Sand and Water Culture Methods

Practical no 1: Sand and Water Culture Methods
There are four primary methods for cultivating plants without soil, each utilizing a nutrient
solution. These methods include water culture, sand culture, gravel culture, and the adsorbed-
nutrient technique.
1. Water Culture (Hydroponics)
The water culture method is known as hydroponics or solution culture. Today, all methods of
growing plants with nutrient solutions are known as "hydroponics" although technically the term
refers to water culture only.
In hydroponics, plants are grown with their roots partially submerged in a solution containing
nutrients for plant growth. The solution is contained in tanks, typically 6 to 8 inches deep, with
dimensions based on the location and convenience of use. Wooden, concrete, or metal
containers must be coated with inert materials to prevent damage from toxic substances.
Support for Plants:
 Plants are supported on wire, wooden, or metal structures to keep them upright.
 Wire mesh, hardware cloth, or other materials may be used, coated with asphalt emulsion
to prevent corrosion.
Bedding Material:
 Porous bedding materials like excelsior, peat moss, or shavings are placed over the
support to provide a surface for tubers, bulbs, or other plant parts to develop.
 The bedding material should be 3 to 4 inches thick, varying based on the type of plants.
Solution Level Management:
 Solution levels are critical, starting 1 inch below the bedding material for young plants
and dropping to 2 or 3 inches as they mature.
 Care should be taken to avoid waterlogging, which can lead to aeration issues and
undesirable bacterial decomposition.
Nutrient Solution:
 The nutrient solution should contain the necessary elements for plant growth.
Commercially available salts, chemically pure salts, or ready-made mixtures can be used
to prepare the solution. The salts should be used in recommended amounts to prevent
the damage to plants from an oversupply of salts in solution.
 Iron may be added separately to maintain normal plant growth. Various forms of iron
such as tartrate, citrate, sulfate, or chelate can be dissolved in water and added to the
solution.
 Maintaining pH between 5.0 and 6.5 is crucial for optimal nutrient availability. If the
reaction is alkaline, adjustments are made using d 0.1 N sulfuric acid (H2S04), phosphoric
acid (H3P04), or nitric acid (HNO3). Similarly, potassium hydroxide is used for acidic
conditions. A suitable test kit or pH meter is needed to test the pH after each addition to
the solution.
 Lack of oxygen is the most frequent cause of failure in water culture. The lack of oxygen
affects availability and uptake of nutrients by the plant. 4 to 8 parts per million of oxygen
in the solution is required to produce a vigorous, healthy root system. Generally, shallow-
open tanks with porous beds facilitate aeration of the roots. However, some plants
require air bubbling gently through the solution or circulation of the solution to increase
effective aeration of the roots. To supply the oxygen necessary for the plants, air may be
pumped through the solution with a pump, by use of compressed air, or with other
equipment. Air should be bubbled gently so as not to injure the roots. Bubbles 1/2 to 1
inch apart as they rise through the solution are satisfactory for this purpose.
Maintenance of Water Culture:
 The pH and nutrient levels should be monitored regularly, and adjustments made as
needed.
 Lack of oxygen is a common issue; therefore, aeration is essential for nutrient uptake by
plants.
 Draining and replacing the nutrient solution every one to two weeks is recommended to
ensure a constant supply of essential elements.
Sand Culture
Sand culture is sometimes referred to as slop culture, drip culture, or intermittent renewal. Plant
nutrients are supplied with solutions, as in water culture. The major difference is that the plants
are grown in silica sand or other inert material.
 The solution is applied to the sand and then allowed to drain off. In this way plant
nutrients are supplied, aeration is provided, and the roots of the plant are supported.
Additional support may be required for the aerial portions of the plant, especially
tomatoes and cucumbers.
 Sand should be medium to coarse in size (.2Smm-2mm). Finer material drains too slowly,
and proper aeration is difficult to obtain. Th sand should be free of lime (non-calcareous),
free of other harmful materials, and chemically inert.
 The nutrient solution should be added to the sand as needed for the plant's growth. This
may be done by allowing the solution to drip on the sand surface at a prescribed rate
although this method often results in poor aeration with its attendant problems. The
solution may be added once a week and the sand kept moist by adding water. This
prevents the danger of nutrient salts accumulating in the sand and consequently injuring
the plant. The solution may be added by sub-irrigating whereby the sand is flooded from
beneath and then allowed to drain out or by using a wick to allow the solution to move
into the sand by capillary action from a supply below.

Sand and Water Culture Methods

Uploaded by

Copyright:

Available Formats

Sand and Water Culture Methods

Uploaded by

Document Information

Original Title

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

Sand and Water Culture Methods

Uploaded by

Copyright:

Available Formats

Practical no 1: Sand and Water Culture Methods

You might also like