………………………………………………………………………………………………………
…………………………………………………………………………………………………………………………………………………………
[1]
(b) A block of ice is taken from a freezer at -25C, placed in a metal container, and heated by a
source of constant power.
The graph in Fig. 4.1 shows how the temperature of the contents of the container changes with
time. At point E on the graph the container is empty.
(i) State what is taking place in the regions of the graph from B to C, and from D to E.
B to C ………………………………………………………………………………………………………
………………………………………………………………………………………………………………
D to E ………………………………………………………………………………………………………
………………………………………………………………………………………………………………
[2]
(ii) Use the information in the table to explain why the line DE is longer than the line BC.
……………………………………………………………………………………………………………………………………………………………
………………………………………………………………………………………………………………………………………………………
[1]
11
(iii) Use the information in the table to explain why the graph is steeper from A to B than from C
to D.
……………………………………………………………………………………………………………………………………………………………
……………………………………………………………………………………………………………………………………………………………
[2]
[6 marks]
Question 18
Alex was asked to explain why hot air rises. This was his answer:
"As the particles gain energy they become less dense than the surrounding particles, which makes
them rise."
……………………………………………………………………………………………………………………………………………………………
……………………………………………………………………………………………………………………………………………………………
[1 mark]
Question 19
Explain how a vacuum flask can keep hot liquids hot and cold liquids cold for long periods of time. In
your answer, explain the following design features:
1. A rubber stopper
2. A vacuum between the walls of the flask
3. A silvered surface
[4 marks]
12
Question 20
(a) Which of the above substances are best for storing energy? Explain your answer.
(b) Making sure you pay attention to the units in the table, calculate the following:
(i) The amount of energy required to raise the temperature of 1.5 kg of apples from
19˚C to 150˚C
(ii) The amount of energy required to raise the temperature of 10 grams of olive oil
from 25˚C to 105˚C
(iii) The mass of apples that releases 400 kJ of energy when they are cooled from 70˚C to
20˚C
13
(c) A litre of water weighs 1kg. How much energy is required to boil 500ml of water from 10˚C?
[15 marks]
Question 21
An IGCSE student is investigating temperature changes when hot water and cold water are mixed.
She is provided with a supply of hot water and a supply of cold water.
3
She pours 100cm of the hot water into a beaker. Record the temperature h of this water, as shown
on the thermometer.
h = …………………………………………… [1]
3
(b) She adds 10cm of the cold water to the beaker of hot water. She briefly stirs the mixture of
hot and cold water and records in Table 2.1 (on the following page) the temperature m of the
3
mixture of hot and cold water. She quickly repeats this five times, adding 10cm of cold water each
3
time, until a total of 60cm has been added. She records the temperature m of the mixture of hot
and cold water at each stage.
(i) Complete the volume column in the table, where V is the total volume of cold water so far
added.
(ii) Complete the column headings in the table.
[2]
14
Table 2.1
V/ m/
78
74
68
63
61
59
(c) Plot the graph of temperature m (y-axis) against volume V (x-axis). Use the graph paper on
the following page. If you are unsure about plotting experimental graphs, please refer to the
Handling Data resource on Canvas.
(d) If this experiment were to be repeated in order to check the results, it would be important to
control the conditions. Suggest two such conditions that should be controlled.
……………………………………………………………………………………………………………
……………………………………………………………………………………………………………
[2]
(e) Suggest a practical precaution that will enable readings in this experiment to be taken as
accurately as possible.
[1]
15
[4]
[10 marks]
16