Console Box
Console Box
Console Box
EXTERIOR/INTERIOR TRIM
18.Console Box
A: REMOVAL
1) Remove the console front cover assembly.
• MT model
1. Remove the shift knob.
2. Release the clips and claws, then pull up the console front cover assembly.
(a)
EI-02723
NOTE:
Turn over the front center pocket mat (a) and pull up the console front cover from the slit.
3. Disconnect the harness connector and remove the console front cover assembly.
• AT model
1. Remove the select lever knob.
a. Lower the cover grip AT.
b. Remove the clamp grip pin, then remove the select lever knob.
2. Release the clips and claws, then pull up the console front cover assembly.
(a)
EI-02725
NOTE:
Turn over the front center pocket mat (a) and pull up the console front cover from the slit.
EI-72
Console Box
EXTERIOR/INTERIOR TRIM
3. Disconnect the harness connector and remove the console front cover assembly.
2) Remove the left and right console front side cover assembly.
(1) Remove the screws and release the clip engagings (A) to (D) in order.
(2) Remove the console front side cover assembly by pulling it up.
(C)
(A) (B)
(D)
EI-02638
(C)
(B)
(A)
(D)
EI-02637
EI-73
Console Box
EXTERIOR/INTERIOR TRIM
(2) Remove the screws, disconnect the harness connector and remove the console box assembly.
EI-02602
B: INSTALLATION
Install each part in the reverse order of removal.
Tightening torque:
6.5 N·m (0.66 kgf-m, 4.8 ft-lb)
EI-74