The 

water cycle, also known as the  hydrologic cycle  or the  hydrological cycle, describes the
continuous movement of  water  on, above and below the surface of the  Earth.

Four Main Stages in Water Cycle

Evaporation: This is when warmth from the sun causes water from oceans, lakes, streams, ice and soils to
rise into the air and turn into water vapour (gas). Water vapour droplets join together to make clouds!

Condensation: This is when water vapour in the air cools down and turns back into liquid water.

Precipitation: This is when water (in the form of rain, snow, hail or sleet) falls from clouds in the sky.

Collection: This is when water that falls from the clouds as rain, snow, hail or sleet, collects in the oceans,
rivers, lakes, streams. Most will infiltrate (soak into) the ground and will collect as underground water.

Water is one of the world’s most valuable resources and one that is becoming
increasingly difficult to find in drinkable quality. All water in the world is subject to what is
known as the water cycle, or the hydrologic cycle, or the H2O cycle, which is the
process by which water moves around the world.

Different Stages of the Water Cycle

Water goes through three different stages in the water cycle. It can be a liquid (water), a
gas (water vapor) or a solid (ice). These three states are interchangeable, as water can
freeze into ice or evaporate into water vapor, water vapor can condense as water, and
ice can melt into water. The water cycle consists of a number of steps that see the
water go through each of these states.

1. Evaporation

Water is found in lakes, oceans, swamps, and soil, as well as in all living creatures and
plants. When heat is applied from the sun, through exertion, or by artificial means, the
water molecules become excited and spread out. The loss of density is called
‘evaporation,’ and it sees the water rise into the air forming clouds of water vapor.

Normally, the evaporation of water occurs when the water hits the boiling point, around
one hundred degrees centigrade. However, in places where the air pressure and
humidity are lower, far less heat energy is needed to evaporate the water because there
is less pressure holding the water molecules together. The water that evaporates from
the oceans is not salty, as the salt is too dense and heavy to rise with the water vapor,
which is why water from rivers and lakes is not salty.

Snow and ice can actually turn into water vapor without first turning into water. This
process is called ‘sublimation,’ and it results from low humidity and dry winds. This
usually occurs at the peaks of mountains or other high-up places, as the lower air
pressure means that less energy is needed to sublimate the ice into water vapor.

Some of the highest peaks on the earth, such as Mount Everest, have all of the
necessary components for sublimation, namely: strong sunlight, low temperatures, low
air pressure, strong wind, and low humidity. If you’ve ever seen dry ice, which has a fog
pouting off of it, this is an example of sublimation in action.

When water evaporates off of a plant’s leaves, the process is known as

‘evapotranspiration.’ A large percentage of the water in the atmosphere is produced by
this process due to the large areas covered by plants and trees across the planet. While
about ninety percent of the water vapor in the world comes from lakes, oceans, and
streams, the remaining ten percent is comprised of the various plant life around the
world.

2. Condensation

The water vapor that has risen into the sky cools significantly when it comes into contact
with the cooler air found up high. The vapor becomes a cloud, which is pushed around
the world by moving air currents and winds.

If the water vapor cools to anything above zero degrees centigrade, it will condense as
water. Essentially, the water vapor will start to condense on the surface of tiny particles
of dust and dirt that rose with the vapor during the process of evaporation. These tiny
droplets will start to fall into one another and merge, producing a larger droplet.

When a droplet is large enough, gravity will pull it down at a rate that exceeds the
updraft in the cloud, leading to the droplet falling out of the cloud and onto the ground
below. This process is called ‘precipitation’, or – more commonly – rainfall.

If precipitation occurs in conditions that are particularly cold or have very low air
pressure, then these water droplets can quite often crystallize and freeze. This causes
the water to fall as solid ice, known as hail, or as snow. If the conditions are in between
those associated with snow and rain, the droplets will fall as icy cold, half-frozen water
commonly referred to as sleet.

