TECHNICAL

Fall arrest lanyard single SPECIFICATION

Fixed length fall arrest lanyard equiped with 1 standard connector on one end and one scaffold hook on HEIGHT SAFETY
the other end.

FAR0314

Polyamide rope
DISCLAIMER: Information presented within this technical specification was correct on date of issue. Information may be subject to change without notice as part of ongoing product improvement and development. To confirm any specific piece of

Scaffold hook

Shock absorber
Abrasion resistant thimble
FAR0902

METAL COMPONENTS Rope

Material: Alloy steel connectors. Material: Made from 12mm Polyamide 3-strand twisted rope.

Finish: Golden yellow galvanised. Diameter: 12 mm

Breaking strength: 25 kN

DIMENSIONS CHARACTERISTICS
Size: 1.8 meters Rope ends spliced and covered with polyethylene protective sleeve.
Abrasion resistant thimbles provided within loops.
Weight: 1055 g (+- 10 g)
On one end shock absorber and 1 screw gate connector. On the other
end 1 scaffold hook.
1 alloy steel scaffold hook. Gate opening 50 mm. Conforms to
CLEANING & MAINTENANCE EN362:2004 Class T.
1 screw gate connector in alloy steel. Gate opening 18 mm. Conforms to
Maintenance of this product must only be carried out by a trained and EN362:2004 class B & M.
competent person who will:
Connectors provided at both ends for attachment.
information shown is current please email technical@jspsafety.com.

Clean the product using the following procedure: using only warm water,
using only mild detergent, using only a sponge or soft nylon brush, using
fresh clean water to rinse the detergent off the product, drip dry the CONFORMITY
equipment allowing the product to thoroughly dry out before next use.
EN 355: 2002
Ensure that NO alterations to the product are made.
The lifespan of the product is 10 years from the date of manufacture sub-
Ensure that the following cleaning methods are NOT used: water over ject to passing necessary checks and inspection by a competent person.
40º C, bleach, any detergent not suitable for bare skin, wire brushes
or other scouring agents, jet wash or other power products, radiators Static strength: 15 kN for 3 Minutes.
or other direct heat sources, ensure that a thorough visual and tactile Dynamic strength: Maximum breaking force does not exceed 6kN in the
examination of the product is made after cleaning, before the item is line when tested on a free fall from 4 meters height attached to a test
allowed to be re-used. mass of 100 kgs.

MANUFACTURING FOR SAFETY UKSALES@JSP.CO.UK CUTOUT

WWW.JSPSAFETY.COM TEL: +44 (0)1993 826050

Issued 18/03/2019, V1