Department of Chemical & Biomolecular Engineering The National University of Singapore
Department of Chemical & Biomolecular Engineering The National University of Singapore
Department of Chemical & Biomolecular Engineering The National University of Singapore
Experiment F3
Name :
Matric No. :
Group :
Date of Expt. :
GRADE :
Equipment:
A set of three horizontal glass columns packed with spherical glass beads of different sizes.
Objectives:
Experimental:
• To determine the pressure drop and friction factor for fluid flowing through columns
packed with different sizes of glass beads.
• To study the relationship between friction factor and Reynolds number for flow through
packed bed.
1
Average Velocity ∝ Driving Pressure ∝
Bed Thickness
If the flow in the bed is laminar then due to viscous drag , superficial velocity (u) which is
nothing but the velocity through empty column is inversely proportional to the fluid viscosity
and can be represented as
∆P ∆P 1 dv Flowrate of liquid
u=K =B = =
L µ L A dt Cross − sec tional area of the column
where
K = Proportionality constant
∆P = Pressure drop
L = Length of the Bed
B = Permeability coefficient of the bed
A = Cross-sectional area of the bed
dv = Differential Volume
dt = Differential Time
By determining Bed Characteristics such as void fraction (ε), specific surface area (S), etc.
NR e and the friction factor φ can be estimated.
From the basic definition, Reynolds Number for flow through packed bed filled with
6
spherical particles (S= ) can be written as
dp
ρ u dp
NR e =
6 µ (1 − ε )
The resistance to the flow of a fluid through the bed of solids is the net result of the total drag
of all the particles in the bed. Depending on the NR e , friction factor, laminar /turbulent flow,
form drag and wake formation will occur. Hence, friction factor (φ) for the above system can
be obtained by equating total drag force to the total pressure force.
i.e. R’ S L (1-ε) = ε ∆ P
Where R’ is the drag force per unit area of particle surface. Therefore friction factor can be
obtained as
∆P dp ε3
φ Exptl = [ ]
L 6 (1 − ε ) ρ u 2
Ergun equation was developed attributing viscous drag force and inertial force to the total
pressure drop in the bed and can be written as
in the above equation for higher values of NR e viscous force becomes negligible and inertial
forces control.
According to Carman the co-relation for friction factor and Reynolds Number can be written
as
for laminar flow, when NR e ≤ 2, the second term of the Ergun and Carman equations
becomes negligible.
1. McCabe, W.L., J.C. Smith, and P. Harriott, “Unit Operations of Chemical Engineering”,
5th Edition, McGraw-Hill, Chapter 7 (1993).
2. Coulson, J.M., J.F. Richardson, J.R., Backhurst and J.H. Harkaer, “Chemical
Engineering” Vol. II, 3rd Edition, Pergamon Press, Chapter 4 (1978).
3. Perry, R. H., & Green, D. W. (2008). Perry's chemical engineers' handbook. New York:
McGraw-Hill.
5. Welty, J. R., Rorrer, G. L., & Foster, D. G. (2015). Fundamentals of momentum, heat and
mass transfer. Hoboken, NJ: John Wiley and Sons.