1.

Tulip
1. Fold the square in half, diagonally, to make a triangle.

2. Fold the triangle in half.

3. Open the fold you just made and make sure the folded line is facing

upwards.
4.  Fold the points on the base of the triangle upwards as shown.

5. Turn your flower over.

6. Fold back the sides of the flower as shown.

7. Turn your flower over and marvel at your pretty origami creation

2. Whale
1. Start off with a square origami paper

2. Fold along that middle line and you should a triangle and then open it back.

3. Fold right and left sides to meet the crease in the centre

4. Fold the top tip down to meet the middle

5. Fold the entire thing in half

6. Rotate into 90 degrees clockwise and fold along the dash line on left side to

make tail
7. Turn it and mark eyes to make a beautiful whale.

3. Fox
1. Fold the paper in half and then unfold it.

2.  Fold the paper in half the other way.

3.  Fold the top and bottom in along the dotted lines.

4. Fold the paper in half over behind.

5. Open the paper over to the left. Push the paper in the middle down to make

the head.
6.  Turn the model so it’s sitting upright.

7. Fold the side along the dotted line to make the tail.

4. Cat
1. Fold and unfold the paper in half both ways.
2.
Fold the top and bottom corners to the centre.
3. Fold the paper to the centre again along the dotted lines.

4. Unfold the previous two folds.

7. Fold and unfold the sides in and top down along the dotted lines.

8. Make a Petal Fold using the creases from the previous step.

9. Make a Petal Fold using the creases from the previous step.

10. Make two Pleat Folds on the corners to form the ears.

11. Make another Pleat Fold to form the mouth.

12. Fold and unfold the left side of the model down along the dotted line.

13. Fold and unfold the left side of the model down along the dotted line.

14.  Make another Inside Reverse Fold along the dotted line to form the tail.

15. Fold the left side of the model behind along the dotted line.

5. Boat
1. Fold and unfold the paper in half diagonally both ways.

2. Fold the top of the paper down to the centre.

3. Fold the top layer of paper back up along the dotted line

4. Fold the very tip of the paper down along the dotted line.

5.  Fold the paper in half.

6. Fold the paperback along the dotted line on both sides. This is an Outside

Reverse Fold.
7.  Rotate the model so it’s facing the right direction.

6. Swan
1. Fold the paper in half and then unfold it.

2. Fold both sides in to the centre along the dotted lines.

3. Fold the top layers of paper out along the dotted lines.

4. Fold the paper in half bringing the bottom up and behind.

5. Make an Outside Reverse Fold along the dotted line.s

6. Make another Outside Reverse Fold along the dotted lines.

7. Make a Crimp Fold on the head to form the beak and make another Crimp

Fold on the back to form the tail.

2. Fold both sides of the paper in to the centre along the dotted lines.
 3. Turn the paper over.
4. Fold th e top of the paper down along the dotted line.

5. Fold the paper back up along the dotted line.

6. Fold the paper up along the dotted line.

7.  Fold and unfold the paper along the dotted lines.

8. Turn the paper over.

9. Fold the sides of the paper in along the dotted lines.

10. Turn the paper over.

8.Turtle
1. Fo ld the paper in half.

2.  Fold the paper in half again.

3.  Open the paper out over to the right.

4. Squash fold the paper flat.

5. Turn the paper over.

6. Open the paper over to the left and Squash Fold it flat.

7. Fold the sides in along the dotted lines and unfold. Then fold the top down

along the dotted line and unfold.

9. Fold in the sides along the existing creases into a Petal Fold.
10.
 Make a cut along the top flap down to the start of the dotted lines. Then
fold out both sides.
11.
Make a Pleat Fold along the dotted lines.
12. Make an Outside Reverse Fold along the dotted lines.

13. Fold the top flaps of paper out along the dotted lines.

14. Fold the sides and bottom in along the dotted lines.

15. Fold the bottom back out making a Pleat.

16. Turn the paper over.

9.Dog
1. Fold and unfold the paper in half both ways.
2. Fold the 4 corners in towards the centre.
3. Unfold the left corner of paper.
4. Fold the paper in half horizontally.
 5. Open up the top layer of paper along the dotted line.
6. Keep opening up the paper and Squash Fold it flat. Look at the next step to
see how the final fold should look.
7. Fold the top layer of paper up along the dotted line.
8.  Fold both sides of the head in to make ears along the dotted lines.
9. Fold the top layer of paper down along the dotted line.
10. Fold the paper inside the model along the dotted line and repeat
behind.
11.  Rotate the model so it ’s standing upright.
10.Rabbit
1. Fold the paper in half and unfold it.
2. Fold both sides in to the centre along the dotted lines.
3. Fold both sides at the bottom in to the centre along the dotted lines.
4. Pull out the paper trapped inside and fold it flat into a Rabbit Ear Fold on
each side. This gives you a Fish Base.
5.  Fold the top part of the paper down and behind the model.
6. Fold both sides in to the centre along the dotted lines.
7. Fold the top flap of paper up along the dotted line.ss
8. Fold the paper in half bringing the left side behind the model.
9. Make an Inside Reverse Fold along the dotted line.
10. Make another Inside Reverse Fold along the dotted line.
11. Make another Inside Reverse Fold up along the dotted line.
12. Make one more Inside Reverse Fold so the tail isn’t so pointy.
13. Rotate the model about 90 degrees.
14. Make an Outside Reverse Fold on the middle flap of paper.
15. Make another Inside Reverse Fold to complete the head.
16. Open up both ears making them a bit more 3D.
11.Pigeon
1. Fold the paper in half and then unfold it.
2. Fold the paper in half the other way.
3. Fold both layers of paper to the right along the dotted line.
4. Fold the top layer of paper to the left along the dotted line.
5. Fold the model in half down along the dotted line.
6. Fold the top flap of paper up along the dotted line and then repeat on the
other side.
 7. Fold the paper along the dotted line and then unfold it.
8. Make an Inside Reverse Fold using the crease from the previous step.

