Physics: University of Cambridge International Examinations International General Certificate of Secondary Education
Physics: University of Cambridge International Examinations International General Certificate of Secondary Education
Physics: University of Cambridge International Examinations International General Certificate of Secondary Education
com
Centre Number Candidate Number Name
1 hour
Candidates answer on the Question Paper.
No Additional Materials are required.
Write your Centre number, candidate number and name on all the work you hand in.
Write in dark blue or black pen in the spaces provided on the Question Paper.
You may use a soft pencil for any diagrams, graphs or rough working.
Do not use staples, paper clips, highlighters, glue or correction fluid.
2
If you have been given a label, look at the
details. If any details are incorrect or 3
missing, please fill in your correct details
in the space given at the top of this page. 4
The students are provided with 100 cm3 of hot water and a supply of cold water at room
temperature.
(a) The thermometer in Fig. 1.1 shows the temperature of the cold water.
Fig. 1.1
.................................................................................................................................... [1]
(b) A student records the temperature of the hot water. He then pours 20 cm3 of the cold
water into the beaker containing the hot water. He records the temperature of the
mixture of hot and cold water and the volume V of cold water added. He then repeats
the process four times until he has added a total of 100 cm3 of cold water. The table
shows the readings.
V/ /
0 80.0
20 58.0
40 48.0
60 40.5
80 34.0
100 29.0
0 20 40 60 80 100
V / cm3
[5]
The theoretical line shows the results expected by the student after calculating the
values of . The student assumed that all the heat lost by the hot water was gained by
the cold water when the cold water was poured into the beaker.
80
/C
70
60
theoretical line
50
experimental line
40
30
0 20 40 60 80 100
V / cm3
Fig. 1.2
The student carried out the experiment with care. Suggest a practical reason why the
experimental line differs from the theoretical line.
..........................................................................................................................................
.................................................................................................................................... [1]
statement .........................................................................................................................
power
source
A B C D
10 20 30 40 50 60 70 80 90
V crocodile
clip metre rule
Fig. 3.1
The student measures the current I in the wire. She then measures the p.d. V across AB,
AC and AD.
AB 0.375 0.95
AC 0.375 1.50
AD 0.375 1.95
(a) Using Fig. 3.1, record in the table the length l of each section of wire. [1]
0.2 0.3
0.1 A 0.4
0 0.5
2 3
1 V 4
0 5
Fig. 3.2
[2]
(c) Calculate the resistance R of the sections of wire AB, AC and AD using the equation
V
R = –– .
I
Record these values of R, to a suitable number of significant figures, in the table. [2]
(d) Complete the column heading for the R column of the table. [1]
(e) Use your results to predict the resistance of a 1.50 m length of the same wire. Show
your working.
clamp
spring
mass
spring
clamp
Fig. 4.1
A 400 g mass m is attached between two springs, displaced a small distance downwards,
and then released so that it oscillates. The time t taken for 10 complete oscillations of the
mass is recorded. The experiment is repeated using values for m of 300 g and 200 g. The
readings are shown in the table below.
T s
m/g t/s T/s ––
m / ––
g
400 9.0
300 7.8
200 6.3
(a) Calculate the period T of the oscillations. T is the time for one complete oscillation.
Enter the values in the table. [2]
T
(b) Calculate and enter in the table the values of — . [2]
m
statement .........................................................................................................................
reason ..............................................................................................................................
.................................................................................................................................... [2]
(d) In this experiment, the mass oscillates rapidly so that it is difficult to take the times
accurately. A technique has been included in this experiment to obtain an accurate
value for the period T. State, briefly, what this technique is and any calculation involved
to obtain the T value.
..........................................................................................................................................
..........................................................................................................................................
.................................................................................................................................... [2]
(e) Another student carried out the same experiment using a wider range of masses.
Suggest why, when the mass was 900 g, it could not oscillate freely.
.................................................................................................................................... [1]
He places the transparent block on a sheet of plain paper, largest face down, and draws a
line round the block. He draws a line to represent an incident ray and places two pins W
and X in the line. Fig. 5.1 shows the outline of the block and the incident ray.
X
A B
D C
Fig. 5.1
(a) On Fig. 5.1, draw a normal to line AB at the point where the incident ray meets the
block. The incident ray is drawn on the diagram. The positions of the two pins W and X
that mark the incident ray are shown. [1]
i = ........................................................ [1]
(c) Draw in the refracted ray with an angle of refraction of 20°. Continue this line until it
meets the line CD. [2]
(d) The ray emerges from the block in a direction that is parallel to the incident ray. Draw in
this emergent ray. [2]
(e) Two pins Y and Z are placed so that the pins W and X, viewed through the block, and
the pins Y and Z all appear exactly in line with each other. Mark on the diagram, with
the letters Y and Z, where you would place these two pins. [2]
BLANK PAGE
0625/06/M/J/05
www.dynamicpapers.com
12
BLANK PAGE
Permission to reproduce items where third-party owned material protected by copyright is included has been sought and cleared where possible. Every
reasonable effort has been made by the publisher (UCLES) to trace copyright holders, but if any items requiring clearance have unwittingly been included, the
publisher will be pleased to make amends at the earliest possible opportunity.
University of Cambridge International Examinations is part of the University of Cambridge Local Examinations Syndicate (UCLES), which is itself a department
of the University of Cambridge.
0625/06/M/J/05