3. Precipitation

The water that has fallen as rain is absorbed into the ground through a process known
as ‘infiltration.’ Soil and other porous materials can absorb great deals of water this way,
while rocks and other harder substances will only retain a small amount of water.

When the water infiltrates the soil, it will move in all directions until it either seeps into
nearby streams or else sinks deeper into what is known as ‘groundwater storage.’ This
is where the water that does not seep out or evaporate joins up under the ground,
saturating the smallest nooks and crannies of rock and soil under the ground. These
formations are also known as ‘aquifers’ and explain why sometimes the ground
underneath the topsoil is damp or sodden.

When an aquifer becomes too full, it starts to leak out onto the surface, forming what is
known commonly as a ‘spring.’ These can often be found in formations of porous or
brittle rock, which can crack following slightly acidic rainfall. Should the water be located
near a volcano or any source of natural thermal energy, it will form a hot spring.

4. Runoff

After the water has fallen and the soil has become saturated, or the snow has melted,
the water follows gravity and falls down any hills, mountains, or other inclines to form or
join rivers. This process is known as ‘runoff,’ and it is how water comes to rest in lakes
and returns to the ocean. The waterfalls according to the incline of the place from which
it is falling, and when several threads of water meet, they form a stream.

The direction in which the water moves is known as ‘streamflow’, and it is central to the
concept of the currents within rivers and streams. These streams and rivers will run off
eventually to either form lakes or rejoin the ocean, depending on their proximity to the
ocean.

Due to the amount of water stored in snow or ice, a sudden increase in the heat can
lead to flooding due to the water suddenly melting and running off at an alarming rate.
This is why flooding can occur so easily during a warm spring following a particularly
cold and biting winter.

When more snow falls than evaporates or sublimates, the ice will compact densely to
form what is known as ‘ice caps.’ The ice caps and glaciers located in the coldest
regions of the world are the biggest collections of ice in the world, and are slowly
starting to shrink as the water in which they sit is becoming warmer.

This happens in a cyclical manner, with no beginning or end. As precipitation happens

in one part of the world, evapotranspiration is happening somewhere else. The cycle of
water never ends, which is why the oceans stay level, there are always clouds
somewhere in the sky, and drinkable water doesn’t suddenly just run out.

At some point, any water that has infiltrated will be released, any that has joined the
ocean will evaporate, and even a large portion of the ice caps may melt, releasing water
that has been stored for millions of years back into the water cycle with potentially
cataclysmic effects.

The Importance of the Water Cycle

1. We cannot live without freshwater

All life is dependent upon water. Water makes up 60 to 70 percent of all living matter,
and humans cannot live without drinking water for more than a week. The water cycle is
an extremely important process because it enables the availability of water for all living
organisms and regulates weather patterns on our planet. If water didn’t naturally recycle
itself and distribute freshwater all over the earth’s surface, we would run out of clean
water, which is essential to life.

Freshwater seems abundant, but when accounting for all the water on Earth, it’s in
limited supply. Just three percent of the water on our planet is freshwater. A majority of
this water, about two percent of the world total, is contained in glaciers and ice sheets or
stored below ground. The remaining one percent is found in lakes, rivers and wetland
areas or transported through the atmosphere in the form of water vapor, clouds and
precipitation.

2. Purification

Evaporation and infiltration benefit human, animal and plant life by purifying water.
When water evaporates, the pollutants and sediments in it are left behind. As water
undergoes infiltration, the ground purifies it of pollutants and contaminants. Glaciers,
ice, and snow can act as stores of freshwater for both humans and other organisms.
Even aquatic life needs water purified, as saltwater must be within certain pH and saline
ranges.

3. Distribution

Perhaps most important, the water cycle distributes water all over the earth’s surface,
though unevenly. This is important because if water was not distributed, gravity would
push it all into the lowest place, the oceans. The water cycle continually feeds
freshwater to all life on the planet: humans, animals and plants. Runoff contributes to
rivers, other freshwater bodies, and eventually, the ocean, sustaining freshwater and
marine life.

