Indications For Splinting Implant Restorations

Indications for Splinting Implant Restorations: A Clinical
Report
Elana Lowell1, Vicky Evangelidis-Sakellson DDS, MPH2, John Evans DDS3, Francis Oh DDS, MS, MA3
1Class of 2014, College of Dental Medicine, Columbia University, New York, NY
2Professor of Dental Medicine, Division of Operative Dentistry, College of Dental Medicine, Columbia University, New York, NY
3Assistant Professor of Dental Medicine, Division of Prosthodontics, College of Dental Medicine, Columbia University, New
York, NY
Abstract subcutaneous injections of Prolia® (Denosumab). Teeth #18

While the concept of splinting weak dentition is well and #19 presented as implant retained restorations. A
documented and practiced, splinting of dental review of the dental history indicated that #18 and #19
implant-supported prostheses is controversial in modern implants were placed in January 2010, the implants were
dentistry. Some research suggests that splinting implant restored as splinted #18 and #19 likely due to angulation. In
restorations may be advantageous under certain addition, further review revealed that implant fixtures for
circumstances, such as for short or narrow implants, teeth #20 and #22 as well as ?AlloOss? bone grafts were
crown-to-implant ratios greater than 1:1, and angled performed in July and September 2013, respectively. At this
implants. This article reports a case of a patient who point, the amount of bone loss around implant fixture #20
presented to the College of Dental Medicine with narrow was reviewed and diagnosed as ?restorable? by
implants of varying angulations in the position of teeth #18, periodontists. If deemed ?non-restorable,? then the implant
19, 20, and 22. This case details the subsequent restoration fixture would have to be re-implanted, or another restoration
of implants using a splinted rigid FPD. The purpose of option presented to the patient.
sharing this case is to explore the indications and
management of splinting implant restorations. Clinical and radiographic examinations revealed 4 narrow
Nobel Select implants of varying angulations in the positions
Introduction of teeth #18, 19, 20, and 22. Tooth #19 had an open margin
In modern dentistry, the concept of splinting weak dentitions at the interface between the implant and PFM cylinder with a
together to support each other is a well-studied topic that is possible fractured screw (Figures 1, 2).
also commonly practiced. However, as we are relatively
new to implant dentistry in comparison to treating natural
teeth, several in vitro studies have reported conflicting
results for splinting implant units in regard to minimizing the
stress transfer to the restoration and supporting bone.1-4
Initially, the concept of splinting implants originated from
splinting teeth, where the assumption was that joined units
improve the resistance to forces and alter the center of
rotation.3 However, some argue that a concept that works on
natural dentition cannot be transferred directly to implant
dentistry due to differences in mechanics.4 Glantz et al
documented unexpectedly high functional bending moments
on implants on maximum biting and chewing in a Figure 1 Patient radiograph reveals #19 with an open margin at interface
between implant and PFM cylinder
conventional cross-arch splinted restoration. Vigolo and
Zaccaria5 evaluated 144 splinted and non-splinted implants
in 32 patients. The authors found no difference in marginal
bone loss between the two designs.
However, splinting of implants may be indicated for short or

narrow implants, crown-to-implant ratios greater than 1:1,
angled implants, high loading forces, and immediate
function.6-7
Case Report
A 90-year-old female patient was referred to Senior Clinic by
external Periodontist for evaluation of restorative needs. The
patient?s medical history revealed that patient had been
Figure 2 #20 implant fixture with bone loss
diagnosed with osteoporosis and received biannual
___________________________________________________________________________________
? 2016 Columbia Dental Review Volume 19: 2013-2015 11
Indications for Splinting Implant Restorations: A Clinical Report
Clinical Procedure
After gathering of preliminary data, clinical, and radiographic
examinations, it was noted that 1) the fixtures were narrow,
2) the crown-to-implant ratio was greater than 1:1, and 3)
the angulation of the implants was not ideal. After
consultation with periodontists and prosthodontists, the
decision was made to utilize all four implants and splint
them to fabricate a 5-unit FPD (#18-19-20-X-22). It was felt
that this treatment option would distribute forces more
evenly than single tooth supported restorations. A Figures 6, 7 Radiograph and clinical photograph of FPD #18-19-20-X-22
screw-retained design was chosen for accessibility. torqued in
A precise occlusal adjustment was made prior to delivery

An open tray impression was taken of #18, 19, 20, and 22 and torque, to minimize occlusal interference and to
impression copings (Figure 3). A framework was made from maximize correct force distribution. Group function was
noble metal. Upon try-in, the framework had to be sectioned verified for laterotrusion, while anterior-guided posterior
between #18 and #19, and #19 and #20-X-21 for passive disclusion was verified during protrusion. (Figures 8, 9).
sitting (Figure 4). The framework was soldered using GC
pattern resin (Figure 5).
Figure 8 Group-function verified during laterotrusion
Figure 3 Open tray impression copings
Figure 4 Framework sectioned between #18 and #19, and #19 and Figure 9 Anterior-guided posterior disclusion verified during protrusive
#20-X-21 for passive sitting movement
Implant fixtures, especially the ones with exposed surfaces,

