Awdc Series
Awdc Series
Awdc Series
x Use proper power source indicated in the rating label of the machine.
It may cause fire or electrical shock.
ELECTRIC
SHOCK
Failure to use a proper power source may result in the electrical outlet becoming excessively hot, leading to fire.
x Unplug the power cord from the electrical outlet before attempting to cleaning or maintenance the
washing machine.
UNPLUG POWER
x Do not allow water to come into direct contact with the various parts of the outer body.
DO NOT SPLASH
Doing so may result in electrical shock or short circuit.
WATER
x Wipe away off the dust or grime which attached to surface on pin of the plug.
REMOVE DUST
The dust or grime may cause fire.
x Do not place a fire source such as a candle or cigarette near the washing machine.
AVOID It may cause fire.
INFLAMMABLE
x Pull out the plug if you do not plan to use the machine for a long time.
Failure to do so may result in electrical shock or shorts due to deterioration of the insulation.
UNPLUG POWER
x Do not place the hands or other objects under the washing machine while in operation.
Moving parts may cause injury.
DANGER HAND
x Before use, make sure the faucet is open, and the connection with water inlet hose is not loose or
leakage water.
WATER LEAKAGE Looseness of hose nut, hose connections, water inlet valve or other areas may cause water leakage or other damage.
x The bottom ventilation of washing machine must not be obstructed by carpet when the washing
INSTALL
machine is installed on a carpet floor.
CAREFULLY
x During the spin extracting, if the spin basket does not stop rotation completely within 15 seconds after the lid
STOP is opened. Please stop operating the washing machine immediately and contact to service dealer for repairs.
OPERATED
1 Softener/Detergent case
Plug
Cassette Filter
Put the laundry in the basket and start the machine. The sensor will weigh clothes and begin flowing water.
If you start from rinsing without setting water level , it will be automatically set to the highest level.
The "SUPER SPIN DRY" can not be stored , Even if you execute memory course.
Filter cover
L How to remove L How to set in
Turn over the filter, and then slide the filter case in the arrow q Set the filter case to the filter cover as follows.
direction of the following figure (q) to remove it (w). w Press down the filter cover case until a “click” sound
Clean inside the filter cover and the filter case. is heard.
Filter case
Filter cover
Filter case Filter cover
L When the filter valve inside the filter cover
is loosened
If the filter valve is loosened, lint may not be collected.
q Set the filter valve to the filter case while aligning its
When it is difficult to remove the filter case due to lint concavity and convexity to those of the filter case.
attached, wet it with water to soften the lint.
Filter case Filter valve
Filter cover
Concavity Convexity
Groove
Click