4. Water Cycle Sustains Life

Plants wouldn’t grow without precipitation and therefore anything consuming the plants
wouldn’t survive and so forth. The water cycle process sustains life and creates the
ecosystems around us. Some organisms are very sensitive to changes in the water
cycle. A prolonged drought can destroy a population of plants or a certain salamander
species may require a set amount of soil saturation in order to avoid desiccation.

5. The Water Cycle Drives Biogeochemical Cycle

The water cycle patterns and rainfall have major effects on Earth’s ecosystems. Rainfall
and surface runoff play important roles in the cycling of various elements, also known as
the biogeochemical cycle.

In ecology and Earth science, a biogeochemical cycle or substance turnover or cycling

of substances is a pathway by which a chemical substance moves through biotic
(biosphere) and abiotic (lithosphere, atmosphere, and hydrosphere) compartments of
Earth.

These include calcium, carbon, hydrogen, mercury, nitrogen, oxygen, phosphorus,

selenium, and sulfur, molecular cycles for water and silica. In particular, surface runoff
helps move elements from terrestrial, land-based, to aquatic ecosystems.

6. Effects on Climate

The water cycle is powered from solar energy, and 86% of the global evaporation
occurs from the oceans, reducing their temperature by evaporative cooling. Without the
cooling, the effect of evaporation on the greenhouse effect would lead to a much higher
surface temperature of 67 °C (153 °F) and a warmer planet.

On Earth, you can find water in all three states of matter: solid, liquid and gas. Liquid water is
found in Earth’s oceans, rivers, lakes, streams—and even in the soil and underground. Solid ice
is found in glaciers, snow, and at the North and South Poles. Water vapor—a gas—is found in
Earth’s atmosphere.

WATER CYCLE
Water is one of the fundamental natural resources on our planet Earth. Around 71% of the
earth’s surface is covered by water. Water cannot be created nor destroyed. The water on the
earth today is the same water that existed thousands of years ago and will continue to exist
years in the future. Water is constantly being recycled in a process known as the water cycle

FOUR MAIN STAGES OF WATER CYCLE

Evaporation
Evaporation is the initial stage of the water cycle.  Most of the earth’s water is held by the
world’s ocean and the rest of held by rivers, lakes and the south, and north pole informs of ice.
We are all aware that Sun is the main source of energy. When sunlight heats up the water and
some of the energies are transferred to those tiny water particles. Due to heating up, the water
particles are charged and move faster. They move into the air from the water body in form of
vapour. This process is known as Evaporation. In one word, Evaporation is the process by which
liquid water changes its state into vapour. Evaporation can also occur by transpiration in which
water evaporates through minute pores, or stomata, in the leaves of plants. Snow and ice can
actually turn into water vapor without first turning into water. This process is called
‘sublimation,’ and it results from low humidity and dry winds. This usually occurs at the peaks of
mountains or other high-up places, as the lower air pressure means that less energy is needed
to sublimate the ice into water vapor.

Condensation
Condensation is the second stage of the water cycle. When the evaporated water particles
along with warm air rise up from the earth’s surface, it loses its energy and cools down. After
that particles of water vapour collect small particles of dust which are floating in the air and get
closer to form water droplets. This is process is known as condensation. The formation of clouds
is an example of condensation.

Precipitation
After Condensation, water particles come together and this process continues.  When water
vapor collects sufficient water and forms large droplets. Due to gravity, large droplets fall back
to the earth, known as precipitation. Some examples of precipitation are rain, snow, hail and
sleet.

Deposition or collection
The deposition is the last stage of the water cycle. After precipitation, when evaporated water
droplets fall back on the earth’s surface in form of rain, snow etc.  It may deposit in various
water bodies, including lakes, rivers, oceans, ponds or in lands which turn into groundwater.