TK110 Manual
TK110 Manual
Thank you very much for using GPS TRACKER. The user guide will explain in detail
how to operate this product. Please read it carefully before using it in order to
get the correct usage method. If the appearance, color and accessories of this
product are changed, please refer to the actual product. The manufacturer does not
assume legal responsibility for the faults and omissions in the user guide.
Note:
1. The terminal SIM card needs to activate the GPRS function;
2. The terminal needs the voice pickup function, and the SIM card needs
to activate the caller ID function; (According to the function required by the
customer, choose to enable or not to enable)
3. If your SIM card has been turned on and asked to enter the SIM PIN,
please refer to your mobile phone user manual to turn off the SIM PIN input function;
4. Please make sure that there is a charge for the terminal SIM card.
Steps for the correct use of the product: installation → startup → setting →
registration
Installation: When installing, make the GPS antenna face the sky, and the place
above the installation location must be covered by materials that do not absorb
electromagnetic waves (such as metal, explosion-proof insulation film).
Start up: Install the SIM card in the correct direction, connect the wire
according to the terminal wiring diagram, and then turn the power switch to turn
on.
Registering : a platform account: The registration method depends on the
dealer's platform, and the registration method is also different. Please consult
the dealer.
4. Commands
4.1、SMS instruction description and usage:
The user's SIM card number sends a short message instruction to the GPS
vehicle communication terminal SIM card number.
The comma in the following SMS command format is the English input state
format, and the letters are case-sensitive according to the command
requirements.
Common query functions SMS command format Reply
Admin No. 101#13712345678# OK
Status CXZT Version、ID、IP ect.
Google Link G1234 Google map link
Restart device CQ system reset OK!
Resstart GPS CQGPS GPS reset OK!
Back to factory settings FORMAT OK
Normall work mode NMOD,123456 OK
Saving power mode SMOD,123456 OK
Smart mode(minute) TMOD,123456,30 OK
APN apn123456 cmnet SET APN OK
APN user apnuser123456 user SET APNUSER OK