Professional Documents
Culture Documents
Accelerator Control System: Section
Accelerator Control System: Section
E
CONTENTS
PRECAUTION ............................................... 2 Removal and Installation .......................................... 3 F
Inspection ................................................................. 3
PRECAUTIONS ................................................... 2
Precaution for Supplemental Restraint System SERVICE DATA AND SPECIFICATIONS G
(SRS) "AIR BAG" and "SEAT BELT PRE-TEN- (SDS) ............................................................. 5
SIONER" ................................................................... 2
SERVICE DATA AND SPECIFICATIONS
REMOVAL AND INSTALLATION ................ 3 (SDS) .................................................................. 5 H
Accelerator Control ................................................... 5
ACCELERATOR PEDAL ASSEMBLY ............... 3
Exploded View .......................................................... 3 I
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along
with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain
types of collision. Information necessary to service the system safely is included in the SR and SB section of
this Service Manual.
WARNING:
• To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death in
the event of a collision which would result in air bag inflation, all maintenance must be performed by
an authorized NISSAN/INFINITI dealer.
• Improper maintenance, including incorrect removal and installation of the SRS, can lead to personal
injury caused by unintentional activation of the system. For removal of Spiral Cable and Air Bag
Module, see the SR section.
• Do not use electrical test equipment on any circuit related to the SRS unless instructed to in this
Service Manual. SRS wiring harnesses can be identified by yellow and/or orange harnesses or har-
ness connectors.
PRECAUTIONS WHEN USING POWER TOOLS (AIR OR ELECTRIC) AND HAMMERS
WARNING:
• When working near the Airbag Diagnosis Sensor Unit or other Airbag System sensors with the Igni-
tion ON or engine running, DO NOT use air or electric power tools or strike near the sensor(s) with a
hammer. Heavy vibration could activate the sensor(s) and deploy the air bag(s), possibly causing
serious injury.
• When using air or electric power tools or hammers, always switch the Ignition OFF, disconnect the
battery and wait at least three minutes before performing any service.
ALBIA0775GB J
K
Removal and Installation INFOID:0000000011149717
REMOVAL
L
1. Remove three accelerator pedal assembly nuts.
2. Disconnect harness connector (A) from the accelerator pedal
assembly (1). M
: Front
3. Remove the accelerator pedal assembly.
CAUTION:
N
• Do not disassemble accelerator pedal assembly.
• Do not drop or impact accelerator pedal assembly.
• Do not expose accelerator pedal assembly to water.
O
ALBIA0776GB
INSTALLATION P
Installation is in the reverse order of removal.
NOTE:
For inspection, refer to ACC-3, "Inspection".
Inspection INFOID:0000000011149718
ALBIA0798ZZ
ALBIA0798ZZ
E
Accelerator pedal stroke (A) 50.5 - 53.5 (1.99 - 2.11)
Accelerator pedal height 164.2 - 174.2 (6.46 - 6.86)
F
: Front