www.TheGundCompany.

com Wedge Order Form

THE GUND COMPANY

Slot Wedge Specialists | 24-Hour Emergency Service | ISO 9001:2015
Visit us online at www.thegundcompany.com or contact us by phone
at (219) 374-9944 or via email at motors@thegundcompany.com

Order Form: (check one) Topsticks Slot Wedges Fillers

CUSTOMER ______________________________________ PO # _____________________________________

SHIP TO ADDRESS _________________________________ DATE ORDERED ____________________________
________________________________________________ DATE REQUIRED ____________________________
CONTACT _______________________________________ PHONE # __________________________________

PLEASE PROVIDE THE FOLLOWING THICKNESS (T)_________________________________

QUANTITY _______________________________________ WIDTH (W) __________________________________
MATERIAL (Shown Below) ___________________________ TOP WIDTH (W1) ______________________________
________________________________________________ Dim H (If Applicable) __________________________
FIGURE (Shown below) ________________________ LENGTH____________________________________
(Note: Angles measured from horizontal plane) *Corresponding Port City Wedge Detail in RED below

POLYESTER MATERIALS: HIGH-PRESSURE MATERIALS: MAGNETIC MATERIALS:

Class B (130° C) G-9 G-10 Magnohl Magnoval H208
Class B (130° C) GPO-1 TSF ETS GPO-3
Class F (155° C) G-3 G-11
Class F (155° C) N155 H755 EHC
Class H (180° C) N180 EMD200
Class H (180° C) G-11TM G-30 SEMI-CONDUCTIVE MATERIALS:
Class R (220° C) N220 HST2 SG200 Class R (280~) PCGPHT HST2
C109 G-3SC C209 GGBE
SG200 N220

FIGURE 1 FIGURE 2 FIGURE 3 FIGURE 4 FIGURE 5

60° 60° 60° 60°
T A T B T D T F H T E H
FULL
W RAD W .03 W SHARP W FLAT .03 W 30°
RAD RAD

FIGURE 6 FIGURE 7 FIGURE 8 45° FIGURE 9 FIGURE 10

45° 45°
T T G 45° T H T T K 30°
H H
.03 45° .03
W W SHARP W FLAT W RAD W .03
RAD RAD

FIGURE 11 FIGURE 12 30° FIGURE 13 FIGURE 14 DENOTE FIGURE 15

T 30° T N 30° T L T R T
H H
W SHARP W W .03 W W DENOTE
FLAT 30° RAD
RAD

FIGURE 16 FIGURE 17 FIGURE 18 FIGURE 19 FIGURE 20

DENOTE 60° W1
DENOTE
60°
T P T
H
T C H
T J H T

W SHARP 60° W W W FULL W

45°
RAD

*Note: numerous OEM variations of Fig 16 exist. FIGURE 21

67.5°
Please send samples or Indicate angles on the diagram M
T
H
W 45°
REVISION 5/2021