ASTM
ASTM
ASTM
FACULTY OF ENGINEERING
PRESENTATION ON
BY GROUP A
ASTM D4169-16
ASTM E2018-15
ASTM F3194-16
Standard Guide for Training for Personnel Operating Small Land Off Road
Vehicles (ATV-ROHV Ops Endorsement). This guide establishes the minimum
training requirements, including general and field knowledge, skills, and abilities,
for personnel who operate ATVs or ROHVs as part of their duties.
ASTM D3951-18
ASTM B117-19
This practice covers the apparatus, procedure, and conditions required to create
and maintain the salt spray (fog) test environment. Suitable apparatus which may
be used is described in Appendix X1. 1.2 This practice does not prescribe the type
of test specimen or exposure periods to be used for a specific product, nor the
interpretation to be given to the results. 1.3 The values stated in SI units are to be
regarded as standard. The values given in parentheses after SI units are provided
for information only and are not considered standard. 1.4 This standard does not
purport to address all of the safety concerns, if any, associated with its use. It is the
responsibility of the user of this standard to establish appropriate safety, health,
and environmental practices and determine the applicability of regulatory
limitations prior to use. 1.5 This international standard was developed in
accordance with internationally recognized principles on standardization
established in the Decision on Principles for the Development of International
Standards, Guides and Recommendations issued by the World Trade Organization
Technical Barriers to Trade (TBT) Committee.
ASTM A380/A380M-17
Standard Practice for Cleaning, Descaling and Passivation of Stainless Steel Parts,
Equipment and Systems.
This practice covers recommendations and precautions for leaning, Descaling, and
Passivation of new stainless steel parts, assemblies, equipment, and installed
systems. These recommendations are presented as procedures for guidance when it
is recognized that for a particular service it is desired to remove surface
contaminants that may impair the normal corrosion resistance, or result in the later
contamination of the particular stainless steel grade, or cause product
contamination. The selection of procedures from this practice to be applied to the
parts may be specified upon agreement between the supplier and the purchaser. For
certain exceptional applications, additional requirements which are not covered by
this practice may be specified upon agreement between the supplier and the
purchaser. Although they apply primarily to materials in the composition ranges of
the austenitic, ferritic, martensitic, and duplex stainless steels, the practices
described may also be useful for cleaning other metals if due consideration is given
to corrosion and possible metallurgical effects.
REFERENCES
Archived from the original (http://info.craftechind.com/blog/what-is-astm-
international) on 25 April 2017. Retrieved 1 February 2017.
"Membership" (http://www.astm.org/MEMBERSHIP). ASTM International.
"Detailed Overview" (http://www.astm.org/ABOUT/full_overview.html).
ASTM International.
"ASTM International Board of Directors"
(http://www.astm.org/COMMIT/BOD/ASTM). ASTM International.
"Society Awards"
(http://www.astm.org/MEMBERSHIP/socawards.htm#Award).
Transport Canada use of ASTM
(http://www.tc.gc.ca/tdc/summary/14000/14063e.htm) Archived (http
s://web.archive.org/web/20051119212130/http://www.tc.gc.ca/tdc/summary/
14000/14063e.htm)
webstore.ansi.org/sdo/astm