are under care of a periodontist, to try to establish and
maintain soft-tissue attachment.
Discussion
A 90-year-old patient came to our clinic after treatment by a
dentist outside the College of Dental Medicine. Her
treatment plan was largely dictated by her pre-existing
Figure 5 Framework was soldered using GC pattern resin implant fixtures. It was decided that a splinted restoration
would serve the patient better than single-unit implants
A glazed and finished PFM FPD was torqued to 35 N/cm.
given the non-ideal crown-to-root ratio and the size of the
Screw holes were covered with nylon tape and composite.
implants. Splinting of all teeth does pose a challenge in
Occlusion was adjusted to ensure MI, even distribution of
maintenance for most patients, as it is easier to maintain
occlusion on FPD, and composite was out of occlusion
oral hygiene in single fixture restorations.8 Another
(Figures 6, 7).
advantage of non-splinted implants is the elimination of
___________________________________________________________________________________
12 ? 2016 Columbia Dental Review Volume 19: 2013-2015
Indications for Splinting Implant Restorations: A Clinical Report
large prostheses with large quantities of ceramic and metal, clinical study. Clin Oral Implants Res 4: 99-105.
which may reduce the risk of veneer and framework
fracture.5 In addition, it is easier to achieve passive sitting 5. Vigolo P, Zaccaria M (2010) Clinical evaluation of
with non-splinted multiple screw-retained units that reduce marginal bone level change of multiple adjacent implants
static preload forces on implants, and single-unit implants restored with splinted and nonsplinted restorations: a 5-year
are easier to repair than splinted units.2 prospective study. Int J Oral Maxillofac Implants 25:
1189-94.
However, as presented in this case report, when presented
with less than ideal implant fixture placement, splinting 6. Nissan J, Ghelfan M, Gross M, et al (2010) Analysis of
implant fixtures with a rigid FPD may improve the resistance load transfer and stress distribution by splinted and
to forces and alter the center of rotation of the joined units. unsplinted implant supported fixed cemented restorations. J
Among the indications reviewed in introduction, 1) narrow Oral Rehabil 37: 658-62.
implants, 2) crown-to-implant ratios >1:1, and 3) angled
implants were found in the present case. It should also be 7. Clelland NL, Seidt JD, Dias Daroz LG, et al (2010)
noted that the implant fixtures in this case were not splinted Comparisons of strains for splinted and non splinted implant
because of bone loss around #20, as a compromised prostheses using three-dimensional image correlation. Int J
implant with bone loss it not an indication for splinting. Oral Maxillofac Implants 25: 953-9.
Conclusion 8. Norton MR (2006) Multiple single-tooth implant

The utility of splinting implant fixtures is not conclusively restorations in the posterior jaws: maintenance of marginal
established. The following three concepts must be kept in bone levels with reference to implant-abutment microgap.
mind when considering splinting implant fixtures: Int J Oral Maxillfac Implants 21: 777-84.
1. Implant restorations should not be splinted under the

assumption that ?since it worked on nature dentition, it must
work on implants,? since the bio-mechanics are different.
2. Whenever possible, do not splint implant restorations for

a) ease of cleaning, b) minimize bulkiness of porcelain
reducing chance of fracture, c) ease of repair, and d) ease
of passive sitting reducing static preload forces on implants.
3. However, when implant fixtures are not ideally placed,

including a) short or narrow implants, b) crown-to-implant
ratios greater than 1:1, c) angled implants, d) high loading
forces, and e) need for immediate function, then splinting of
implant restoration may be indicated to improve the
resistance to forces and alter the center of rotation of the
joined units.
References
1. Guichet DL, Yoshinobu D, Caputo AA (2002) Effect of
splinting and interproximal contact tightness on load transfer
by implant restorations. J Prosthet Dent 87: 528-35.
2. Brunski JB, Puleo DA, Nanci A (2000) Biomaterials and

biomechanics of oral and maxillofacial implants: current
status and future developments. Int J Oral Maxillofac
Implants 15: 15-46.
3. Faucher RR, Bryant RA (1983) Bilateral fixed splints. Int J

Perio Rest Dent 3: 8-37.
4. Glantz PO, Rangert B, Svensson A (1993) On clinical

loading of osseointegrated implants: a methological and
___________________________________________________________________________________
? 2016 Columbia Dental Review Volume 19: 2013-2015 13
Copyright of Columbia Dental Review is the property of Columbia University College of
Dental Medicine and its content may not be copied or emailed to multiple sites or posted to a
listserv without the copyright holder's express written permission. However, users may print,
download, or email articles for individual use.

Indications For Splinting Implant Restorations

Uploaded by

Copyright:

Available Formats

Indications For Splinting Implant Restorations

Uploaded by

Document Information

Original Title

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

Indications For Splinting Implant Restorations

Uploaded by

Copyright:

Available Formats

Indications for Splinting Implant Restorations: A Clinical

Abstract subcutaneous injections of Prolia® (Denosumab). Teeth #18

However, splinting of implants may be indicated for short or

A precise occlusal adjustment was made prior to delivery

Figure 8 Group-function verified during laterotrusion

Figure 3 Open tray impression copings

Implant fixtures, especially the ones with exposed surfaces,

Conclusion 8. Norton MR (2006) Multiple single-tooth implant

1. Implant restorations should not be splinted under the

2. Whenever possible, do not splint implant restorations for

3. However, when implant fixtures are not ideally placed,

2. Brunski JB, Puleo DA, Nanci A (2000) Biomaterials and

3. Faucher RR, Bryant RA (1983) Bilateral fixed splints. Int J

4. Glantz PO, Rangert B, Svensson A (1993) On clinical

You might also like