Pages From 9803-4160-17 - JCB 426, 435, 436, 446 Wheeled Loading Shovel Service Manual
Pages From 9803-4160-17 - JCB 426, 435, 436, 446 Wheeled Loading Shovel Service Manual
Pages From 9803-4160-17 - JCB 426, 435, 436, 446 Wheeled Loading Shovel Service Manual
Powershift Transmission
WG 160, WG 190
F - 73 9803/4160-16 F - 73
Section F - Transmission
Powershift Transmission
WG 160, WG 190
Install Pre-assembled Drive Shaft and Clutches
Fig 83.
Fig 84.
F - 74 9803/4160-16 F - 74
Section F - Transmission
Powershift Transmission
WG 160, WG 190
8 Rotate housing cover 180°. Attach two M20 eyebolts
B and one M16 eyebolt C to the torque converter
case half.
F - 75 9803/4160-16 F - 75
Section F - Transmission
Powershift Transmission
WG 160, WG 190
Fig 87.
F - 76 9803/4160-16 F - 76
Section F - Transmission
Powershift Transmission
WG 160, WG 190
Install Oil Seal Covers 2 Fit output flange 11. Insert O-ring 10 into the gap
between drive flange and shaft.
1 Insert O-rings 16 and 21 into the annular groove of
the oil feed covers 15 and 20 respectively. 3 Secure output flange 11 by means of disc 9 and
screws 8.
2 Fasten covers 15 and 20 by means of nuts/plain
washers 13/14 and 18/19 respectively. Torque limit........................ 46 Nm (34 lbf ft).
Torque limit...................... 23 Nm (17 lbf ft). 4 Secure screws by means of lock plate 7.
Install Output Flanges 5 Repeat steps 1 - 4 for the opposite drive flange
assembly 1,2, 3, 4, 5 and 6.
1 Install shaft seal 12 with the sealing lip facing the oil
chamber.
Fig 88.
F - 77 9803/4160-16 F - 77