Adjustable Plant Shelf
Adjustable Plant Shelf
Adjustable Plant Shelf
Shelf
Slip-in pegs allow instantaneous adjustment of the main
plant shelf height.
Each shelf is a simple frame with cross-lapped notches that accept notched, drop-in slats that will
form the shelf bottoms while allowing light to pass through to the plants below. The frame corners
have 1/2" diameter peg (E) holes that mate-up with matching hole patterns in the four vertical stiles
(D).
You’ll find that the easiest tool to use when making these cross-laps is the Dado Blade. Set every-
thing to make 3/4" wide dadoes, 1” deep. Use your Rip Fence with a piece of wood attached to its
face to serve as a stop when cutting these laps equidistant from both ends of your shelf slats (C) and
frame sides (A&B).
Assemble the frames with waterproof glue and woodscrews (brass or stainless steel screws are best),
since they won’t rust. Don’t glue in the center slats on each shelf...only the two slats on each shelf
end that attach to the vertical stiles.
Cut the four vertical stiles (D) from 1-1/2” x 1-1/2” stock that’s at least 6” long. Using your Drill
Press, bore the 1/2" peg holes every 8” along their lengths. The top and bottom holes should be 4” in
from either end.
Finally, turn the pegs you’ll be needing for each shelf, then place and assemble each shelf to the
vertical stiles.
Suggested retail price: $25 and up, depending on number of shelves included and wood species used.
Bill of Materials
(dimensions in inches)
A: Front frames (6) 3/4 x 2-1/2 x (length)
B: Side frames (6) 3/4 x 2-1/2 x 17
C: Slats (x) 3/4 x 2-2/2 x 17
D: Vertical stiles (4) 1-1/2 x 1-1/2 x 72
E: Peg blanks (12) 1-1/4 square x 2 long
F: Peg blocks (12) 3/4 x 2 x 1-1/2
Hardware
Brass or stainless wood screws (36) 1-1/2” x #10 (flathead)
Dowel buttons (36) 3/8” dia (for covering screw heads, if preferred)