12.Frog
1. Fold the paper in half sideways to make a rectangle.
2. Fold the corners down and unfold them right away, repeating this for
both top corners of your rectangle.
3. Flip the paper over and fold the top of the paper down at the spot
where the diagonal creases meet. Unfold right away.
4. Flip over once again, and fold the two edges toward you so they
meet e ach other. The top of your rectangle will fold down to form a
triangle.
5. Fold the bottom of the paper up so that its edge meets the bottom of
your triangle. Fold the two corners of the triangle up to form the
"front legs" of the frog.
6. Fold the sides inward to meet at the center.
7. Fold the bottom of the paper upward so its edge touches the bottom
of the "legs," and unfold right away.
8. Insert your fingers into the inside of the flaps, and pull the bottom
corners outward to the sides, so that the bottom edge comes up to
touch the bottom of the "legs."
9. Fold the corners down so they meet at the bottom of the figure.
10. Fold the bottom corners outward to form the "back legs" of the
frog
11. Create a zigzag fold at the bottom of the figure, folding the
bottom half up and then the bottom quarter back down.

13. Long hat

14. Car
1. Fold in half to make a crease and fold back
2. Fold in the dotted lines
3. Fold in half
 4. Pocket fold in the dotted lines
5. Cut with a pair of scissors and tuck in
6. Draw windows and finish it

16.Duck
1. Fold the paper in half and then unfold it.
2. Fold the top and bottom of the paper to the centre along the dotted
lines.
3. Fold the top layers of paper out along the dotted lines.
4. Make a Pleat Fold along the dotted lines behind the model.
5. Fold the paper in half.
6. Fold and unfold the paper along the dotted lines. You’ll use these
creases in a later step.
7. Open the paper back up.
8. Make a Pleat Fold using the creases from step 6.
9. Fold the paper in half.
10. Fold and unfold the paper along the dotted lines. You’ll use these
creases in a later step.
11. Make a Crimp Fold using the creases from the previous step.

17.owl
1.  Fold and unfold the paper in half both ways.
2. Fold the top part of the paper down about a third of the way from the top to
the middle.
3. Fold the bottom of the paper about half of the way between the bottom and
the tip of the triangle at the top.
4. Fold both sides in along the dotted lines.
5. Fold the tip of the paper down to make the beak.

18.Penguin
1. Fold the paper in half and then unfold it.
2. Fold both sides in to the centre along the dotted line.
3. Make two Pleat Folds along the dotted lines.
4. Fold the paper in half bringing the top half behind.
5. Rotate the paper about 45 degrees.
6.  Make an Outside Reverse Fold along the dotted lines.
 7. Make an Inside Reverse Fold along the dotted line.
8.  Inside Reverse Fold the Inside Part again over to the right. 
9. Fold the top flap of paper underneath along the dotted line and then repeat
on the other side.
10. Make a Crimp Fold along the dotted lines.

19.Fish
1. Fold the paper in half both ways and then leave it folded in half.
2. Fold t he paper in half again.
3. Open up the top flap of paper over to the right.
4. Squash Fold this flap of paper flat.
5. Turn the paper over.
6. Open up the top flap of paper over to the left and Squash Fold it flat.
7. Rotate the paper 90 degrees.
8. Fold the top flap of the paper down along the dotted line.
9. Fold the top flap of paper at the bottom up along the dotted line.

20.Crab
1. Fold the paper in half.
2. Fold the paper in half again.
3.  Open up the top flap of paper over to the right.
4. Squash fold this flap flat.
5. Turn the paper over.
6.  Open up the top flap of paper over to the left and Squash Fold it flat.
7. Fold the top two flaps of paper behind along the dotted lines.
8. Turn the paper over.
9. Fold the bottom part of the paper up along the dotted line.
10. Fold the side flaps of paper down along the dotted lines.
11. Turn the paper over.

21.Dino
1. Fold the paper in half diagonally and then unfold it.
2. Fold both sides of the paper to the centre along the dotted lines. This is
a Kite Base.
3.  Fold the paper in half along the existing crease.
4.  Make an Outside Reverse Fold along the dotted line.
 5. Make another Outside Reverse Fold along the dotted line.
6. Make an Inside Reverse Fold along the dotted line to form the head.
7. Make a Crimp Fold at the back to form the tail.
8. Cut along the solid and dotted line to shape the back.
9. Cut out a little rectangle of paper on the bottom to form the legs. Cut
both layers of paper at the bottom.

22.Fruits
1. Fold the paper in half.
2. Fold the to p layer of paper up along the dotted line.
3.  Fold the top layer of paper back behind the model along the dotted
line.
4. Fold the paper in half along the dotted line.
5. Fold the top flap of paper down along the dotted line.
6.  Fold the left flap of paper over to the right on top of the other layers.
7. Fold the top flap of paper to the back of the model along the dotted
line

23.House
1. Fold in half to make a crease
2. Fold to meet the centre line along the crease
3. Fold in the dotted line
4. Fold back
5. Open and flatten
6. Fold in the dotted line
7. Draw a door and window

24.ice cream
1. Fold in half to make a crease and fold back
2. Fold to meet centre line
3. Fold in dotted line
4. Fold backward in the dotted line
5. Turn over
6. Fold in the dotted line turn over
7. Draw checked line in the cone