(Tri-Nitrate Toluene) ) (: TNT Acid Preparation
(Tri-Nitrate Toluene) ) (: TNT Acid Preparation
(Tri-Nitrate Toluene) ) (: TNT Acid Preparation
com
The acid needed to manufacture explosives can be produced by adding nitrate fertilizer to full strength vinegar. With a simple drug such as
aspirin, the explosive TNT can be produced. The recipe will be sufficient to manufacture several blasting capsules. Increasing the volume 100
Required chemicals:
• mortar
Preparation:
First step:
• Get aspirin
oTake 100 tablets of 325 milligram aspirin. Grind it to a fine powder.
Note:
Some aspirin contains inert ingredients. Test the aspirin first to make sure it will dissolve in hot water. Add
3 crushed tablets to 10 ml of hot water, if all of the selected tablets have dissolved.awhatifNot all of the
solid is dissolved, then the aspirin should be removed from the powder.
Optional step:
Aspirin purification:
To extract aspirin from undissolved solids, take 100 tablets and add them to 100 ml of 91% disinfecting alcohol. Place
the solution in a hot water bath.Do not use fire with alcohol solution(And stir until the tablets dissolve. Make sure
to keep the liquid just below boiling point.
Filter the hot alcohol solution through filter papers, the remaining solid is waste.
Add the alcohol solution to 500 ml of cold water. Put the solution in an ice bath. The pure aspirin will come out of the
solution, filter this solid for use in the second step.
Step Two:
Converting aspirin to salicylic acid:(SA
Make a solution of 250 mL of water and 5 mL of muriatic acid. Add 30 g of pure aspirin to the solution. Place the solution in a hot
water bath, just below boiling, and then dissolve all of the aspirin. Keep heating for another 10 minutes after all the aspirin has been
Third step:
– start of formation of TNT acid:(TNT
- Prepare the nitric solution by adding 50 g of calcium nitrate to 100 ml of full strength vinegar. Heat the mixture just
below boiling until all the compost has dissolved.
While the solution is still warm, add 20 g of the salicylic acid from step two.
- Heat the solution again until all the acid is dissolvedDo not let the solution boil.
Fourth step:
Complement the reaction product to form TNT acid.:(TNT
- Take the solution with the crystals formed in the third step and put them in a hot water bath just below boiling point. keep
the temperature under80M°.
- Once all crystals have been returned to the solution, continue heating and stirring the mixture for another 30 minutes.
Sixth step:
NominateTNT acid)(TNTaFor a pale yellow-brown steel, rinse with cold water. Let it dry overnight in
the open air.
Warning:
• Do not use the flame with alcohol or after the third reaction heating step.
• Do not let TNT acid(TNTIt comes into contact with metals where dangerous reactions can occur.
• save TNT(TNTunder water and dry the powder only when needed.
To contact the Al-Saqri Foundation, contact us on Telegram on this account and send him the word “link”
Sqr100
God is the guardian of success